Effect of bristle pack position on the rotordynamic characteristics of brush-labyrinth seals at various operating conditions

Over the last few decades, the research on the effect of bristle pack position on the rotordynamic characteristics of the brush-labyrinth seals is not sufficient. To this end, two kinds of brush-labyrinth seals for the bristle pack element installed upstream of the labyrinth teeth named BSU and installed downstream of the labyrinth teeth called BSD were used to investigate the effect of bristle pack position on the rotordynamic characteristics of the brush-labyrinth seals. Using the numerical model combining the porous medium model and the whirling rotor method, the rotordynamic characteristics of the BSU and BSD at various operating conditions including four kinds of pressure ratios, five kinds of inlet preswirl speeds and four kinds of rotor spinning speeds were conducted. The obtained results show that the effects of operating conditions on rotordynamic coefficients for the different seal configurations are different. The direct stiffness, cross-coupled stiffness and direct damping of the BSU are lower than those of the BSD. The rotordynamic coefficients of the BSU are more insensitive to the operating conditions variation. From the perspective of the seal stability, the BSU is a better brush-labyrinth seal configuration at high pressure ratio, high positive preswirl or high rotor spinning speed conditions. While in the case of low pressure ratio, low positive preswirl or low rotor spinning speed conditions, the BSD is a better choice.     

偏心撞击对撞击式喷嘴雾化特性的影响

为研究偏心撞击对撞击式喷嘴雾化特性的影响,建立了求解自燃推进剂冷态射流撞击雾化过程的数值模拟方案,计算了不同偏心度条件下的射流撞击雾化过程。采用树形自适应加密算法直接求解不可压Navier-Stokes方程组,由分段线性的流体体积(VOF)方法对流体界面进行捕捉。结果表明偏心撞击会导致雾场发生偏转,当无量纲偏心度E为1/8时,雾场偏转角度约为9.2°,应控制加工偏差小于该值。随着偏心度的增大,液膜的偏转角度增大,理论推导得到的液膜偏转角度要小于数值计算得到的液膜偏转角度。正心撞击时燃料与氧化剂流强峰值接近,雾场的流强分布呈单峰分布。当发生偏心撞击时,由于燃料与氧化剂部分射流未参与撞击导致流强峰值出现交错,雾场的流强分布呈双峰分布,混合比的空间分布发生较大改变。正心撞击时撞击点下游液滴的速度分布近似呈轴对称分布,而偏心撞击之后的速度分布则呈中心对称分布。偏心撞击导致的射流动量损失使得雾化性能变差,当无量纲偏心度E为1/8时,一甲基肼(MMH)的Sauter平均直径增大约4.8%,四氧化二氮(NTO)的Sauter平均直径增大约5.8%。      

亚超剪切混合层燃油雾化特性试验研究

为了摸清亚超大梯度剪切混合层内直射式喷嘴的燃油雾化特性，设计了用于向亚超剪切混合流中进行燃油喷射的直射式喷嘴，建立了亚超剪切混合层中燃油雾化试验系统。利用粒子图像测速系统（PIV），对亚超大梯度混合层中油雾场进行测量。通过改变喷嘴流量、喷射角度和喷嘴数量研究不同参数对雾化特性的影响，并应用图像处理技术对亚超大梯度剪切混合层内的油雾场进行分析，总结归纳其雾化规律。试验结果显示：随着流量增大，穿透深度会随之增大，破碎后的颗粒分布峰值所对应的液滴直径会逐渐变小，雾化效果提升；相同流量条件下，喷嘴的角度改变对雾化效果有影响，顺喷和逆喷的雾化效果均好于垂直喷射；逆喷的喷射高度最高，随着流量的增长，燃料将会碰壁；顺喷条件下，随着角度的增加，穿透长度会有所增加；综合燃油轨迹边界，逆喷的效果相对较好。相同流量条件下，喷孔个数的改变对雾化效果和穿透深度的影响不大。     

PBT弹性体微相分离及对其力学性能的影响研究

为了获得微相分离对宽温PBT叠氮聚醚弹性体力学性能的影响规律,用红外光谱分析法(FT-IR)和动态热力学分析法(DMA)研究了PBT叠氮聚醚弹性体产生微相分离的机理和影响因素。用调节硬段含量、交联参数的方法调控其微相分离,控制适当的微相分离程度可显著改善推进剂的力学性能。研究结果表明:在二元醇扩链的弹性体体系中,当硬段含量约为15%时,弹性体发生相对最大比例的微相分离,体现出较佳的综合力学性能。通过微相分离的调控可获得宽温范围内综合力学性能较好的叠氮聚醚推进剂用粘合剂基体材料。     

