自制等离子喷枪冷却系统的设计及测试

等离子喷枪是制备热障涂层中的研究重点。目前关于等离子喷枪的研究多集中于喷嘴(阳极)、阴极,鲜有关于喷枪冷却系统方面的研究;喷枪冷却系统的优劣直接影响喷枪的工作寿命和喷涂过程的稳定性,同时制备热障涂层的质量也与冷却效果紧密相关。本文利用三维模型,详细阐述了自制的喷枪冷却系统通道及工作原理,并对设计进行了理论计算,对自制的喷枪进行点火试验和喷涂测试,结果显示自制的喷枪冷却系统功能良好,喷枪工作稳定,涂层质量较好。     

基于新型丝状电极等离子体激励器的前体涡控制

本文首次将新型丝状暴露电极DBD等离子激励器应用于大迎角下细长体非对称涡控制。丝状暴露电极的材料的选择对DBD推力以及推力效率至关重要,通过地面精细推力测量对丝状暴露电极等离子体激励器进行了优化,结果表明,本文研究材料中采用钨丝作为暴露电极,其推力效率最优;且随着电极直径从d=0.3 mm减小到d=0.08 mm,DBD推力效率显著提升。基于优化后的DBD激励器,将其应用于前体非对称涡控制:未施加等离子体控制时,压力测量以及PIV结果均表明细长体背风区流场为明显的非对称涡结构;在等离子体激励下,该非对称涡结构可变为对称甚至反向非对称,且非稳态激励控制能力明显优于稳态激励。研究发现,大迎角下细长体非对称涡控制与背风区原始涡系结构有关,其中包含对称涡系和非对称涡系。本文研究为大迎角下细长体非对称涡控制提供了一种新思路,同时也为丝状暴露电极DBD等离子体激励器的应用提供参考。     

某型航空活塞发动机曲轴喷油螺钉的维修工艺研究

喷油螺钉是某型航空活塞式发动机曲轴组合中的重要零件，单纯采用超声波清洗难以清除该零件内部积炭。结合生产实践对工艺进行改良，使该零件修理后的抽检合格率由20%提升至70%，缩短了发动机的翻修时间，节约了维修成本。     

Application of small-size antennas for estimation of angles of arrival of HF signals scattered by ionospheric irregularities

A modification of the Doppler Interferometry Technique is suggested to enable estimating angles of arrival of comparatively broadband HF signals scattered by random irregularities of the ionospheric plasma with the use of small-size weakly directional antennas. The technique is based on the measurements of cross-spectra phases of the probe radiation recorded at least in three spatially separated points. The developed algorithm has been used to investigate the angular and frequency-time characteristics of HF signals propagating at frequencies above the maximum usable one (MUF) for the direct radio path Moscow-Kharkiv. The received signal spectra show presence of three families of spatial components attributed, respectively, to scattering by plasma irregularities near the middle point of the radio path, ground backscatter signals and scattering of the sounding signals by the intense plasma turbulence associated with auroral activations. It has been shown that the regions responsible for the formation of the third family components are located well inside the auroral oval. The drift velocity and direction of the auroral ionosphere plasma have been determined. The obtained estimates are consistent with the classical conception of the ionospheric plasma convection at high latitudes and do not contradict the results of investigations of the auroral ionosphere dynamics using the SuperDARN network.     

Spectroscopy peculiarities of thermal plasma of electric arc discharge between electrodes with Zn admixtures

Plasma of the free burning electric arc between Ag–SnO₂–ZnO composite electrodes as well as brass electrodes were investigated. The plasma temperature distributions were obtained by Boltzmann plot method involving Cu I, Ag I or Zn I spectral line emissions. The electron density distributions were obtained from the width and from absolute intensity of spectral lines. The laser absorption spectroscopy was used for measurement of copper atom concentration in plasma. Plasma equilibrium composition was calculated using two independent groups of experimental values (temperature and copper atom concentration, temperature and electron density). It was found that plasma of the free burning electric arc between brass electrodes is in local thermodynamical equilibrium. The experimental verification of the spectroscopic data of Zn I spectral lines was carried out.     

