Optimal friction control on a circular cylinder taking into account the reverse effect of the boundary layer

We analyze the effect of injection both of uniformly distributed over the entire cylinder surface and of the optimal one on the velocity distribution at the outer border of the boundary layer and, as a result, on friction.     

Possibilities of parallel calculations in solving gas dynamics problems in the CFD environment of FLUENT software

The results of studying an incompressible gas flow field in a periodic element of the porous structure made up of the same radius spheres are presented; the studies were based on the solution of the Navier-Stokes equations using FLUENT software. The possibilities to accelerate the solution process with the use of parallel calculations are investigated and the calculation results under changes of pressure differential in the periodic element are given.     

A program package for solving problems of FV structure design

In this paper, a program package for solving problems in the field of thin-walled three-dimensional FV structure design is described.     

Problems of application of face gasodynamic seals in aircraft engines

Problems arising in introduction of gasodynamic seals in aircraft engines are considered. The operation of a face gasodynamic seal as part of a natural gas pump is analyzed and its efficiency in the presence of oil is shown.     

A system for measuring the altitude-airspeed parameters of rotorcraft and very light flight vehicles

In this paper, a problem on measuring the altitude-airspeed parameters (AAPs) of rotorcraft and very light flight vehicles is considered. Some ways of improving systems used to measure the parameters of FV elements and units have been determined. Also suggested and substantiated are the principles and designs of the basic variants of these measuring systems as well as the algorithms of their operation.     

Two years of INTEGRAL observation of the BHC IGR J17464-3213

On March 2003, IBIS, the γ-ray imager on board the INTEGRAL satellite, detected an outburst from a new source, IGR J17464-3213, that turned out to be an HEAO-1 transient, namely H1743-322. The spectral and temporal evolutions of the source were observed by INTEGRAL in different periods. Also RXTE observed the source for the first time on 2003 March 29 during a PCA Galactic bulge scan. The source flux decayed below the RXTE PCA sensitivity limit in November 2003, then in April 2004 it was again detected by INTEGRAL. On July 3, 2004 the source was again detected by RXTE/PCA at a 2–10 keV intensity of 16 mCrab and on July 7, reached 69 mCrab. Recently, a new outburst was observed on August 2005. We briefly summarise here the behaviour of the source observed by INTEGRAL from March 2003 to August 2005. The new outbursts of the source and the analysis of all the data collected (now public) give a global view of the spectral and time behaviour of this X-ray transient.     

Unmanned aircraft navigation for shipboard landing using infrared vision

This paper addresses the problem of determining the relative position and orientation of an unmanned air vehicle with respect to a ship using three visible points of known separation. The, images of the points are obtained from an onboard infrared camera. The paper develops a numerical solution to this problem. Both simulation and flight test results are presented.     

Features of active sidestick controllers

This paper discusses the advantages of incorporating active sidesticks into a modern aircraft cockpit. Active sidestick controllers for manual pilot inputs in pitch and roll are examined for commercial transport aircraft. Options and requirements for sidesticks are reviewed. The recommendation of an active sidestick controller is developed providing both cross-cockpit coupling and autopilot backdrive capability. These characteristics provide pilot cues identical to traditional cable-linked column/yoke configurations     

Methodologies in user interface design

Software applications that require a high learning curve, a mountain of documentation, and weeks of training should be things of the past. Today's applications need to be simple to learn and to use. The human/computer interface should be intuitive and consistent. Context sensitive help should be available to keep the user on track. This paper provides some guidelines for taking commercial world concepts and applying them to the Automatic Test Equipment world. Examples included are from the Integrated Maintenance Information System (IMIS)