三旋流器加装外套环对燃烧性能的影响

对带有两种不同头部结构（基准型为方案1,头部加装外套环为方案2）的三旋流单头部燃烧室进行了研究,对有两种头部结构的燃烧室进行了流场和燃烧场的数值模拟,在相同的进口试验条件下,用燃气分析法和15点测温耙分别测量了两种头部的燃烧效率、出口冒烟数和出口温度场.结果表明:三旋流器的燃烧效率超过了99.7%,加装外套环后其流场、温度场分布均较基准型有所改善,回流区更加饱满,油气混合和燃油雾化效果增强,出口温度分布系数（OTDF）和出口冒烟数分别降低了36%和25%.      

导风轮叶片偏置对高压比串列离心压气机性能的影响

为提升高压比串列离心压气机的性能,借鉴常规一体化离心叶轮中偏置分流叶片的方法,针对某高压比串列离心压气机,应用数值仿真手段分析了串列叶轮中导风轮叶片周向偏置对压气机流场和性能的影响。通过对不同导风轮叶片偏置方案下压气机流场的分析,建立了压气机流动损失与偏置参数的关联性。研究表明:采用较大的偏置参数γ可降低导风轮叶片1前缘的激波强度,改善激波作用导致的泄漏涡破碎和流动分离,但过大或过小的γ方案中导风轮叶顶会出现二次泄漏致使低能流体的掺混损失增加;γ=65%方案压气机综合性能最佳,其压比和效率较γ=50%分别提高了1.5%和1.4%;对于串列离心压气机导风轮叶片周向位置的优化,在避免导风轮叶顶形成较强二次泄漏的前提下,应考虑采用较大的偏置参数γ,同时应防止诱导轮尾迹流体参与导风轮的叶顶泄漏。     

三旋流燃烧室喷嘴雾化性能试验研究

为了获得三旋流燃烧室喷嘴雾化性能与喷嘴几何尺寸的相互关系,针对供油压力以及旋流槽长宽比和旋流槽角度等关 键结构参数对燃油流量、喷雾锥角和雾化性能的影响进行了试验研究。采用3 维相位多普勒粒子分析仪测量了某一直线上各点的 索太尔平均直径和数密度分布,以及Rosin-Rammler 分布的特征直径和均匀度指数。结果表明：当供油压力提高时,燃油流量和喷 雾锥角增大;旋流槽几何尺寸的变化对燃油流量和喷雾锥角有不同的影响,当旋流槽长宽比和旋流槽角度增大时,燃油流量减小, 喷雾锥角增大。研究所获得的规律为三旋流高温升燃烧室的喷嘴优化设计提供了重要的理论依据。     

风车状态下转子性能及通道内流动分析

为探究低展弦比压气机转子在风车状态下由压气机模式向涡轮模式转化过程中性能、内部流场结构以及气动损失的演化过程,提出了一种基于叶片和流体间能量传递的简化数值计算方法,以获得某转速下的风车状态临界流量点。在数值模拟的基础上,重点对比了同一转速线上压气机工况点(小流量工况)、风车临界点和涡轮工况点下叶尖泄漏损失的演化机制,同时探究了叶片通道内流动分离的演化过程。 结果显示,随着转速的增加,转子风车状态临界流量呈现近似线性的变化趋势。而同转速下随流量增大,叶尖泄漏流从吸力面流向压力面,并与压力面上的低能量流体进行掺混,造成了流动堵塞。同时,从压气机模式转向涡轮模式的过程中,叶尖区域的流动分离从吸力面分离转变为压力面分离,随后分离强度和尺寸逐渐增大,造成的气动损失显著增加;而在轮毂区域,流动分离始终保持吸力面分离,其分离尺度沿径向有所发展。     

Time-dependent cosmic ray modulation

Time-dependent cosmic ray modulation is calculated over multiple solar cycles using our well established two-dimensional time-dependent modulation model. Results are compared to Voyager 1, Ulysses and IMP cosmic ray observations to establish compatibility. A time-dependence in the diffusion and drift coefficients, implicitly contained in recent expressions derived by , ,  and , is incorporated into the cosmic ray modulation model. This results in calculations which are compatible with spacecraft observations on a global scale over consecutive solar cycles. This approach compares well to the successful compound approach of Ferreira and Potgieter (2004). For both these approaches the magnetic field magnitude, variance of the field and current sheet tilt angle values observed at Earth are transported time-dependently into the outer heliosphere. However, when results are compared to observations for extreme solar maximum, the computed step-like modulation is not as pronounced as observed. This indicates that some additional merging of these structures into more pronounced modulation barriers along the way is needed.     

Modeling of ionospheric scintillation at low-latitude

The presence and movement of plasma density fluctuations in the F-region of the ionosphere are studied by monitoring phase and amplitude of radio waves propagating through the region. In this paper, we have used weak scattering theory and assumed the plasma density fluctuations to behave like phase changing diffraction screen. Appropriate relations for scintillation index S₄, and phase variance δ? are derived and computed for different parameters of the plasma density irregularities of the ionosphere. SROSS-C2 satellite in situ measurements of plasma density fluctuations, which provide direct information about the structure and morphology of irregularities that are responsible for scintillation of radio waves, were used first time to develop a scintillation model for low latitude. It is observed that the scintillation index S₄ and phase variance δ? depends on the strength of the plasma turbulence. Finally, the results obtained from modeling are compared and discussed with the available recent results.     