任意波发生器静态特性的评价

介绍了任意波发生器的主要静态特性指标、校准方法及实现过程。通过一组实验．获得了实际校准结果，并对校准中需要注意的问题进行了讨论。所述方法涉及的静态特性内容比较全面。具有足够的测量准确度、分辨力和稳定性。可用于任意波发生器的静态指标评价和计量。     

Obscured Activity: AGN, Quasars, Starbursts and ULIGs Observed by the Infrared Space Observatory

Some of the most ‘active’ galaxies in the Universe are obscured by large quantities of dust and emit a substantial fraction of their bolometric luminosity in the infrared. Observations of these infrared luminous galaxies with the Infrared Space Observatory (ISO) have provided a relatively unabsorbed view to the sources fuelling this active emission. The improved sensitivity, spatial resolution and spectroscopic capability of ISO over its predecessor Infrared Astronomical Satellite (IRAS) of enabled significant advances in the understanding of the infrared properties of active galaxies. ISO surveyed a wide range of active galaxies which, in the context of this review, includes those powered by intense bursts of star formation as well as those containing a dominant active galactic nucleus (AGN). Mid-infrared imaging resolved for the first time the dust enshrouded nuclei in many nearby galaxies, while a new era in infrared spectroscopy was opened by probing a wealth of atomic, ionic and molecular lines as well as broad band features in the mid- and far-infrared. This was particularly useful, since it resulted in the understanding of the power production, excitation and fuelling mechanisms in the nuclei of active galaxies including the intriguing but so far elusive ultraluminous infrared galaxies. Detailed studies of various classes of AGN and quasars greatly improved our understanding of the unification scenario. Far-infrared imaging and photometry revealed the presence of a new very cold dust component in galaxies and furthered our knowledge of the far-infrared properties of faint starbursts, ULIGs and quasars. We summarise almost nine years of key results based on ISO data spanning the full range of luminosity and type of active galaxies.     

扩压器-水泵内非稳定流动研究

水泵内部流动实质上是复杂的三维非稳定流动 ,它对水泵性能及结构振动有重要影响。本文介绍了一种求解这种复杂内流动的数值方法。三维雷诺数平均的纳维斯托克斯方程 ( 3-DReynolds-averaged Navier-Stokes,RANS)以及标准 k-ε的方程用于描述水泵内非定常紊流流场。系统特性方程与水泵的 CFD模型相结合以考虑流体在管道中的加速 ;采用任意滑移网格界面模拟叶轮和静止部件之间的相互干涉 ;将整个叶轮作为分析对象 ,以考虑失速情况下流动的周向非对称。这些技术的结合包括了水泵内非稳定流动的物理实质。一台实验数据比较齐全的离心式 -扩压器水泵被用于验证所提出的数值方法     

弹道靶红外辐射测量

为深入认识再入物理现象 ,在弹道靶上做了模型头部和近尾流红外辐射测量。发射器为 1 4.5mm口径的二级轻气炮 ,模型为1 0mm的球 ,材料为聚碳酸酯和铝 ,模型发射速度 4～6km/s,使用红外InSb探测器测量波长 3～ 5 .4μm的红外辐射 ,靶室压力 5 .32kPa。实验中使用光电法测量模型速度 ,两站阴影照相进行模型姿态监测和速度核实。实验结果表明 :球模型的红外辐射强度强烈依赖于模型材料和模型飞行速度。对不同材料模型头部和尾流部辐射强度的定性比较说明由于低温材料烧蚀产物的存在 ,极大地增强了头部和近尾流区的辐射强度 ,而且延长了尾流辐射长度     

桥式测量转换电路特性与实验教学结合的探索与实践

桥式测量转换电路是众多传感器测量转换电路中非常重要的一种转换电路,其特性的理解和掌握对理解其在多种电路中的应用起着至关重要的作用。通过应变片电阻传感器实验教学可实现对桥式测量转换电路特性的掌握。     

Cd1-xZnxS体系红外光谱及发射率特性

制备了Cd1-xZnxS三元系半导体材料。利用X射线衍射(XRD)对其结构进行了表征,结果表明实验所得样品均为纤锌矿结构。建立了Cd1-xZnxS混晶替位模型,根据所建模型和晶格振动理论,对Cd1-xZnxS红外光谱特性进行探讨。研究了Cd1-xZnxS三元系半导体材料红外发射率特性,Cd1-xZnxS在3~5μm波段的发射率远远低于8~14μm波段的发射率,这与材料的红外吸收机制和光谱特性有关;Cd1-xZnxS半导体材料的红外发射率随着烧结温度的提高而降低,这是由于温度升高,晶格畸变减小并逐渐趋近于完整晶格。