极区中层惯性重力波VHF雷达观测的统计特征

本文采用ＳＯＵＳＹＶＨＦ雷达１９８７年６月２２日至６月２９日在挪威Ａｎｄφｙａ（６９°Ｎ，１０°Ｅ）的观测数据，研究中层惯性重力波传播的统计特征．２１个周期为数小时的准单色波例子，在垂直方向上有确定的相位移动，表明它们是惯性内重力波．通过分析波相关水平扰动速度的矢端曲线，获得了水平传播矢量的大小和方向的分布，大多数（７６％）波具有西向传播的波矢分量，似乎与中层顶具有强的西向背景风有关；水平传播速度的大小与中层高度上典型的观测值一致．本文分析结果还表明在极区中不仅存在向上的能量传输，也存在强烈的向下的能量传输．     

飞机壁板结构的声疲劳计算及试验

 <正> 飞机结构所承受的噪声载荷声压级超过130dB时,经较长时间激励,往往在噪声诱导应力较大的区域里产生疲劳破坏。而在各种类型的结构件中声疲劳破坏的相对发生率以蒙皮壁板结构为最高。 本文采用矩形铝合金平板来模拟蒙皮壁板结构,对其进行了声疲劳寿命计算与试验研究.     

Hypervelocity impact induced shock acoustic emission waves for quantitative damage evaluation using in situ miniaturized piezoelectric sensor network

Manmade debris and natural meteoroids, travelling in the Low Earth Orbit at a speed of several kilometers per second, pose a severe safety concern to the spacecraft in service through the HyperVelocity Impact(HVI). To address this issue, an investigation of shock Acoustic Emission(AE) waves induced by HVI to a downscaled two-layer Whipple shielding structure is performed,to realize a quantitative damage evaluation. Firstly a hybrid numerical model integrating smoothparticle hydrodynamics and finite element is built to obtain the wave response. The projectiles, with various impact velocities and directions, are modelled to impact the shielding structure with different thicknesses. Then experimental validation is carried out with built-in miniaturized piezoelectric sensors to in situ sense the HVI-induced AE waves. A quantitative agreement is obtained between numerical and experimental results, demonstrating the correctness of the hybrid model and facilitating the explanation of obtained AE signals in experiment. Based on the understanding of HVI-induced wave components, assessment of the damage severity, i.e., whether the outer shielding layer is perforated or not, is performed using the energy ratio between the regions of ‘‘high frequency" and ‘‘low frequency" in the acquired AE signals. Lastly, the direct-arrival fundamentalsymmetric wave mode is isolated from each sensing signal to be input into an enhanced delay-andsum algorithm, which visualizes HVI spots accurately and instantaneously with different sensor network configuration. All these works demonstrate the potential of quantitative, in situ, and real time HVI monitoring using miniaturized piezoelectric sensor network.     

W波段UAV MISAR实时成像运动补偿方法

建立了实时成像正侧视合成孔径雷达(SAR)运动误差模型,采用了一种基于惯导和相位梯度自聚焦(PGA)运动误差估计的中心波束平面运动补偿算法。该算法对回波包络和相位进行分开补偿,利用惯导数据把带有运动误差的回波包络拉直,再利用相位梯度自聚焦算法对回波进行相位误差估计并补偿。针对实时成像的时间少、运算量大、运算资源受限等特点,该算法取消了距离徙动校正的步骤,将运动误差矢量在斜距平面投影并完成包络校正和相位误差估计。该方法运算量小,同时能满足分辨率要求。仿真结果表明:该方法能够得到质量较高的SAR图像。     

一种修正的Osher通量在高阶WCNS中的特性

将一种基于多维修正的Osher通量运用于高阶加权紧致非线性格式(WCNS)中,该修正通量主要在垂直于激波面的界面上增加耗散,能够改善Osher通量的激波捕捉稳定性,同时对边界层和接触间断的分辨率影响非常小。对修正的Osher通量在高阶WCNS中的特性进行研究,通过数值模拟测试了基于Osher通量的WCNS的激波稳定性、热流预测精度、边界层模拟能力、激波边界层干扰模拟能力,并与Steger-Warming通量和Roe通量进行了对比。结果表明修正后的Osher通量比Harten修正的Roe通量具有更好的激波捕捉鲁棒性,而边界层、驻点热流值和激波边界层干扰的模拟则明显优于Steger-Warming通量。上述结果说明了基于修正的Osher通量的高阶WCNS具有较好的激波捕捉特性、热流预测精度和边界层计算能力。     

