频域盲源分离的非圆信号推广

作为盲源分离（BSS）问题的最有效解决方法之一,独立分量分析（ICA）算法可以分为时域和频域算法两类.将时域盲源分离的快速算法推广到频域,通过在频域中应用非圆信号的伪协方差矩阵,推导出一个新的固定点算法来解决线性瞬时混合的非圆信号盲源分离（BNSS）问题.仿真实验验证了该算法的有效性.     

三支点柔性转子系统支承不同心激励特征及振动响应分析

针对航空发动机三支点柔性转子系统的支承不同心问题,充分考虑转子结构特征和载荷特征,首次将当量刚度引入多支点柔性转子不同心问题的动力学分析,定量描述转子系统各支承间不同心度带来的转子轴段刚度非线性,并提出了多跨度柔性转子系统支承不同心激励的数学描述,建立了不同心激励下多跨度柔性转子系统的力学模型。基于Lagrange能量法,给出了转子系统动力学方程的求解方法,研究得到了支承不同心转子系统的动力响应特征。结果表明:支承不同心不仅引起转子过渡轴的刚度非线性,产生2倍频激励,还会给转子系统带来附加不平衡激励;对于三支点柔性转子系统而言,2倍频分量同样是支承不同心下转子系统振动响应的典型特征之一。转子系统2倍频分量随不同心量的增加而迅速增加,而1倍频分量基本保持不变。同时转子振动响应呈现"缓增速降"趋势,且随非线性刚度、不平衡量的增大愈加明显。     

A straw-soil co-composting and evaluation for plant substrate in BLSS

Material closure is important for the establishment of Bioregenerative Life Support System, and many studies have focused on transforming candidate plant residues into plant culture medium. For the limitations of using wheat straw compost as substrate for plant cultivation, a straw-soil co-composting technique was studied. The changes of pH, C/N value, germination index, cellulose, lignin and so on were monitored during the co-composting process. The maturity was evaluated by the C/N value and the germination index. The result showed that after 45 days’ fermentation, the straw-soil final co-compost with inoculation (T1) became mature, while the co-compost without inoculation (T0) was not mature. In the plant culture test, the T1 substrate could satisfy the needs for lettuce’s growth, and the edible biomass yield of lettuce averaged 74.42 g pot⁻¹ at harvest. But the lettuces in T0 substrate showed stress symptoms and have not completed the growth cycle. Moreover, the results of nitrogen (N) transformation experiment showed that about 10.0% and 3.1% N were lost during the T1 co-composting and plant cultivation, respectively, 23.5% N was absorbed by lettuce, and 63.4% N remained in the T1 substrate after cultivation.     

一种非线性飞行控制律评估方法研究

研究了一种基于改进遗传算法的非线性评估方法。将非线性准则转换成简单的适应度函数,通过寻优找到最坏情况,在其基础上实现评估。仿真结果表明,该方法不仅能在各个飞行状态对飞行控制律进行非线性准则评估,而且能找出飞行包线内的最坏飞行状态,细化飞行包线,方法使用灵活,结果可靠。     

基于灰色补偿反步法的机动指令跟踪控制

基于三自由度飞行动力学模型和运动学模型,提出了一种带有灰色补偿的反步(Back-stepping)控制方法,以实现某些预定的战术机动动作。首先,将飞行动力学模型和运动学模型分解成3个轴方向的相对简单的子系统;然后,针对3个子系统采用反步法分别设计出模型中没有干扰时的控制律,并采用GM(0,N)预测模型对不确定部分的模型参数进行辨识,进一步根据估计出的参数设计灰色补偿控制律;最后,根据3个子系统设计出的控制律解算出同时满足3个子系统渐进稳定的控制输入,这样使得整个系统渐进稳定。仿真结果表明,GM(0,N)预测模型能精确预测不确定模型参数,该算法能够高效实现预定的战术机动动作。     

基于金属密封垫圈非线性变形仿真的预紧设计

为确保密封结构能有效阻止箱体内部介质的泄漏,要求密封面具备一定的密封比压,即通过施加合理的拧紧力矩来控制密封件的压缩量。目前主要采用试验方法验证一系列拧紧力矩下的密封效果,从而获取临界力矩值并确定可靠的拧紧力矩设计值。文章基于试验经验做出了合理的假设以建立简化的非线性有限元分析模型,对金属垫圈在压紧力下的塑性变形进行仿真,通过金属垫圈发生临界变形量的压紧力反推出拧紧力矩的临界值。该方法获取的临界力矩值与试验方法相近,可以有效地提高设计效率,降低试验成本。     

The use of Gaussian equations of motions of a satellite for local gravity anomaly recovery

The orbital elements of a low Earth orbiting satellite and their velocities can be used for local determination of gravity anomaly. The important issue is to find direct relations among the anomalies and these parameters. Here, a primary theoretical study is presented for this purpose. The Gaussian equations of motion of a satellite are used to develop integral formulas for recovering the gravity anomalies. The behaviour of kernels of the integrals are investigated for a two-month simulated orbit similar to that of the Gravity field and steady-state ocean circulation explorer (GOCE) mission over Fennoscandia. Numerical investigations show that the integral formulas have neither isotropic nor well-behaved kernels. In such a case, gravity anomaly recovery is not successful due to large spatial truncation error of the integral formulas. Reformulation of the problem by combining the orbital elements and their velocities leads to an integral with a well-behaved kernel which is suitable for our purpose. Also based on these combinations some general relations among the orbital elements and their velocities are obtained which can be used for validation of orbital parameters and their velocities.     

求解一维非线性守恒律的一类MmB差分格式

本文构造了一维非线性双曲型守恒方程的一类ＭｍＢ差分格式，并推广到方程组情形。数值计算结果表明，格式具有高分辨率且不会产生数值为振荡。     

放大器中非线性失真的研究

晶体管是非线性器件,在放大信号时会产生非线性失真.针对弱非线性失真,推导了总谐波人(THD)、二阶互调失真(IM2)、三阶互调失真(IM3)和截点(IP3)的表达式,借助于Multisim软件,对晶体管共发放大器、发射极带反馈电阻的失发放大器、差分放大器和发射极间带反馈电阻的差分放大器进行了仿真,并与理论结果作了比较,结果令人满意.     

基于特征空间变换的运载火箭Pogo模型降阶方法

针对运载火箭Pogo状态空间模型存在维数高和奇异性的问题,开展了Pogo模型的降阶方法研究。基于特征空间变换理论,导出了一般形式的Pogo状态空间模型的解耦形式。该形式与推进系统和结构系统的模态频率相对应,从而通过模态截断或保留感兴趣的模态实现有效的模型降阶。同时,还给出了降阶方法的实数运算公式。在两种不同型号推进系统的火箭Pogo问题中进行了仿真校验。结果表明所提出的降阶方法对奇异和非奇异Pogo状态空间模型都能给出正确的降阶模型,显著地提高计算效率,具有很好的通用性,为Pogo时域仿真和主动抑制提供了合适的模型。