MTI Loss with Coherent Integration of Weighted Pulses

A moving target indicator (MTI) preceding a coherent integrator causes a degradation in the signal-to-noise ratio (SNR). This negative effect can be reduced by weighting of the MTI output pulses before the integration process. Two examples are given which show the improvement in SNR and detection probability as a result of this weighting.     

Bandpass Signal Sampling and Coherent Detection

Coherent detectors in radar and communications receivers are generally implemented in the form of two parallel baseband channels which form in-phase (I) and quadrature (Q) components of a received RF/IF signal. Phase errors of several degrees due to imperfect matching of these separate channels limit the performance achievable from signal processors such as moving target indicators (MTI), coherent integrators, Doppler filters, antenna array processors, and coherent sidelobe cancellers. Thus methods in which a single analog to digital (A/D) converter samples and digitizes the IF signal directly, eliminating the need for IF to baseband conversion, have been of recent interest and are the subject of this paper. To obtain accurate coherent detection from IF samples taken near the Nyquist rate requires interpolation based upon a number of stored samples. An algorithm derived from sampling theory is defined and used to demonstrate accurate reconstruction of the original IF signal from digitized samples. In-phase and quadrature components of the signal are shown to be available from processed samples with demonstrated phase errors less than 0.2°.     

CTD MTI Radar Filter with Charge-Transfer Inefficiency Compensation

The design and implementation of a second-order nonrecursive moving target indication (MTI) radar filter using commercially available charge-transfer devices as delay lines are described. A simple technique is included to compensate for the device charge-transfer in-efficiency and its sensitivity is analyzed. Experimental laboratory tests and results in an operating radar system are reported showing the good performance of the realized MTI radar filter.     

Closed-Form Expressions for Noncoherent Radar Integration Gain and Collapsing Loss

Closed-form formulas allow rapid determination of noncoherent integration gain and integration loss when the single-sample IF signal-to-noise ratio (SNR) is known. In addition, if the required SNR is known for any number of integrated pulses, the required SNR for any other number is easily determined. A closed-form expression is given for radar collapsing loss, expressed in terms of the equivalent integrated signal-to-noise ratio required to produce a given combination of false-alarm and detection probabilities. Alternatively, the single-sample signal-to-noise ratio of a set of samples may be used together with the closed-form expression for integration gain to get the equivalent integrated signal-to-noise ratio.     

Interference Due to Limiting and Demodulation of Two Angle Modulated Signals

Two angle modulated signals (FM or PM) passing through a limiter and then a demodulator are analyzed. The analysis considers the problem of adjacent carrier interference, direct adjacent channel interference (DACI) or cross talk, and adjacent channel interference (ACI). The analysis of adjacent carrier interference shows that if the 3rd order IM is not to overlap the signal spectra, the carrier frequencies must be separated by 2B where B is the bandwidth of each carrier. The ACI analysis shows that the carrier frequencies must be separated by B+2?m for no ACI, since the demodulator reduces the bandwidth of the 3rd order IM from 3B to 2B+2?m where ?m is the maximum frequency of each baseband. The DACI analysis shows that DACI does not exist in a PM system and is -52 dB for an ideal hard limiter with no bandpass filter. But the DACI is -58 dB for an ideal hard limiter with a more realistic bandpass filter.     

The Susceptivity of MTI Systems to White Noise

The performance of various coherent MTI systems in the presence of white noise is investigated. The single-pulse signal-to-noise ratios at the output of the filters are presented for the case of large system bandwidth. Generalized results, calculated as a function of the system's bandwidth, are given. Finally, those results are compared to the optimum signal-to-noise acheivable by a matched filter.     

