螺旋桨飞机起飞构型突风影响研究

对于小迎角纵向静不稳定飞机,突风给飞机带来显著的安全隐患,为此,结合飞行品质规范中的突风模型,给出不同概率和不同高度下的突风速度。针对某螺旋桨飞机,计算分析垂直向上和向下突风所引起的飞机迎角变化,获得了起飞状态下可行的飞行速度和高度范围。研究结果表明,垂直向下突风显著地削弱了该类飞机的纵向静稳定性;垂直向上突风显著地减小了其安全迎角裕度。     

Early analysis of precise orbit and clock offset determination for the satellites of the global BeiDou-3 system

Eight new-generation BeiDou satellites (BeiDou-3) have been launched into Medium Earth Orbit (MEO), allowing for global coverage since March 2018, and they are equipped with new hydrogen atomic clocks and updated rubidium clocks. Firstly, we analyzed the signals for the carrier-to-noise-density ratio (C/N0) and pseudorange multipath (MP) by using international GNSS (Global Navigation Satellite System) Monitoring and Assessment System (iGMAS) station data, and found that B1C has a lower C/N0, and B2a has the same level of C/N0 as the B1I and B3I signals. For pseudorange multipath, compared with the BeiDou-2 satellites, the obvious systematic variation of MP scatters related to the elevation angle is greatly improved for the BeiDou-3 and BeiDou-3e satellites signals. For the signals of the BeiDou-3 satellites, the order of the Root Mean Square (RMS) values of multipath and noise is B3I?<?B1I?<?B2a?<?B1C. Then, the comparison of the precise orbit determination and clock offset determination for the BeiDou-2, BeiDou-3, and BeiDou-3 experimental (BeiDou-3e) satellites was done by using 10 stations from iGMAS. The 3D precision of the 24?h orbit overlap is 24.55, 25.61, and 23.35?cm for the BeiDou-3, BeiDou-3e, and BeiDou-2 satellites, respectively. BeiDou-3 satellite has a comparable precision to that of the BeiDou-2 satellite. For the precision of clock offset estimation, the Standard Deviation (STD) of the BeiDou-3 MEO satellite is 0.350?ns, which is an improvement of 0.042?ns over that of the BeiDou-2 MEO satellite. The stabilities of the BeiDou-3 and BeiDou-3e onboard clocks are better than those of BeiDou-2 by factors of 2.84 and 1.61 at an averaging time of 1000 and 10,000?s, respectively.     

涡环伞降末敏子弹的稳态扫描动力学特性

综合采取理论建模、高空自由落体试验及可视化仿真相结合的方法,研究了一种涡环伞降末敏子弹的稳态扫描动力学特性。基于第一类拉格朗日方程,建立了由弹体、降落伞、伞盘、摩擦盘、连杆所组成的五刚体动力学模型,并应用ADAMS、MATALB及VR相结合的方法进行了弹道计算和可视化仿真研究。通过在高空热气球上投放试验样弹的方法,得到了伞弹系统的运动图像、平均落速、转速等弹道数据。对比研究得出:涡环伞的运动稳定性良好,可使末敏子弹保持匀速旋转降落状态,弹体达到稳定后的落速约为13.5 m/s,转速约为3 r/s,稳态扫描角接近于弹体的静态悬挂角,仿真计算与试验结果的一致性较好。      

升力体布局飞行器偏航气动增稳方法研究

针对升力体飞行器偏航弱稳定性问题,提出了一种基于当地侧向流动膨胀/压缩原理的偏航气动增稳方法.通过对升力体后体侧缘进行曲线切削,造成切削表面流动先膨胀后压缩的气动效应,从而使得侧向气动力后移,以此实现航向压心后移、偏航静稳定性提高的目的.采用数值方法对单锥升力体布局进行了方法验证,算例表明较小的侧面切削可以大幅提高中小攻角状态偏航静稳定性,但也同时会不同程度地降低飞行器纵向静稳定性、升阻比以及横侧静稳定性.本方法在改善升力体布局航向静稳定性的同时,具有不带来航向附加气动安定面的优点,可引入相关布局设计优化之中.     

