Effect of bristle pack position on the rotordynamic characteristics of brush-labyrinth seals at various operating conditions

Over the last few decades, the research on the effect of bristle pack position on the rotordynamic characteristics of the brush-labyrinth seals is not sufficient. To this end, two kinds of brush-labyrinth seals for the bristle pack element installed upstream of the labyrinth teeth named BSU and installed downstream of the labyrinth teeth called BSD were used to investigate the effect of bristle pack position on the rotordynamic characteristics of the brush-labyrinth seals. Using the numerical model combining the porous medium model and the whirling rotor method, the rotordynamic characteristics of the BSU and BSD at various operating conditions including four kinds of pressure ratios, five kinds of inlet preswirl speeds and four kinds of rotor spinning speeds were conducted. The obtained results show that the effects of operating conditions on rotordynamic coefficients for the different seal configurations are different. The direct stiffness, cross-coupled stiffness and direct damping of the BSU are lower than those of the BSD. The rotordynamic coefficients of the BSU are more insensitive to the operating conditions variation. From the perspective of the seal stability, the BSU is a better brush-labyrinth seal configuration at high pressure ratio, high positive preswirl or high rotor spinning speed conditions. While in the case of low pressure ratio, low positive preswirl or low rotor spinning speed conditions, the BSD is a better choice.     

A survey of safety separation management and collision avoidance approaches of civil UAS operating in integration national airspace system

Recent years have witnessed a booming of the industry of civil Unmanned Aircraft System (UAS). As an emerging industry, the UAS industry has been attracting great attention from governments of all countries and the aviation industry. UAS are highly digitalized, informationized, and intelligent; therefore, their integration into the national airspace system has become an important trend in the development of civil aviation. However, the complexity of UAS operation poses great challenges to the traditional aviation regulatory system and technical means. How to prevent collisions between UASs and between UAS and manned aircraft to achieve safe and efficient operation in the integrated operating airspace has become a common challenge for industry and academia around the world. In recent years, the international community has carried out a great amount of work and experiments in the air traffic management of UAS and some of the key technologies. This paper attempts to make a review of the UAS separation management and key technologies in collision avoidance in the integrated airspace, mainly focusing on the current situation of UAS Traffic Management (UTM), safety separation standards, detection system, collision risk prediction, collision avoidance, safety risk assessment, etc., as well as an analysis of the bottlenecks that the current researches encountered and their development trends, so as to provide some insights and references for further research in this regard. Finally, this paper makes a further summary of some of the research highlights and challenges.     

偏心撞击对撞击式喷嘴雾化特性的影响

为研究偏心撞击对撞击式喷嘴雾化特性的影响,建立了求解自燃推进剂冷态射流撞击雾化过程的数值模拟方案,计算了不同偏心度条件下的射流撞击雾化过程。采用树形自适应加密算法直接求解不可压Navier-Stokes方程组,由分段线性的流体体积(VOF)方法对流体界面进行捕捉。结果表明偏心撞击会导致雾场发生偏转,当无量纲偏心度E为1/8时,雾场偏转角度约为9.2°,应控制加工偏差小于该值。随着偏心度的增大,液膜的偏转角度增大,理论推导得到的液膜偏转角度要小于数值计算得到的液膜偏转角度。正心撞击时燃料与氧化剂流强峰值接近,雾场的流强分布呈单峰分布。当发生偏心撞击时,由于燃料与氧化剂部分射流未参与撞击导致流强峰值出现交错,雾场的流强分布呈双峰分布,混合比的空间分布发生较大改变。正心撞击时撞击点下游液滴的速度分布近似呈轴对称分布,而偏心撞击之后的速度分布则呈中心对称分布。偏心撞击导致的射流动量损失使得雾化性能变差,当无量纲偏心度E为1/8时,一甲基肼(MMH)的Sauter平均直径增大约4.8%,四氧化二氮(NTO)的Sauter平均直径增大约5.8%。      