MTI Optimization in a Multiple-Clutter Environment

A means of optimizing a moving target indicator (MTI) filter for rejecting several types of clutter, which are generated by different mechanisms such as by rain or the ground, is formulated. lt is found that the optimal performance of such a filter depends on the spectral density functions, average radar cross sections, and the relative mean Doppler frequencies of each type of clutter. lt is shown that the optimal improvement factor of such a filter is bounded by the weighted average (weighted in accordance with the radar cross sections of the clutter types) of the improvement factor for the individual clutter type. lt is also shown that the improvement factor of such a filter is a function of the relative mean Doppler frequency f0 between the clutter types. As f0 increases, the performance of the MTI system degrades. The worst improvement factor occurs when f0 is equal to half of the radar pulse-repetition frequency (PRF).     

Signal Resolution via Digital Inverse Filtering

Research in numerous areas is directed toward the resolution of multiple overlapping signals in a noisy environment. These areas include radar, sonar, speech, seismology, and electrophysiology. Sometimes matched filters are used; other times inverse filters are employed. This paper discusses one approach to the analysis of the resolution of inverse filters. Our method is to compromise the trade-off between signal resolution and the output signal-to-noise ratio (SNR). A performance measure for the inverse or deconvolution filter is defined as a quantity proportional to the harmonic mean of the resolution and the SNR. An optimum output pulse duration is obtained using this criterion, where the pulse shape has been previously selected and the input signal waveform is known. In addition, upper and lower bounds for the output pulse duration are presented. Graphs are given which allow the designer to select the optimum inverse filter output pulse duration for a desired signal resolution and an estimated SNR.     

On the Optimization of MTI Clutter Rejection

In this paper is formulated the problem of optimization of the improvement factor of a nonrecursive MTI by minimization of a quadratic form. The minimum normalized clutter output (a reciprocal of the average improvement factor) is the minimum eigenvalue of this quadratic form, and the corresponding eigenvector is the optimal weight to be used in this filter. By use of classic matrix theory, some properties of this MTI improvement factor are shown, namely, that it is bounded and is a monotonic function of the clutter spectrum variance. Also discussed is the limit of an MTI system having a large number of cancellers. Finally, the problem of a staggered-PRF MTI filter is examined, for which it is shown that its improvement factor is bounded by two equivalent constant-PRF MTI systems. One of these systems has a PRF equal to the lowest PRF of the staggered-PRF system, while the other has a PRF equal to the highest PRF of the staggered system.     

带通限幅器对锁相环噪声性能的影响

锁相环路中,在鉴相器前加上AGC（自动增益控制）,可以使环路性能在输入信噪比发生变化时保持稳定,带通限幅器也可以起到类似作用。尽管有一些文章对限幅器的性能作了研究,但是在PLL（锁相环）闭环条件下,鲜有文章分析其对环路噪声性能的影响。因此,文章以基本PLL环路的数学模型为基础,推导出PLL中分别加入相干AGC和带通限幅器后新的环路数学模型,以一阶PLL为例,计算和比较不同控制方式下环路相位误差均方值的变化,最后说明应当根据飞行任务的不同选择对环路更有利的控制方式。     

Properties of Staggered PRF Radar Spectral Components

Expressions for moving target indicator (MTI) improvement factor limitation due to pulse repetition frequency (PRF) staggering and loss of target detectability for various values of Doppler frequency in the passband are presented. It is also shown that the product of variance of stagger periods and clutter variance is an important parameter determining the performance of a staggered PRF MTI radar.     

Constrained Improvement MTI Radar Processors

A new class of staggered PRF MTI radar processors is developed in this paper. These processors are constrained to achieve a specified value of MTI improvement and, subject to this constraint, minimize variations in processor response as a function of target Doppler frequency. The selection of both filter weights and PRF stagger sequences is discussed and a number of representative designs are presented.     

Design of MTI Radar on the Basis of Detection Probability

A single (quadrature) channel moving target indicator (MTI) radar system employing a tapped delay line filter is analyzed. The point of view taken is that of optimal clutter rejection in conjunction with subsequent receiver decision operations. The random nature of the spread of target Doppler shifts is taken into account. Based on the above, a procedure is presented by means of which the detection probability can be numerically evaluated for an optimized filter frequency response.     

