斜楔式槽钢冲孔模

主要介绍了斜楔式槽钢冲孔模的结构与工作原理,以及凸模、双向斜楔、退料组件等主要零部件的设计技术方法。     

脉冲爆震发动机模型机平均推力特性计算与实验研究

针对如何确定脉冲爆震发动机平均推力的问题,介绍了体积比冲估算法、推力壁压力曲线积分法和弹簧-质量-阻尼系统法的计算与测量原理。建立了PDE模型机推力测试台架系统。同时采用推力壁压力曲线积分法和弹簧-质量-阻尼系统法对一PDE模型机在不同频率多循环工况下的平均推力特性进行实验研究。对比分析了体积比冲估算法、推力壁压力曲线积分法和弹簧-质量-阻尼系统法所获得的PDE模型机平均推力计算值与实验值,发现：PDE模型机的平均推力随工作频率的升高基本上呈线性增加;同一工作频率下,采用体积比冲估算法得到的平均推力最大,推力壁压力曲线积分法次之,弹簧-质量-阻尼系统法最小;PDE模型机平均推力应处于推力壁压力曲线积分法与弹簧-质量-阻尼系统法所测推力之间。     

气相爆轰波传播特性的数值模拟及实验对照

本文应用基元反应模型和频散可控耗散格式(DCD)对氢氧爆轰波进行了二维数值模拟.氢氧混合物的化学反应模型考虑了8种组分20个反应方程式.在处理化学反应引起的刚性问题时采用了时间算子分裂的方法.本文首先对爆轰波数值结果和实验结果进行了对照验证,然后对爆轰波在楔面反射由马赫反射向规则反射转变的过程进行了数值分析,得到了反射转变临界角,并和实验结果及理论分析进行了比较,结果是令人满意的;本文还对爆轰波的多波结构进行了初步的数值分析.     

螺旋爆轰内部胞格结构实验探索

为研究螺旋爆轰胞格结构,选取预混气C2H2+2.5O2+85%Ar、C2H2+2.5O2+70%Ar与C2H2+5N2O在光滑管中进行爆轰实验,使用烟膜记录管道侧壁与端面胞格结构。编写MATLAB程序处理烟膜记录,比较侧壁横波间距、端面胞格直径平均值,以及相邻端面胞格中心点距离平均值与标准差。其中,侧壁横波间距明显大于管壁附近端面胞格直径平均值。另外,相较于稳定气,不稳定气近管壁与近管轴区域的端面胞格直径差异更大,不同压力下预混气C2H2+5N2O近管壁与近管轴区域的端面胞格直径差异分别为47.91 %、59.64 %、40.42 % 与37.21 %。为进一步探索爆轰波内部结构,使用CH4+2O2在5 mm、15 mm与25 mm宽度的环形管进行实验,对比侧壁及端面烟膜结果可观测到内部螺旋横波旋转方式。相对环管宽度而言,初始压力是胞格尺寸的主要影响参数,而整体上外侧壁胞格尺寸稍大于内侧壁胞格尺寸。     

煤油/氧气预爆器爆震波特性研究

为了解决液态煤油旋转爆震发动机短距离快速起爆问题,进行了煤油/氧气预爆器方案设计。此方案包括双级轴向旋流和离心喷嘴匹配方案、半圆轴向垂直预爆管和圆管切向预爆管等设计,建立了液态煤油/氧气预爆器爆震波特性试验台。探讨了不同工作时序、当量油气比、预爆管结构等对预爆器爆震燃烧特性的影响。结果表明预爆器产生的爆震波压力达到4.0MPa以上,爆震波传播速度高于1300m/s,液态煤油/氧气最佳当量油气比存在于0.6-0.73之间一点。对比半圆轴向垂直预爆管和圆管切向预爆管,圆管模型爆震波压力明显高于半圆管模型,而传播速度却低于半圆管模型,圆管模型整体存在着前导激波的生成,而半圆管模型却在生成的爆震波后方有明显的压力波动现象     

