Fault diagnosis based on measurement reconstruction of HPT exit pressure for turbofan engine

Aero-engine gas path health monitoring plays a critical role in Engine Health Management(EHM). To achieve unbiased estimation, traditional filtering methods have strict requirements on measurement parameters which sometimes cannot be measured in engineering. The most typical one is the High-Pressure Turbine(HPT) exit pressure, which is vital to distinguishing failure modes between different turbines. For the case of an abrupt failure occurring in a single turbine component, a model-based sensor measurement reconstruction method is proposed in this paper. First,to estimate the missing measurements, the forward algorithm and the backward algorithm are developed based on corresponding component models according to the failure hypotheses. Then,a new fault diagnosis logic is designed and the traditional nonlinear filter is improved by adding the measurement estimation module and the health parameter correction module, which uses the reconstructed measurement to complete the health parameters estimation. Simulation results show that the proposed method can well restore the desired measurement and the estimated measurement can be used in the turbofan engine gas path diagnosis. Compared with the diagnosis under the condition of missing sensors, this method can distinguish between different failure modes, quantify the variations of health parameters, and achieve good performance at multiple operating points in the flight envelope.     

一种基于参数控制的低轨星载接收机载波跟踪算法CSCD

低轨星座接收机面临大多普勒频移及频繁快速换星等设计约束,对其载波跟踪环路设计提出了较高的动态适应性与跟踪精度要求。针对以上问题,提出了一种基于参数控制的载波跟踪算法。该算法引入环路控制因子参数,将环路滤波器分为牵引和跟踪两阶段。基于理论建模推导环路控制因子的最优参数配置原则,指导实现牵引和跟踪两种状态滤波器的协同配合,在牵引阶段有效引导大多普勒信号快速入锁,在跟踪阶段精确估计载波频移参数,实现基于低轨星载平台的GNSS信号快速准确跟踪。理论与仿真结果均表明基于参数控制的载波跟踪算法能够有效提升环路的动态适应性与跟踪精度,满足低轨星载接收机的设计需求。与传统算法相比,该算法在保证信号跟踪精度的同时,能够将收敛时间缩短78%,且环路设计简单,易于硬件实现。     

INTEGRATED GPS/INS OF PSEUDO-RANGE DELTA-RANGE SEMI-PHYSICAL SIMULATION'S RESEARCH

In order to further study the performance of tightly integrated navigation system of GPS/INS, a semi-physical simulation of tightly coupled system has been done based on the data gathered from the experiment of integrated system of GPS and INS. The closed-loop Kalman Filter and U-D discompose algorithm have been used. The simulation results associated to four integrated models of pseudo-range, delta-range, pseudo-range and delta-range alternation, and pseudo-range and delta-range synthesis have been provided, and the actual effects of variously integrated models have been analyzed. The results show that the pseudo-range and delta-range synthesis coupled model is the most effective to improve the coupled system performance and the individual delta-range coupled model had better be avoided in application.     

Denoising methods in interferometric SAR images processing

ＩｎｔｅｒｆｅｒｏｍｅｔｒｉｃＳＡＲ（ＩｎＳＡＲ）ｐｒｏｖｉｄｅｓａｍｅａｎｓｔｏｏｂｔａｉｎｈｉｇｈｒｅｓｏｌｕｔｉｏｎｄｉｇｉｔａｌｔｏｐｏ－ｇｒａｐｈｉｃｍａｐｓｗｉｔｈｌａｒｇｅｓｗａｔｈｗｉｔｈｏｕｔｔｈｅｅｆｅｃｔｏｆｔｈｅｗｅａｔｈｅｒ...     

干涉SAR图像的降噪方法及水平地形效应消除

考察不同滤波器抑制干涉SAR(Synthetic Aperture Radar)图像噪声的效果.为有效地使用低通滤波处理,首先对原始干涉图像进行水平地形效应消除,保证图像信号频率的中心在零频处,降低由干涉SAR系统几何结构引起的信号频率偏移对滤波效果的影响.同时水平地形效应消除后的干涉SAR相位图可直观地反映地形的拓扑结构.实际数据处理结果证明本文提出的水平地形效应消除算法及滤波算法的可行性及有效性.      

静电陀螺漂移的补偿和监控方法

简要介绍静电陀螺惯性导航系统的基本原理及其常平架结构。由于静电陀螺具有良好的漂移特性,上述系统位置误差随时间增长速度极低。着重讨论静电陀螺漂移模型及其在系统中补偿和监控方法。利用系统内部冗余轴漂移的实时测量将卡尔曼滤波器应用于上述系统,有效地改善了惯性导航系统的精度;此外还同时估计出绕冗余轴方向陀螺漂移的未知常值偏差,取得满意的仿真结果。     

跟踪飞机机动的自适应滤波方法

本文研究了对目标机动的最优检测问题,针对飞机主要有三种飞行状态:匀速直线运动、加速直线运动与圆运动这一特点,提出了既探测飞机机动又同时判断飞机作何种形式的机动的方法;并建议对飞机的不同飞行状态,采用相应的动态模型。在此基础上,给出了自适应滤波方法。最后给出的仿真计算果表明,自适应滤波方法有较高的跟踪精度。     

均值检验方法及其在冗余惯性导航系统中的应用

采用了非线性滤波的方法对影响故障检测及分离（FDI）性能的传感器误差进行了补偿,同时提出了故障检测与分离的均值检验方法（MVT）,该方法可以对2个传感器同时出现故障的情况进行检测与隔离。5个陀螺冗余惯性导航系统仿真结果验证了本文算法的有效性。     

巴特沃兹有源滤波器设计中的灵敏度分析

通过对两种巴特沃兹有源滤波器设计方案的灵敏度分析,仿真了电路元件参数灵敏度随 Q 因数的变化规律,从而介绍了一种利用灵敏度分析比较网络设计方案优劣的方法。     

陀螺稳定平台漂移误差参数的辨识方法研究

给出了一种平台工作在惯性稳定状态下的静态多位置测漂方案 ,建立了包含陀螺漂移、地球自转因素在内的平台漂移数学模型和系统状态方程 ,解决了三轴开路状态下的耦合问题。取框架角传感器的输出作为观测量 ,利用广义Kalman滤波器对含有噪声的测量数据进行处理 ,将参数辨识问题转化为状态估计 ,仿真结果表明 ,此方法可以获得较好的辨识效果