Probablity of Detection for ICW Radars

Eclipsing of received signals is analyzed for Interrupted Continuous Wave (ICW) radars. A probability density for the Signal to Noise Ratio (SNR) at the Doppler filter output is derived which incorporates eclipsing effects and a fluctuating target cross section model. The probability of detection as a function of SNR is calculated for typical ICW parameters and the magnitude of the detection loss due to eclipsing is assessed     

Development of airborne moving target radar for long range surveillance

The following topics are discussed in the context of the development of an airborne moving target radar for long range surveillance: US Navy long range shipborne radar; Cadillac I airborne early warning (AEW) radar; Cadillac II airborne early warning (AEW) radar; airborne moving target indicating (AMTI) radar; related post-war radar activities; and the invention of the displaced center antenna. Among the topics studied is the use of a monopulse antenna in an MTI radar to remove the degradation of the MTI caused by rapid scanning of the antenna. A method of using a monopulse antenna for motion compensation in airborne MTI is discussed.<>     

New Clutter Rejection Waveforms for Long-Range Radar

A frequent compromise in the design of long-range search radars has to be made between the maximum unambiguous detection range and the achievable coherent clutter rejection performance. A new class of waveforms is introduced which offers the designer a previously unavailable flexibility in arriving at radar designs with improved clutter rejection without seriously affecting the maximum unambiguous search range. The key to these new waveforms is the recognition that a class of useful N-pulse, nonrecursive, moving target indicator (MTI) canceler designs exists which only requires the radar to transmit a total of N -1 (nonuniformly spaced) pulses.     

Performance of Digital Implementations of an Adaptive Processor

The performance of a digital implementation of an Applebaum-Howells type adaptive processor is analyzed for both a limiter and nonlimiter configuration. The performance is evaluated in terms of steady-state residue power, using either a single-pole filter or a perfect integrator to smooth the output of the correlation mixer. The latter filter is the more commonly used for digital implementations. It is shown that when using the perfect integrator filter for both the limiter and linear digital implementations, the steady-state average weight vector equals the optimum weight vector. Thus, for this filter, the steady-state residue power is the minimum possible for either implementation. When using the single-pole filter, neither implementation achieves the minimum possible steady-state residue power. The relative performance of the two implementations depends upon the relative gain settings. When the gains are adjusted to give comparable servo stability for the design maximum jammer power, a reasonable criterion for digital implementations because of analog to digital saturation, the limiter configuration always has smaller steady-state residue power.     

On Increasing Usable MTI Filter Bandwidth by Removing Linear-Phase Constraint

It has been shown in the literature that the linear-phase constraint of finite-duration impulse-response (FIR) digital filters can, under certain circumstances, be effectively traded either for a better filter amplitude response or a reduction in the number of filter coeficients. It is shown that such a tradeoff can be exploited for moving target indicator (MTI) radar signal processors to increase the usable bandwidth for target detection. Although it is demonstrated that the increase is significant for narrowband (ground) clutter, it is negligible for wideband (weather) clutter.     

Quantization Noise in Digital Moving Target Indication Systems

This paper deals precisely with the effect of quantum or step size in an analog-to-digital converter on the quantization noise in the output of MTI (moving target indication) radar processors. The correlation between quantization errors on successive pulses is considered in the analysis and is shown to have a small quieting effect on the output quantization noise.     

Clutter suppression using recursive and nonrecursive MTI filters

The author calculates the effectiveness of clutter suppression of a moving-target-indicator (MTI) filter in tandem with a fast-Fourier-transform (FFT) Doppler filter bank, taking into account the transient response of the MTI filter. Both recursive and nonrecursive filters are considered. The analysis is extended to the high-pulse-repetition-frequency (PRF) case with clutter fold over. The results can be used to select key design parameters, including the MTI filter, the window size, and the initial transient segment to be discarded. Numerical examples are included