From Titan’s tholins to Titan’s aerosols: Isotopic study and chemical evolution at Titan’s surface

In the present work, we focused on the possible isotopic fractionation of carbon during the processes involved in the formation of Titan’s tholins. We present the first results obtained on the ¹²C/¹³C isotopic ratios measured on Titan’s tholins synthesized in laboratory with cold plasma discharges. Measurements of isotopic ratio ¹²C/¹³C, done both on tholins and on the initial gas mixture (N₂:CH₄ (98:2)) used to produce them, do not show any evident deficit or enrichment in ¹³C relatively to ¹²C in the synthesized tholins, compared to the initial gas mixture. This observation allows to go further in the analyses of the ACP experiment data, including part of the Cassini–Huygens mission.     

Process of establishing design requirements and selecting alternative configurations for conceptual design of a VLA

In this study, a process for establishing design requirements and selecting alternative con-figurations for the conceptual phase of aircraft design has been proposed. The proposed process uses system-engineering-based requirement-analysis techniques such as objective tree, analytic hier-archy process, and quality function deployment to establish logical and quantitative standards. Moreover, in order to perform a logical selection of alternative aircraft configurations, it uses advanced decision-making methods such as morphological matrix and technique for order prefer-ence by similarity to the ideal solution. In addition, a preliminary sizing tool has been developed to check the feasibility of the established performance requirements and to evaluate the flight perfor-mance of the selected configurations. The present process has been applied for a two-seater very light aircraft (VLA), resulting in a set of tentative design requirements and two families of VLA configurations: a high-wing configuration and a low-wing configuration. The resulting set of design requirements consists of three categories: customer requirements, certification requirements, and performance requirements. The performance requirements include two mission requirements for the flight range and the endurance by reflecting the customer requirements. The flight performances of the two configuration families were evaluated using the sizing tool developed and the low-wing configuration with conventional tails was selected as the best baseline configuration for the VLA.     

Optical fiber wavelength division multiplexing

During flight, aircraft avionics transmit and receive RF signals to/from antennas over coaxial cables. As the density and complexity of onboard avionics increases, the electromagnetic interference (EMI) environment degrades proportionately, leading to decreasing signal-to-noise ratios (SNRs) and potential safety concerns. The coaxial cables are inherently lossy, limiting the RF signal bandwidth while adding considerable weight. To overcome these limitations, we have investigated a fiber optic communications link for aircraft that utilizes wavelength division multiplexing (WDM) to support the simultaneous transmission of multiple signals (including RF) over a single optical fiber. Optical fiber has many advantages over coaxial cable, particularly lower loss, greater bandwidth, and immunity to EMI. In this paper, we demonstrate that WDM can be successfully used to transmit multiple RF signals over a single optical fiber with no appreciable signal degradation. We investigate the transmission of FM and AM analog modulated signals, as well as FSK digital modulated signals, over a fiber optic link (FOL) employing WDM. We present measurements of power loss, delay, SNR, carrier-to-noise ratio (CNR), total harmonic distortion (THD), and bit error rate (BER). Our experimental results indicate that WDM is a fiber optic technology suitable for avionics applications.     

Dosimetric investigations on Mars-96 mission.

The dosimetric experiments Dose-M and Liulin as part of the more complex French-German-Bulgarian-Russian experiments for the investigation of the radiation environment for Mars-96 mission are described. The experiments will be realized with dosemeter-radiometer instruments, measuring absorbed dose in semiconductor detectors and the particle flux. Two detectors will be mounted on board the Mars-96 orbiter. Another detector will be on the guiderope of the Mars-96 Aerostate station. The scientific aims of Dose-M and Liulin experiments are: Analysis of the absorbed dose and the flux on the path and around Mars behind different shielding. Study of the shielding characteristics of the Martian atmosphere from galactic and solar cosmic rays including solar proton events. Together with the French gamma-spectrometer and the German neutron detectors the investigation of the radiation environment on the surface of Mars and in the atmosphere up to 4000 m altitude will be conducted.     

A cost effective critical space systems design approach

NASA-ISC requires avionics platforms capable of serving a wide range of applications in a cost-effective manner. In part, making the avionics platform cost effective means adhering to open standards and supporting the integration of COTS products with custom products. Inherently, operation in space requires low power, mass, and volume while retaining high performance, reconfigurability, scalability, and upgradability. The Universal Mini-Controller (UMC) project is based on a modified PC/104-Plus architecture while maintaining full compatibility with standard COTS PC/104 products. The architecture consists of a library of stackable building block modules, which can be mixed and matched to meet a specific application. A set of NASA developed core building blocks, (e.g. processor card, analog input/output card, high level analog card, and a Mil-Std-1553 card) were constructed to meet critical functions and unique interfaces     

Some practical strategies for reducing intermodulation in satellitecommunications

Various heuristic procedures for obtaining practical solutions to the general one-level carrier frequency assignment problem are described. The problem treated is general in the sense that it accommodates the case where L of the N slots may be explicitly designated as prohibited and unavailable for assignment. This problem occurs in satellite transmission with many small carriers accessing the same transponder where, due to multipath and TV interference from crosspolarized transponders of the same satellite and from copolarized transponders of the adjacent satellites, some portions of the bandwidth of the considered transponder cannot be used. To permit comparison with respect to the intermodulation advantage and central-processing-unit time required, the case without prohibited slots is considered. The sequential insertion procedure in which, starting with two carriers at the two end slots, one additional carrier at a time is optimally inserted into one of the unassigned slots is found best when the ratio between the available bandwidth and the total carrier bandwidth is greater than about 125%. All the heuristic procedures produced assignments whose intermodulation advantages are all greater than the bandwidth ratio     

