Concatenated Sequences for Spread Spectrum Systems

Concatenated sequences are suggested and developed for use in spread spectrum (SS) systems. Special receiver realization is discussed and it is shown that the concatenated sequences offer great advantage in reducing the size of the matched filter correlators (MFC) in the SS receiver. Experimental systems have been built using concatenated sequences and their performance is reported here. It has been shown that a processing gain of 60 is obtainable with a 15 × 4 concatenated sequence which requires three tapped delay lines (TDL), two of length 15 and one of 4. Thus a total of only 34 delay units (with a nonlinear interface network, only 19 delay units) are required. Teleprinter signals can be transmitted over telephone channels using a bandwidth (BW) expansion of 60 with an input signal-to-noise ratio (SNR) of only -5.1 dB, resulting in a character- error-rate of 1 in 103. Techniques have been developed to reduce the sidelobe levels in the aperiodic autocorrelation functions (ACF) of the pseudonoise (PN) codes. For 15 length and 7 length PN sequences, sidelobes are reduced by 9 dB and 9.4 dB, respectively, using transversal filters. Application of the SS systems to the problem of multiaccessing and antijamming are discussed.     

Range Sidelobe Suppression for Barker Codes

The utility of Barker-type phase-reversal codes is extended by the use of sidelobe suppression techniques that can be easily implemented in digital form. It is shown that sidelobe suppression techniques can be found where the tapped delay line used to reduce the sidelobes has only a few distinct tap weights, in which case the complexity of the digital processor is greatly reduced. An example is given where the technique is applied to Barker codes with positive sidelobes, specifically, the 13-element Barker code. If higher pulse compression factors are desired than are obtainable with Barker codes, multistage Barker codes may be used. The sidelobes then may be suppressed for any one or all of the different coding stages.     

Modified Barker and Huffman Sequences in Combination Codes

lt is possible that usable combination codes can be obtained if Barker and Huffman sequences are chosen as the inner and outer codes. lt is shown that an improvement in either energy efficiency or time sidelobe structure will result either from a modification of a Huffman sequence or from a modification of a Barker sequence. Results are given for a combination code of length 91, with inner and outer codes of length 7 and 13.     

Digital and Analog Subcomplementary Sequences for Pulse Compression

Golay's complementary pairing has been a method to increase the utility of binary sequences, because of the temporal sidelobe suppression in the autocorrelation vector summation. Complementary sets of Tseng and Liu and of Hollis exhibit the same effect when several autocorrelations are combined. These complementary pairs and sets of sequences can be extended into long complementary chains by a simple transformation. This transformation is extended here to all pulse compression waveforms. By this method, even though analog complementary sequences cannot be formed, a new class of waveforms, called subcomplementary waveforms, can be formed. Following these rules, repetition of waveforms such as linear frequency modulation (LFM) or linear stepped frequency modulation (LSFM) in a prescribed manner is possible without creating autocorrelation grating lobes or repetitive sidelobes. This method is equally applicable to all analog or digital pulse compression waveforms.     

Biphase Barker-Coded Data Transmission Recommended Techniques for CAS

The use of biphase modulation and Barker data coding within the 200-us range/Doppler transmission proposed for collision avoidance systems (CAS) is described. Following a general discussion of requirements for compatibility between important CAS threat-evaluation measurements and less essential message communications, emphasis is placed on consideration of the binary Barker pulse sequences and the recommended biphase modulation techniques for data transmission.     

Variable Format Radar Receiver Using a SAW Convolver

A technique for receiving radar pulse trains is presented [which can be of a variable format in the sense that they vary from pulse to pulse]. The heart of the receiver is a sufrace ascoustic wave (SAW) convolver. In addition to prsenting experimental results for variable format waveform reception, it is shown that the convolver can easily generate ambiguity functions for virtually any waveform, and specific results for signals such as Barker codes and linear FM (chirp) waveforms are presented.     

基于纠删码的遥测链路丢帧恢复技术

针对遥测系统在恶劣天气条件、航天器姿态调整、天线指向偏离、脉冲干扰等各种因素影响下出现的遥测信号闪断以至接收机丢帧问题,提出一种适用于闪断信道的纠删码技术,用于恢复丢失的数据帧.首先介绍LDPC（低密度奇偶校验）纠删码的编译码算法,然后构造一种以短码长的随机码为外码、IRA（不规则重复累积）LDPC码为内码的级联纠删码,最后给出纠删码的应用策略和实现纠删码所需的CCSDS（空间数据系统咨询委员会）协议扩展.通过仿真实验和分析,得到了LDPC纠删码和级联纠删码的纠删性能,得出级联纠删码与LDPC纠删码均可获得接近理想的纠删性能的结论,且级联纠删码的构造更为灵活,可适应不同的应用环境,对CCSDS协议进行适当扩展后即可支持纠删码在CCSDS遥测链路中的应用.     