障碍物对脉冲爆震火箭发动机性能影响的实验研究

为了探究障碍物对脉冲爆震火箭发动机在无阀自适应工作方式下性能的影响,采用汽油为燃料,富氧空气为氧化剂,开展了工作频率为20Hz的无阀式多循环实验研究。实验中使用Shchelkin螺旋、螺旋凹槽、环形凹槽和孔板作为障碍物,并分析了其对起爆和推进性能的影响。研究结果表明,Shchelkin螺旋、螺旋凹槽和环形凹槽在阻塞比BR=0.36,0.46和0.56时都可实现PDRE的稳定工作,孔板在BR=0.56时无法实现爆震的起始;Shchelkin螺旋的DDT距离和DDT时间最短;实验测得的平均推力较理想流动模型理论值有13.3%~39.3%的亏损,BR=0.36的Shchelkin螺旋推力损失最小;螺旋凹槽与环形凹槽的DDT距离和DDT时间较长,没有明显的推力增益。     

小型弹用涡轮发动机发展综述

小型涡轮喷气和涡轮风扇发动机可为高亚音速、中远程导弹提供理想的巡航动力,是各军事强国竞争的焦点。弹用涡轮发动机具有成本低、寿命短、尺寸小、转速高、增压比低、容积热强度大、起动和点火方式多样等特点,已被广泛应用于巡航、反舰和空地等多种战略与战术导弹。从国内外主要产品及其技术参数、性能与结构基本特点、应用现状、发展趋势等方面,对20世纪70年代以来100~700daN推力范围内弹用涡轮发动机的发展情况进行梳理和分析。指出更低成本、更少油耗和更优结构将是未来导弹推进系统继续追求的目标;螺桨风扇发动机高速性好、耗油率低,脉冲爆震涡轮发动机循环效率高、结构简单,是未来先进弹用涡轮发动机重要的发展方向。     

A self-similar solution of a curved shock wave and its time-dependent force variation for a starting flat plate airfoil in supersonic flow

The problem of aeroelasticity and maneuvering of command surface and gust wing interaction involves a starting flow period which can be seen as the flow of an airfoil attaining suddenly an angle of attack. In the linear or nonlinear case, compressive Mach or shock waves are generated on the windward side and expansive Mach or rarefaction waves are generated on the leeward side. On each side, these waves are composed of an oblique steady state wave, a vertically-moving one-dimensional unsteady wave, and a secondary wave resulting from the interaction between the steady and unsteady ones. An analytical solution in the secondary wave has been obtained by Heaslet and Lomax in the linear case, and this linear solution has been borrowed to give an approximate solution by Bai and Wu for the nonlinear case. The structure of the secondary shock wave and the appearance of various force stages are two issues not yet considered in previous studies and has been studied in the present paper. A self-similar solution is obtained for the secondary shock wave, and the reason to have an initial force plateau as observed numerically is identified. Moreover, six theoretical characteristic time scales for pressure load variation are determined which explain the slope changes of the time-dependent force curve.     

Experimental research on rotating detonation with liquid hypergolic propellants

This paper describes experimental research into the initiation and propagation of rotating detonation for liquid Nitrogen TetrOxide (NTO) and liquid MonoMethylHydrazine (MMH). An annular rocket-type combustor without nozzle was designed to investigate detonation combustion. The propellants were injected through unlike impingement injectors. The combustion flame fronts and pressure waves were detected using optical diagnostics and dynamic pressure sensors, respectively. The propagation of rotating detonation was established spontaneously by increasing the mass flow rate of propellants. The velocity of propagation of the flame fronts and pressure waves was nearly equal and reaches supersonic speed. Two different detonation combustion patterns are present, single wave mode and double waves mode. And in double waves mode, the two detonation waves are always counter-rotating. The possibility of rotating detonation initiation in a combustor with nozzle was also checked. Stable rotating detonation can be initialized and sustained at similar operating conditions.     

Kink mode m = 1 in magnetic tube with discontinuous magnetic field

In this paper, we study conditions of realization and stability of kink modes with azimuthal wave numbers $m=\pm 1$ in cylindrical plasma flex with twisted magnetic field and homogeneous current along its axis. We assume permanent axial magnetic field both inside and outside the flex, surrounded by currentless plasma. Azimuthal magnetic field decreases inversely proportional to the distance from the boundary beyond the flex. We derived dispersion equations for stable and unstable modes in approximation of “thin” plasma flex. The analysis of equations has been provided for the case of discontinuous axial magnetic field on flex’s boundary. Conditions of propagation of wave modes have been defined. It was shown, that unstable modes can be implemented in certain interval of longitudinal wavenumbers. Results can be applied for the interpretation of solar magnetic tubes behavior, using measurements, provided by spacecrafts.