深空网伪码测距技术研究

介绍了NASA深空网所采用的伪码测距的基本原理,讨论了深空航天器应答机相干转发或再生所采用伪码序列的两种形式,对再生测距系统中的具体序列产生和相关、以及用中国剩余定理解算距离的实现方法和技术途径进行了分析,并计算分析了测距精度、捕获时间等系统关键指标,以对我国深空网的建设提供技术理论参考.     

自校准定轨方法的精度评定

推导了自校准定轨的误差协方差公式。与非校准方法相比,指出了自校准定轨能够同时修正系统误差和改善定轨精度,并提出了敏感度矩阵在选取校准参数中的作用及其值得注意的方面。     

一种减小PFC变换器电容规格的方法

常规的由Boost和DC/DC变换器级联构成的两级式PFC变换器,在Boost电路输出端要接高耐压等级的电解电容作为储能电容,不仅体积大、价格高,而且寿命短,为此本文研究了一种低压输出的Boost/半桥组合式软开关谐振PFC变换器。该变换器利用半桥电路输出端的低压电解电容平衡瞬时功率,Boost电路输出端电容与变压器漏感谐振,并不大量储能,由此减小了Boost电路电容的规格,提高了工作可靠性。讨论了该变换器的控制策略,前后级共用一套控制电路,实现功率管的软开关和能量的传递。分析了降低电容容值的可行性,指出采用小容值非电解电容替代Boost电路输出端的大容量电解电容后,变换器具有良好的性能。给出了Boost和半桥电路输出端电容的设计方法,进行了实验验证。     

Flow Stability Model for Fan/Compressors with Annular Duct and Novel Casing Treatment

A three-dimensional compressible flow stability model is presented in this paper, which focuses on stall inception of multi-stage axial flow compressors with a finite large radius annular duct configuration for the first time. It is shown that under some assumptions, the stability equation can be obtained yielding from a group of homogeneous equations. The stability can be judged by the non-dimensional imaginary part of the resultant complex frequency eigenvalue. Further more, based on the analysis of the unsteady phenomenon caused by casing treatment, the function of casing treatment has been modeled by a wall impedance condition which is included in the stability model through the eigenvalues and the corresponding eigenfunctions of the system. Finally, some experimental investigation and two numerical evaluation cases are conducted to validate this model and emphasis is placed on numerically studying the sensitivity of the setup of different boundary conditions on the stall inception of axial flow fan/compressors. A novel casing treatment which consists of a backchamber and a perforated plate is suggested, and it is noted that the open area ratio of the casing treatment is less than 10%, and is far smaller than conventional casing treatment with open area ratio of over 50%, which could result in stall margin improvement without obvious efficiency loss of fan/compressors.     

萤火一号火星探测器轨道设计与科学探测事件分析

针对萤火一号火星探测器在2011年发射窗口的轨道进行初步设计.在此基础上,分析了萤火一号火星探测器绕火星飞行的轨道特性,预报其穿越火星弓激波和磁堆积区域、CCD相机拍照时刻,其与深空站进行星-地掩星试验和与俄罗斯Phobos-Grunt火星探测器进行星-星掩星试验的时刻.结果表明,萤火一号火星探测器在与俄罗斯Phobos-Grunt分离后一年的环火飞行时间里,存在大量的科学探测机会.     

Ionospheric response of equatorial and low latitude F-region during the intense geomagnetic storm on 24–25 August 2005