Noncoherent Radar Pulse Compression Based on Complementary Sequences

Noncoherent pulse compression (NCPC), suggested recently, uses on-off keying (OOK) signals, obtained from Manchester coding a binary sequence with favorable a-periodic autocorrelation. This paper investigates the use of binary complementary pairs as a basis for NCPC. It shows that a pair of Manchester coded, N-element binary complementary sequences will yield a peak sidelobe (PSL) ratio of 1/(2N).     

Improving performance in pulse radar detection using neuralnetworks

A new approach using a multilayered feed forward neural network for pulse compression is presented. The 13 element Barker code was used as the signal code. In training this network, the extended Kalman filtering (EKF)-based learning algorithm which has faster convergence speed than the conventional backpropagation (BP) algorithm was used. This approach has yielded output peak signal to sidelobe ratios which are much superior to those obtained with the BP algorithm. Further, for use of this neural network for real time processing, parallel implementation of the EKF-based learning algorithm is indispensable. Therefore, parallel implementation has also been developed     

Reduction of sidelobe self-interference in an agile beam radar

In an agile beam phased array radar, the beam is often multiplexed over several angular positions, and “listens” in each position only over an instrumented range that may be a fraction of the unambiguous range as determined by the pulse repetition period in each position. After transmitting a pulse in a given direction, the beam is switched, essentially instantaneously, to another position, after the instrumented range delay. In this second position, echoes from the first position, from multiple trips of the instrumented range, enter the one-way angular sidelobes of the first position. This interference is compounded if there are several beam positions in a pulse repetition period. The author proposes a method of phase coding the pulses in such a way that the pulse-to-pulse phase variation in each direction is orthogonal to every other phase code in the other directions. The codes are Walsh functions. These are sets of binary valued (+1 or -1) functions such that all of the functions in the set are mutually orthogonal. Not every possible number N of pulses in each direction and number K of beam positions can be accommodated, but a large variety of such combinations can be accommodated. Several examples are given. The combination of low one-way sidelobes and orthogonality (or near orthogonality) of the phase codes should provide for very stringent sidelobe self interference rejection     

Sequence design for IIR inverse filter pulse compression

An infinite impulse response (IIR) inverse filter structure is presented, and compared with the performance of two finite impulse response (FIR) designs. The IIR design is shown to provide better performance and be able to improve further (e.g., -1.4 dB in sidelobe levels per unit delay increase for the length-13 Barker sequence) by increasing delay. The performance parameters of this IIR inverse filter suggest a design criterion for sequences on which the filter operates; that is related to the roots of the Z transform polynomial of the sequence. The sidelobe-optimal sequence derived according to this criterion is shown to provide sharper sidelobe reduction (-6 dB per unit delay increase for the sidelobe optimal length-13 sequence)     

Further studies on efficient AFEC schemes for Ka-bandsatellite systems

Adaptive fade margin is required to counter the severe but varying rain attenuation in Ka satellite communications. In searching for a suitable rain countermeasure, the effectiveness of the adaptive forward error control (AFEC) scheme is studied. Two AFEC schemes using convolutional codes and concatenated codes are proposed and their performance analyzed. The schemes can provide a progressively adaptive fade margin of 10.1 and 10.4 dB, respectively, in excess of the systems fixed fade margin. To improve the efficient use of shared resources of the system, an AFEC scheme using double coding is introduced, and its performance is analyzed. In this scheme a single codec is used repeatedly, and as a result the hardware cost is reduced and the utilization increased. The effective usable capacity of a conceptual AFEC resource sharing scheme using Golay double coding is also analyzed     

Efficient exhaustive search for optimal-peak-sidelobe binary codes

The work presented here describes an exhaustive search for minimum peak sidelobe level (PSL) binary codes, combining several devices for efficiency. These include combinatoric tree search techniques, the use of PSL-preserving symmetries to reduce search space, data representations and operations for fast sidelobe computation, and a partitioning scheme for parallelism. All balanced 64-bit minimum PSL codes are presented, and the upper limit on known consecutive lengths to have PSL = 4 codes is extended to 70. In addition, a technique for determining balance properties of a code for given PSL-preserving transformations is developed.     