Median filtering algorithms for multichannel detectors

Particle detectors of worldwide networks are continuously measuring various secondary particle fluxes incident on Earth surface. At the Aragats Space Environmental Center (ASEC), the data of 12 cosmic ray particle detectors with a total of ∼280 measuring channels (count rates of electrons, muons and neutrons channels) are sent each minute via wireless bridges to a MySQL database. These time series are used for the different tasks of off-line physical analysis and for online forewarning services. Usually long time series contain several types of errors (gaps due to failures of high or low voltage power supply, spurious spikes due to radio interferences, abrupt changes of mean values of several channels or/and slowly trends in mean values due to aging of electronics components, etc.). To avoid erroneous physical inference and false alarms of alerting systems we introduce offline and online filters to “purify” multiple time-series. In the presented paper we classify possible mistakes in time series and introduce median filtering algorithms for online and off-line “purification” of multiple time-series.     

Science operations planning expertise: A neglected component of mission design

In this paper, Science Operations Planning Expertise (SOPE) is defined as the expertise that is held by people who have the two following qualities. First they have both theoretical and practical experience in operations planning, in general, and in space science operations planning in particular. Second, they can be used, on request and at least, to provide with advice the teams that design and implement science operations systems in order to optimise the performance and productivity of the mission. However, the relevance and use of such SOPE early on during the Mission Design Phase (MDP) is not sufficiently recognised. As a result, science operations planning is often neglected or poorly assessed during the mission definition phases. This can result in mission architectures that are not optimum in terms of cost and scientific returns, particularly for missions that require a significant amount of science operations planning. Consequently, science operations planning difficulties and cost underestimations are often realised only when it is too late to design and implement the most appropriate solutions. In addition, higher costs can potentially reduce both the number of new missions and the chances of existing ones to be extended. Moreover, the quality, and subsequently efficiency, of SOPE can vary greatly. This is why we also believe that the best possible type of SOPE requires a structure similar to the ones of existing bodies of expertise dedicated to the data processing such as the International Planetary Data Alliance (IPDA), the Space Physics Archive Search and Extract (SPASE) or the Planetary Data System (PDS). Indeed, this is the only way of efficiently identifying science operations planning issues and their solutions as well as of keeping track of them in order to apply them to new missions. Therefore, this paper advocates for the need to allocate resources in order to both optimise the use of SOPE early on during the MDP and to perform, at least, a feasibility study of such a more structured SOPE.     

Evolution of periodic orbits near the Lagrangian point L2

A study of the evolution of the periodic and the quasi-periodic orbits near the Lagrangian point L₂, which is located to the right of the smaller primary on the line joining the primaries and whose distance from the more massive primary is greater than the distance between the primaries, in the framework of restricted three-body problem for the Sun–Jupiter, Earth–Moon (relatively large mass ratio) and Saturn–Titan (relatively small mass ratio) systems is made. Two families of periodic orbits around the smaller primary are identified using the Poincaré surface of section method – family I (initially elliptical, gradually becomes egg-shaped with the increase in the Jacobi constant C and elongated towards the more massive primary) and family II (initially egg-shaped orbits elongated towards L₂ and gradually becomes elliptical with the increase in C). The family I in the Sun–Jupiter and Saturn–Titan systems contains two separatrix caused by third-order and fourth-order resonances, while the Earth–Moon system has only one separatrix which is caused by third-order resonances. Also in the Sun–Jupiter and the Saturn–Titan systems, family I merge with family II, around Jacobian constant 3.0393 and 3.0163, respectively, while in the Earth–Moon system, family II evolves separately from two different branches. The two branches merge at C = 3.184515. In the Earth–Moon system, the family II contains a separatrix due to third-order resonances which is absent in the other two systems.     

Optimal target grasping of a flexible space manipulator for a class of objectives

Space graspers are complex systems, composed by robotic arms placed on an orbiting platform. In order to fulfil the manoeuvres’ requirements, it is necessary to properly model all the forces acting on the space robot. A fully nonlinear model is used to describe the dynamics, based on a multibody approach. The model includes the orbital motion, the gravity gradient, the aerodynamic effects, as well as the flexibility of the links. The present paper aims to design, thanks to nonlinear optimization algorithms, a class of manoeuvres that, given the same target to be grasped, are characterized by different mission objectives. The grasping mission can be performed with the objective to minimize the power consumption. Collision avoidance constraints can be also added when the target is equipped with solar panels or other appendices. In some cases, large elastic displacements should be expected, possibly leading to an inaccurate positioning of the end-effector. Therefore, different design strategies can require that the manoeuvre is accomplished with minimum vibrations’ amplitude at the end-effector. Performance of the different strategies is analyzed in terms of control effort, trajectory errors, and flexible response of the manipulator.