基于ALE法的水陆两栖飞机船体着水性能分析

水陆两栖飞机的着水性能是体现其综合性能的重要因素之一.应用ALE法对三种水陆两栖飞机船体截面进行入水仿真计算,从着水载荷、喷溅性能及运动响应三个方面对着水性能进行综合评估.对比分析了直线型、带舭弯弧形、复合型三种构型截面在不同速度、不同重量下的压力分布、喷溅性能以及运动响应,得到了三种截面横向压力分布规律.计算结果显示相同状态下,喷溅性能复合型优于带舭弯弧形、带舭弯弧形优于直线型;过载复合型远大于带舭弯弧形,带舭弯弧形稍大于直线型,综合看来带舭弯弧形截面着水性能最佳.     

吸热型碳氢燃料RP-3替代模型研究

利用广义对应态法则对吸热型碳氢燃料RP-3的5种替代模型的密度、黏度、导热系数和比定压热容进行了数值计算.计算温度变化范围为300~800K,压力变化范围为3~6MPa.结果表明:不同替代模型均能定性重现RP-3在拟临界温度附近的物性急剧变化;由53%正十一烷,18%正丁基环己烷,29%1,3,5-三甲基苯组成的3组分替代模型在预测RP-3物性上表现最优,相对于实验数据,300~700K内密度相对误差均小于0.08;替代模型的相对分子质量越大,预测的拟临界温度越高,对拟临界温度下物性值的影响无显著规律.      

无沸腾区机载喷雾冷却实验关联式研究

主要开展4种不同结构热沉表面无沸腾区机载喷雾冷却实验关联式的研究.在总结前人工作经验并搭建实验台完成实验的基础上,提出了影响喷雾冷却性能的4个无量纲参数,且通过实验数据处理得到各个热沉表面的努塞尔数无量纲关联式.给出的光滑热沉表面实验关联式的预测值与实验值偏差在±8.5%以内,并分析了各个量纲对实验关联式精度的影响.对于钻孔表面,引入传热强化系数对关联式进行修正,使得关联式的预测值能够落在偏差±15%内.另外单独给出了槽道热沉表面的实验关联式,该关联式不受槽道结构及数量的影响,且适用于水、盐类及醇类溶液.      

正十七烷与正十八烷对航空煤油理化性能及液滴平均直径的影响

讨论了正十七烷与正十八烷(C₁₇,C₁₈)对燃料运动黏度、密度、表面张力理化性能的影响,探究了直链烷烃对SMD(Sauter mean diameter)的影响.将Key's混合规律、Tat混合规律和多项式拟合应用于密度公式的拟合,并将Key's混合规律与对数拟合应用于运动黏度公式的拟合,得出的理化性能拟合公式精度较高;通过测量纯煤油及C₁₇,C₁₈混合油雾化的SMD,实验发现随着直链烷烃的质量分数的增加,混合油的运动黏度增加,SMD也随之增加,雾化效果与纯航空煤油的相比较差,而C₁₈混合油的SMD要比C₁₇混合油要大,并且利用密度、运动黏度的拟合公式对SMD进行预测的偏差小于0.3%.      

毫秒脉冲等离子体激励改善飞翼的气动性能实验

在来流速度为30m/s时,进行了毫秒脉冲介质阻挡放电等离子体激励改善飞翼气动性能的风洞实验.等离子体激励器布置在飞翼前缘,峰峰值电压为9.5kV时,放电的脉冲能量在0.1mJ/cm量级.通过六分量测力天平测力研究了脉冲激励频率和占空比对升/阻力系数、升阻比和俯仰力矩系数的作用效果.结果表明:等离子体激励可以有效改善飞翼大攻角气动特性;在最佳无量纲脉冲激励频率F+≈1时,临界失速迎角由14°提高到17°,最大升力系数提高10%;占空比对流动控制效果影响较大,减小占空比可以降低能耗,实验中最佳占空比为5%;俯仰力矩系数的变化表明施加等离子体激励改善了飞翼纵向静稳定性.