一种主动悬架式火星车稳定裕度优化控制策略

针对火星车在非结构化环境下行驶存在的稳定性不足而导致倾覆的风险，提出针对一种六轮主动悬架式火星车的稳定裕度优化控制方法。首先，考虑了火星车悬架机构调整过程中车轮与接触地面滑移和侧倾等运动关系，建立和完善了六轮主动悬架式火星车行驶的运动学模型。然后，以火星车夹角调整机构角度为变量，推导火星车在非结构环境下的稳定裕度模型。之后，使用内点法求解火星车稳定裕度的最优解，并获得期望的夹角调整机构关节角度。在此基础上，对夹角调整机构的关节角度进行规划和控制，实现火星车悬架机构构型的调整，从而提高火星车在非结构化环境下行驶的稳定裕度。最后，对火星车稳定裕度优化控制策略的有效性进行仿真验证，结果表明，所提出的控制方法可有效提高火星车在非结构化环境下行驶的稳定裕度。     

低轨Walker星座构型偏置维持控制方法分析

针对低轨（low earth orbit,LEO）Walker星座构型稳定性维持问题，分析了低轨卫星的轨道摄动和星座构型稳定性的影响因素。通过分析低轨Walker星座的轨道摄动和相对漂移特点，提出了两次偏置策略。首先，依据未偏置时星座相对漂移量拟合得出第一次偏置时的偏置量。然后利用第一次偏置后的相对漂移量拟合得出第二次偏置量，消除残余项影响。两次偏置量叠加，使相对漂移大大降低。结果表明，低轨Walker星座中各卫星的初始参数偏差造成了升交点赤经和沿迹角相对漂移的发散，两次偏置策略可将两种星座的相对漂移量降至0.1°以下，证明了策略的有效性，提高了星座构型稳定性。     

基于锁相环的光电振荡器频率稳定化研究

通过构建小数分频锁相环,将一个工作于X波段的OEO(OptoElectronic Oscillator,光电振荡器)与OCXO(Oven-Controlled Crystal Oscillator,恒温晶体振荡器)进行锁相,得到了输出信号相位噪声和长期频率稳定度的提升。从PLL(Phase-Locked Loop,锁相环)环路传输特性出发,理论分析了PLL输出信号环路带宽内相位噪声水平和作用范围。为降低OEO整体的相位噪声,采用SIL(Self-Injection-Locking,自注入锁定)使OEO在10Hz~10kHz频偏处的相位噪声得到20dB以上的抑制。在此基础上将此SIL OEO与一个频率为100 MHz的OCXO锁相,获得了频率为9.95GHz、相位噪声为-55dBc/Hz@10Hz和-124dBc/Hz@10kHz的微波信号输出,其频率的重叠阿伦方差在100s平均时间内达到1.14×10~(-11),证明了提出的方案对提升OEO频率稳定性具有一定的实际意义。     

Aircraft nonlinear stability analysis and multidimensional stability region estimation under icing conditions

Icing is one of the crucial factors that could pose great threat to flight safety,and thus research on stability and stability region of aircraft safety under icing conditions is significant for control and flight.Nonlinear dynamical equations and models of aerodynamic coefficients of an air craft are set up in this paper to study the stability and stability region of the aircraft under an icing condition.Firstly,the equilibrium points of the iced aircraft system are calculated and analyzed based on the theory of differential equation stability.Secondly,according to the correlation theory about equilibrium points and the stability region,this paper estimates the multidimensional stability region of the aircraft,based on which the stability regions before and after icing are compared.Finally,the results are confirmed by the time history analysis.The results can give a reference for stability analysis and envelope protection of the nonlinear system of an iced aircraft.     

考虑结构因素的起落架摆振稳定性分析及优化

以考虑侧向柔性和陀螺特性的摆振数学模型为例,研究了起落架摆振结构因素的影响.采用代数稳定性判据、状态空间法等方法进行了稳定性分析,得到了有关侧向刚度、偏摆刚度和稳定距等结构因素的稳定性区域,以及幅相特性曲线.而且对于起落架摆振优化,提出了基于遗传算法的PID主动控制策略.仿真结果表明,方法有效抑制了各种结构参数组合下摆振的发生,使得受控系统具有一定的强鲁棒性.     

铣削加工工艺力学机理研究

结构件数控铣削加工技术广泛应用于航空航天工业中。铣削加工中,不合理工艺参数下的切削力会引起较大刀具-工件变形及加工颤振,极大影响着加工精度和质量。深入研究工艺过程的力学机理,进而采用建模仿真技术来优选工艺参数,对高效高精度加工技术的实现具有重要意义。本研究围绕切削力建模、动力学建模与颤振稳定性分析以及变形误差预测与控制技术等相关工作进行介绍。