亚超剪切混合层燃油雾化特性试验研究

为了摸清亚超大梯度剪切混合层内直射式喷嘴的燃油雾化特性，设计了用于向亚超剪切混合流中进行燃油喷射的直射式喷嘴，建立了亚超剪切混合层中燃油雾化试验系统。利用粒子图像测速系统（PIV），对亚超大梯度混合层中油雾场进行测量。通过改变喷嘴流量、喷射角度和喷嘴数量研究不同参数对雾化特性的影响，并应用图像处理技术对亚超大梯度剪切混合层内的油雾场进行分析，总结归纳其雾化规律。试验结果显示：随着流量增大，穿透深度会随之增大，破碎后的颗粒分布峰值所对应的液滴直径会逐渐变小，雾化效果提升；相同流量条件下，喷嘴的角度改变对雾化效果有影响，顺喷和逆喷的雾化效果均好于垂直喷射；逆喷的喷射高度最高，随着流量的增长，燃料将会碰壁；顺喷条件下，随着角度的增加，穿透长度会有所增加；综合燃油轨迹边界，逆喷的效果相对较好。相同流量条件下，喷孔个数的改变对雾化效果和穿透深度的影响不大。     

An innovative approach for integrated airline network and aircraft family optimization

The determination of optimal aerial transport networks and their associated flight frequencies is crucial for the strategic planning of airlines, as well as for carrying out market research, to establish target markets, and for aircraft and crew rostering. In addition, optimum airplane types for the selected networks are crucial to improve revenue and to provide reduced operating costs. The present study proposes an innovative approach to determine the optimal aerial transport network simultaneously with the determination of the optimum fleet for that network, composed of three types of airplanes (network and vehicle integrated design). The network profit is maximized. The passenger’s demands between the airports are determined via a gravitational model. An embedded linear programming solution is responsible for obtaining potential optimal network configurations. The optimum fleet combination is determined from a database of candidate aircraft designs via genetic algorithm. A truly realistic airplane representation is made possible thanks to accurate surrogate models for engine and aerodynamics is adopted. An accurate engine deck encompassing a compression map and an innovative engine weight calculation besides an aerodynamical artificial neural network module enable a high degree of accuracy for the mission analysis. The proposed methodology is applied to obtain the optimum network comprised of twenty main Brazilian airports and corresponding fleet.     

任意波发生器静态特性的评价

介绍了任意波发生器的主要静态特性指标、校准方法及实现过程。通过一组实验．获得了实际校准结果，并对校准中需要注意的问题进行了讨论。所述方法涉及的静态特性内容比较全面。具有足够的测量准确度、分辨力和稳定性。可用于任意波发生器的静态指标评价和计量。     

风挡串流对测力数据的影响及其改进措施

本文研究了风挡串流对三角形机翼飞机模型测力数据的影响。试验结果指出,在风挡具有串流的情况下,正反装模型所获得的纵向测力数据都是错误的,特別是俯仰力矩。为了消除风挡串流对测力数据的影响,应尽力限制串流量,此外建议在测定模型的平均气流偏角和支架干扰量时,上风挡亦带串流,并使其对称于下风挡的串流。经试验证明,这些措施将有助于获得较为可靠的正反装测力数据。     

中心极限定理用于近似计算时必须注意的问题

本文着重指出,在运用中心极限定理近似计算独立同泊松分布随机变量之和的概率时,通常只注意了取n适当大的值,从而导致了差异较大的不同结果。本文指出了不仅要使n适当的大,而且也要使nλ足够地大。当X_h是其他离散型随机变量时,也要考虑类似的问题。     

扩压器-水泵内非稳定流动研究

水泵内部流动实质上是复杂的三维非稳定流动 ,它对水泵性能及结构振动有重要影响。本文介绍了一种求解这种复杂内流动的数值方法。三维雷诺数平均的纳维斯托克斯方程 ( 3-DReynolds-averaged Navier-Stokes,RANS)以及标准 k-ε的方程用于描述水泵内非定常紊流流场。系统特性方程与水泵的 CFD模型相结合以考虑流体在管道中的加速 ;采用任意滑移网格界面模拟叶轮和静止部件之间的相互干涉 ;将整个叶轮作为分析对象 ,以考虑失速情况下流动的周向非对称。这些技术的结合包括了水泵内非稳定流动的物理实质。一台实验数据比较齐全的离心式 -扩压器水泵被用于验证所提出的数值方法     

桥式测量转换电路特性与实验教学结合的探索与实践

桥式测量转换电路是众多传感器测量转换电路中非常重要的一种转换电路,其特性的理解和掌握对理解其在多种电路中的应用起着至关重要的作用。通过应变片电阻传感器实验教学可实现对桥式测量转换电路特性的掌握。