Some Results on Digital Chirp

Generating chirp waveforms by means of phase coding yields a simple, cost-effective mechanization. The coding process, however, introduces phase errors whose effect must be included in the design. An approximate analysis is presented, valid for moderate to high compression ratios, which allows error effects on compressed pulse amplitude and sidelobes to be calculated in a simple manner. The anaylsis provides criteria for selecting the coding bit width (sample rate), weighting network bandwidth, and phase-coder quantization interval and transition times. Weighting functions for maximizing the signal-to-noise ratio (SNR) or for producing desired close-in sidelobe performance are derived, as is an exact expression for the transmitted spectrum. Numerical results are presented for Gaussian and the maximum-SNR weighting. The results indicate that performance will be satisfactory for many applications.     

A New Class of Polyphase Pulse Compression Codes and Techniques

A new class of symmetric radar pulse compression polyphase codes is introduced which is compatible with digital signal processing. These codes share many of the useful properties of the Frank polyphase code. In contrast with the Frank code, the new codes are not subject to mainlobe to sidelobe ratio degradation caused by bandlimiting prior to sampling and digital pulse compression. It is shown that bandlimiting the new codes prior to pulse compression acts as a waveform amplitude weighting which has the effect of increasing the mainlobe to sidelobe ratios.     

Transmit Beamforming for MIMO Radar Systems using Signal Cross-Correlation

Proposed next-generation radar systems will have multiple transmit apertures with complete flexibility in the choice of the signals transmitted at each aperture. Here we propose the use of multiple signals with arbitrary cross-correlation matrix R, and show that R can be chosen to achieve or approximate a desired spatial transmit beampattern. Two specific problems are addressed. The first is the constrained optimization problem of finding the value of R which causes the true transmit beampattern to be close in some sense to a desired beampattern. This is approached using convex optimization techniques. The second is the problem of designing multiple constant-modulus waveforms with given cross-correlation R. The use of coded binary phase shift keyed (BPSK) waveforms is considered. A method for finding the code sequences based on random signaling with a structured correlation matrix is proposed. It is also shown that by restricting the class of admissible waveforms one reduces the set of possible signal correlation matrices.     

A Logarithmic Frequency Allocation Algorithm for Wideband Discrete Frequency Pulse Trains

It is shown that signal waveforms utilizing discrete frequency modulation (DFM) which are generated using a narrowband or frequency shift algorithm have ambiguity sidelobe distortion which is caused by the approximation of time compression by frequency shift. A logarithmic frequency allocation algorithm is presented which couches the signal design problem in terms of band and step ratios, rather than in terms of bandwidth and frequency steps, and is consistent with the wideband formulation of the ambiguity function. The algorithm makes use of the same basic code generating sequence used for narrowband frequency allocation, but the resulting signal will have invariant ambiguity sidelobe positions for any receiver realization in the delay-time compression plane.     

Biphase Sequence Generation with Low Sidelobe Autocorrelation Function

Since Barker-like sequences could not be found for sequence lengths greater than 13, radar system designers have been searching for biphase sequences with discrimination (ratio of the magnitude of the mainlobe to the magnitude of the peak sidelobe of the autocorrelation function of the sequence) greater than 13. We present new results on biphase Legendre sequences for all prime lengths. The results of the paper are as follows. 1) Two lemmas on the symmetric properties of the Legendre sequences are stated and using these lemmas and simple rules of modulo arithmetic, a method is suggested for generating long sequences which does not require multiplications and divisions. 2) From the properties of autocorrelation function of the cyclically shifted Legendre sequence (LS) for prime lengths, a computationally efficient method is evolved for carrying out systematic search for sequences with discrimination greater than 13. The proposed method reduces the computational load by a factor of approximately 16. Using these techniques, we generated codes up to length 1019. In each case we searched for the code which gives the maximum discrimination for that length.     

Optimal planning for a multi-debris active removal mission with a partial debris capture strategy

In this paper, a new mission model, called a multi-debris active removal mission with partial debris capture strategy, is proposed. The model assumes that a platform only captures part of the scheduled debris at a time and then releases these debris pieces to a disposal orbit. This process is then repeated until all of the scheduled debris is removed. A genetic algorithm with a multiparameter concatenated coding method is designed to optimize the plan of a multi-debris active removal mission wit...     

GF（q）域上的低密度校验（LDPC）码的译码及其在深空通信中的应用

低密度校验码是一类能有效逼近香农限的好码,而高进制的LDPC码具有比二进制LDPC码更好的性能,但其译码复杂度太高不利于工程应用。本文提出了一种基于协同优化算法的低复杂度的高进制LDPC码的译码算法,并讨论了其在深空通信中的应用。