In this investigation, we present and discuss the response of the ionospheric F-region in the South American and East Asian sectors during an intense geomagnetic storm in August 2005. The geomagnetic storm studied reached a minimum Dst of −216 nT at 12:00 UT on 24 August. In this work ionospheric sounding data obtained of 24, 25, and 26 August 2005 at Palmas (PAL; 10.2° S, 48.2° W; dip latitude 6.6° S), São José dos Campos (SJC, 23.2° S, 45.9° W; dip latitude 17.6° S), Brazil, Ho Chi Minh City, (HCM; 10.5° N, 106.3° E; dip latitude 2.9° N), Vietnam, Okinawa (OKI; 26.3° N, 127.8° E; dip latitude 21.2° N), Japan, are presented. Also, the GPS observations obtained at different stations in the equatorial and low-latitude regions in the Brazilian sector are presented. On the night of 24–25 August 2005, the h′F variations show traveling ionospheric disturbances associated with Joule heating in the auroral zone from SJC to PAL. The foF2 variations show a positive storm phase on the night of 24–25 August at PAL and SJC during the recovery phase. Also, the GPS-VTEC observations at several stations in the Brazilian sector show a fairly similar positive storm phase on 24 August. During the fast decrease of Dst (between 10:00 and 11:00 UT) on 24 August, there is a prompt penetration of electric field of magnetospheric origin that result in abrupt increase (∼12:00 UT) in foF2 at PAL, SJC (Brazil) and OKI (Japan) and in VTEC at IMPZ, BOMJ, PARA and SMAR (Brazil). OKI showed strong oscillations of the F-region on the night 24 August resulted to the propagation of traveling atmospheric disturbances (TADs) by Joule heating in the auroral region. These effects result a strong positive observed at OKI station. During the daytime on 25 August, in the recovery phase, the foF2 observations showed positive ionospheric storm at HCM station. Some differences in the latitudinal response of the F-region is also observed in the South American and East Asian sectors.     

恒压式气体流量计变容室截面面积测量技术研究

为了研制恒压式气体微流量计,设计了以波纹管为主体的变容室,并对波纹管变容室截面面积进行了测量。采用多项式拟合公式对波纹管截面面积测量结果进行了修正,避免了波纹管非线性的影响,结果表明修正后偏差小于0.16%,截面面积的测量结果合成标准不确定度小于0.53%,可以满足使用要求。     

航天器技术状态基线与技术状态文件的应用探讨

技术状态基线和技术状态文件管理是航天器研制过程中技术状态管理的重要组成部分。文章总结了航天器技术状态基线和技术状态文件的分类;针对在航天器实际应用中存在的对技术状态基线和技术状态文件的理解和认识不统一问题,梳理了研制阶段与技术状态基线的对应关系,并以此为基础探讨和分析了功能、研制(分配)与生产(产品)三类基线的建立,功能技术状态文件、研制技术状态文件和生产技术状态文件的形成与组成,以及技术状态控制过程中形成的文件归类问题。结合某新研遥感卫星技术状态管理过程,进一步阐述了新研航天器开展的与技术状态基线和技术状态文件相关的工作,并具体分析了形成的文件与技术状态文件的关系。该项目的应用效果表明,各阶段技术状态基线和文件的建立、确认、清理、总结等工作,有助于提高航天器技术状态管理的规范性和有效性。     

基于零控脱靶量的拦截器轨控发动机优化设计

为提高动能拦截器变轨拦截能力,考虑目标与拦截器相对距离、相对速度等因素,构建了拦截器零控脱靶量、轨控发动机内弹道、发动机质量与尺寸等优化模型,将遗传算法和Powell算法相结合进行轨控发动机不确定性优化设计.应用算例表明,采用优化设计后的轨控发动机,拦截器可修正的最大零控脱靶量至少提高17.9%,不确定性因素的影响更加明确,为动能拦截器总体优化设计提供了参考.      

应用于陶瓷试件的胶粘剂粘贴强度研究

陶瓷试验件在800℃以上快速升温过程中,对粘贴温度传感器的胶粘剂剥离试件现象进行研究。首先从接触角入手,阐述试验用高温胶粘剂在陶瓷试件表面进行粘贴的前提条件是胶粘剂与被粘贴物表面的接触角θ范围为0°≤θ90°;对实际中陶瓷试件表面的粗糙化处理影响胶粘剂粘贴强度进行了理论和试验分析,说明对试件表面适当粗糙化处理提高了粘贴强度并减小了接触角;最后对高温胶粘剂在高温固化过程中的加压工艺改进进行说明,并进行了试验,试验结果表明工艺改进改善了试验过程中的胶粘剂剥离问题。