Time variations of the total electron content in the Southeast Asian equatorial ionization anomaly for the period 2006–2011

This study presents the time variations of the total electron content in the South East Asian equatorial ionization anomaly. The time variation of the TEC is analyzed through the period 2006–2011 by using a latitudinal chain of GPS stations extending in the northern and southern hemisphere. The data shows that the shape of the diurnal variation of the TEC depends on the latitude: a plateau is observed at the stations near the equator and a Gaussian at the station distant from the equator. We observe a semiannual pattern in all the stations with maxima at equinox. In both hemispheres, the amplitude of the crest is larger in spring than autumn from 2006 to 2008 and smaller in spring than in autumn from 2009 to 2011. We also observe an asymmetry between the amplitude and the position of the two crests of ionization. There is a very high level of correlation between the amplitude of the TEC at the two crests and the sunspot number: ∼0.88. During the deep solar minimum 2008–2009, the amplitude of crests of ionization becomes small during several months in summer and winter. The results show that both crests move significantly equatorward in winter than other seasons and there is a tendency for both crests to appear earlier in winter and later in summer.     

Medium resolution near-infrared spectra of the host galaxies of nearby quasars

We present medium resolution near-infrared host galaxy spectra of low redshift quasars, PG 0844+349$0844+349$ (z = 0.064), PG 1226+023$1226+023$ (z = 0.158), and PG 1426+015$1426+015$ (z = 0.086). The observations were done by using the Infrared Camera and Spectrograph (IRCS) at the Subaru 8.2 m telescope. The full width at half maximum of the point spread function was about 0.3 arcsec by operations of an adaptive optics system, which can effectively resolve the quasar spectra from the host galaxy spectra. We spent up to several hours per target and developed data reduction methods to reduce the systematic noises of the telluric emissions and absorptions. From the obtained spectra, we identified absorption features of Mg I (1.503 μm), Si I (1.589 μm) and CO (6-3) (1.619 μm), and measured the velocity dispersions of PG 0844+349$0844+349$ to be 132 ± 110 km s⁻¹ and PG 1426+015$1426+015$ to be 264 ± 215 km s⁻¹. By using an _MBH–σ$M_{\text{BH}}''–''\sigma$ relation of elliptical galaxies, we derived the black hole (BH) mass of PG 0844+349$0844+349$, log(_MBH/_M⊙)=7.7±5.5$\log (M_{\text{BH}}/M_{\odot })=7.7\pm 5.5$ and PG 1426+015,log(_MBH/_M⊙)=9.0±7.5$1426+015\text{,}\log (M_{\text{BH}}/M_{\odot })=9.0\pm 7.5$. These values are consistent with the BH mass values from broad emission lines with an assumption of a virial factor of 5.5.     

Shock tube study of boundary layer instability

An experimental study of the spatio-temporal evolution of the transition in a shock-tube wall boundary-layer has been carried out with thin film heat transfer gauges placed all along the tube. The results show that the transition appears, for small initial pressures, under the form of turbulent spots which are periodically created: these spots grow and are transported roughly at a velocity slightly smaller than the inviscid flow, regressing towards the contact surface. For higher initial pressures, a continuous transitional front is created which moves at about the same velocity as the shock-wave. These results seem to explain previous and often contradictory interpretations based on quasi-punctual measurements but the fact remains that the characterization criteria of the transition in unsteady boundary layers are still to be studied.     

The Low-Energy Telescope (LET) and SEP Central Electronics for the STEREO Mission

The Low-Energy Telescope (LET) is one of four sensors that make up the Solar Energetic Particle (SEP) instrument of the IMPACT investigation for NASA’s STEREO mission. The LET is designed to measure the elemental composition, energy spectra, angular distributions, and arrival times of H to Ni ions over the energy range from ～3 to ～30 MeV/nucleon. It will also identify the rare isotope ³He and trans-iron nuclei with 30≤Z≤83. The SEP measurements from the two STEREO spacecraft will be combined with data from ACE and other 1-AU spacecraft to provide multipoint investigations of the energetic particles that result from interplanetary shocks driven by coronal mass ejections (CMEs) and from solar flare events. The multipoint in situ observations of SEPs and solar-wind plasma will complement STEREO images of CMEs in order to investigate their role in space weather. Each LET instrument includes a sensor system made up of an array of 14 solid-state detectors composed of 54 segments that are individually analyzed by custom Pulse Height Analysis System Integrated Circuits (PHASICs). The signals from four PHASIC chips in each LET are used by a Minimal Instruction Set Computer (MISC) to provide onboard particle identification of a dozen species in ～12 energy intervals at event rates of ～1,000 events/sec. An additional control unit, called SEP Central, gathers data from the four SEP sensors, controls the SEP bias supply, and manages the interfaces to the sensors and the SEP interface to the Instrument Data Processing Unit (IDPU). This article outlines the scientific objectives that LET will address, describes the design and operation of LET and the SEP Central electronics, and discusses the data products that will result.