白天激光漫反射测距中微弱信号检测的单开门多触发方法

白天激光漫反射测距因存在强背景噪声,导致微弱回波信号的检测十分困难,严重限制了激光漫反射测距的广泛应用。因此,提出了采用单开门多触发方法解决白天激光漫反射测距的微弱信号检测难题。首先,介绍了一种GM-APD (Geiger-ModeAvalanchePhotoDiode,盖革模式雪崩光电二极管)多触发概率分布函数的快速求解方法。接着,取激光漫反射测距系统典型参数,理论分析了多触发情况下的回波信号检测概率,分析结果表明单开门多触发方法可提高激光漫反射测距在白天情况下的回波信号检测概率。同时,通过对触发次数限制的优选,可以增加有效检测比,减少白天观测条件下回波信号的提取代价。最终,通过系统仿真验证了理论分析结果的正确性。因此,单开门多触发方法是解决白天激光漫反射测距微弱信号检测的可行途径之一。     

Coupled Stress-Electricity Model for Electromagnetic Emission Induced by Concrete Fracture

Electromagnetic emission induced during concrete fracturing is of great significance to health monitoring of concrete structures.A coupled stress-electricity model is established by analyzing the interaction between stress and electricity during concrete fracturing.And based on this model,the electromagnetic radiation parameters are calculated.The theoretical calculation is well coincident with experimental results.This work provides theoretical support for concrete testing system.     

基于空间矢量脉宽调制的过调制策略研究

在电机控制中,过调制算法能够显著提高逆变器输出的电压,对提高电机转速有着重要意义。为了改善空间矢量脉宽调制对直流母线电压利用率不足的缺点,研究了基于空间矢量脉宽调制的单模式过调制算法,对输出电压基波幅值与其谐波含量进行理论分析。针对过调制区实际输出电压基波幅值与参考电压不一致这一问题,对目标调制比与给定调制比的关系作出可控性分析,作出拟合曲线并求出函数关系,最后对该过调制算法进行了仿真研究和试验验证。仿真分析和试验验证结果均证明了理论分析的正确性和可行性。     

Satellite launch vehicle effect on the Earth’s lower ionosphere: A case study

The effect of the rocket exhaust products on the D-region of the ionosphere is investigated with the help of Very low frequency (VLF) electromagnetic wave propagation characteristics within the Earth-ionosphere waveguide. The changes in the electron density profile are computed from the observed VLF signal amplitude perturbations about 3 dB during the rocket launch. We find a localized electron depletion in the lower ionosphere at an altitude of around 58 km, that is thought to be originated by the attachment of ionospheric ion and molecular hydrogen along with water molecule in the exhaust product of first stage burn of Geosynchronous Launch Vehicle (GSLV) rocket at the time of GSLV launched from Sriharikota, India, on 27 August 2015 at 11:22 UT (16:52 IST). The ionospheric depletion perturbed the navigational VLF signal (VTX = 17 kHz) 134 s after the launch of the GSLV rocket.     

前后缘型线同时可控的乘波体设计

提出了一种前后缘型线同时可控的乘波体设计方法,在马赫数可控的外锥形曲面基准流场中,结合流线追踪技术和混合函数,实现了椭圆前缘转椭圆后缘的乘波体设计,并在设计点(Ma=6.0)和接力点(Ma=4.0)对其进行数值仿真研究。前后缘同时可控的乘波体在型面剧烈过渡处产生了较弱的激波,出口两侧存在高温高压区,后部对称面附近的激波形状由圆弧变为平直线且出口处流场基本均匀,非常有利于与进气道匹配设计。另外,该乘波体具有较高的容积率和预压缩效率,附面层修正后的容积率为0.24,设计点时乘波特性较好,接力点时前部完全乘波,具有较高的升阻比,有黏条件下设计点和接力点的升阻比分别为2.54和2.41。此外,与给定前缘的乘波体相比,其升力、阻力、俯仰力矩和出口增压比都有明显增加,但是升阻比和出口总压恢复系数有所降低,在设计点无黏升阻比由3.56降为3.00。以上研究表明,本文的设计方法可行且更加灵活,拓宽了乘波体的选择范围。