Adaptive canceler and pulse compressor interactions

Performance results for the sidelobe level of a compressed pulse that has been preprocessed through an adaptive canceler are obtained. The adaptive canceler is implemented using the sampled matrix inversion algorithm. Because of finite sampling, the quiescent compressed pulse sidelobe levels are degraded due to the preprocessing of the main channel input data stream (the uncompressed pulse) through an adaptive canceler. It is shown that if N is the number of input canceler channels (main and auxiliaries) and K is the number of independent samples per channel, then K/N can be significantly greater than one in order to retain sidelobes that are close to the original quiescent sidelobe level (with no adaptive canceler). Also it is shown that the maximum level of degradation is independent of whether pulse compression occurs before or after the adaptive canceler if the uncompressed pulse is completely contained within the K samples that are used to calculate the canceler weights. This same analysis can be used to predict the canceler noise power level that is induced by having the desired signal present in the canceler weight calculation     

Tracking multitarget in cluttered environment

A method for multitarget tracking and initiating tracking in a cluttered environment is proposed. The algorithm uses a sliding window of length uT (T is the sampling time) to keep the measurement sequence at time k. Instead of solving a large problem, the entire set of targets and measurements is divided into several clusters so that a number of smaller problems are solved independently. When a set of measurements is received, a new set of data-association hypotheses is formed for all the measurements lying in the validation gates within each cluster from time K-u+1 to K. The probability of each track history is computed, and, choosing the largest of these histories, the target measurement is updated with an adaptive state estimator. A covariance-matching technique is used to improve the accuracy of the adaptive state estimator. In several examples, the algorithm successfully tracks targets over a wide range of conditions     

Finding the best set of K paths through a trellis withapplication to multitarget tracking

A solution is presented to the problem of finding the best set of K completely unmerged paths through a trellis with M _i⩾K states at depth i in the trellis, i=0, 1, 2, . . ., N. Here, `best set' means that the sum of the metrics of all K paths in the set is minimized, and `completely unmerged' means that no two paths pass through a common state. The solution involves using the Viterbi algorithm on an expanded trellis. This result is then used to separate the tracks of K targets optimally in a simplified model of a multitarget radar system. The model includes measurement errors and false alarms, but it does not include the effects of missing detections or merged measurements     

Optimal speckle reduction in polarimetric SAR imagery

Speckle is a major cause of degradation in synthetic aperture radar (SAR) imagery. With the availability of fully polarimetric SAR data, it is possible to use the three complex elements (HH, HV, VV) of the polarimetric scattering matrix to reduce speckle. The optimal method for combining the elements of the scattering matrix to minimize image speckle is derived, and the solution is shown to be a polarimetric whitening filter (PWF). A simulation of spatially correlated, K-distributed, fully polarimetric clutter is then used to compare the PWF with other, suboptimal speckle-reduction methods. Target detection performance of the PWF, span, and single-channel |HH|² detectors is compared with that of the optimal polarimetric detector (OPD). A novel, constant-false-alarm-rate (CFAR) detector (the adaptive PWF) is as a simple alternative to the OPD for detecting targets in clutter. This algorithm estimates the polarization covariance of the clutter, uses the covariance to construct the minimum-speckle image, and then tests for the presence of a target. An exact theoretical analysis of the adaptive PWF is presented; the algorithm is shown to have detection performance comparable with that of the OPD     

Detection performance in K-distributed and correlatedRayleigh clutters

Performance prediction for a detection system employing noncoherent integration is carried out for a chi-square family of fluctuating targets in K-distributed clutter plus noise. The detection performance for Swerling 11 targets in the K-distributed clutter plus noise is compared with that in exponentially correlated Rayleigh clutter. The results show that the performance prediction based on N pulses integrated in clutter plus noise using the K-distributed clutter model may be approximately equivalent to that using the exponentially correlated Rayleigh-distributed clutter model     

Collapsing losses of peak signal integrators

Collapsing losses are computed for systems in which the peak return of K samples of noise plus one sample of signal-plus-noise are integrated over N looks. The statistical approach, collapsing losses, and an application are described. The peak integrator is found to have substantially lower collapsing losses than conventional systems in which the average, not the peak, is integrated     

Optimum gain control for A/D conversion using digitized I/Q data inquadrature sampling

Calculation of optimum gain for minimum distortion due to A/D (analog-to-digital) conversion requires the estimation of the input signal strength. To use a common AGC (automatic gain control) for both the I/Q (in-phase and quadrature) signals, it is efficient to estimate the input signal strength using the quantized A/D output from both channels. Assuming a Gaussian input, the relationship between σ of the input of the A/D converter and E(|x|+|y|) and E(max(|x|,|y|)+1/2 min (|x|,|y|)) for t quantized I/Q output x and y is derived. Numerical results obtained using the derived expression and the statistical data obtained through simulation show excellent agreement. It is concluded that, because of its simplicity, the cubic equation obtained by fitting the numerical results should be useful     

Reiterative median cascaded canceler for robust adaptive array processing

A new robust adaptive processor based on reiterative application of the median cascaded canceler (MCC) is presented and called the reiterative median cascaded canceler (RMCC). It is shown that the RMCC processor is a robust replacement for the sample matrix inversion (SMI) adaptive processor and for its equivalent implementations. The MCC, though a robust adaptive processor, has a convergence rate that is dependent on the rank of the input interference-plus-noise covariance matrix for a given number of adaptive degrees of freedom (DOF), N. In contrast, the RMCC, using identical training data as the MCC, exhibits the highly desirable combination of: 1) convergence-robustness to outliers/targets in adaptive weight training data, like the MCC, and 2) fast convergence performance that is independent of the input interference-plus-noise covariance matrix, unlike the MCC. For a number of representative examples, the RMCC is shown to converge using ~ 2.8N samples for any interference rank value as compared with ~ 2N samples for the SMI algorithm. However, the SMI algorithm requires considerably more samples to converge in the presence of outliers/targets, whereas the RMCC does not. Both simulated data as well as measured airborne radar data from the multichannel airborne radar measurements (MCARM) space-time adaptive processing (STAP) database are used to illustrate performance improvements over SMI methods.     

Identification of rational transfer function from frequencyresponse sample

A method for identifying a transfer function, H(z)=A(z)/B(z), from its frequency response values is presented. Identifying the transfer function involves determining the unknown degrees and coefficients of the polynomials A(z) and B( z), given the frequency response samples. The method for finding the parameters of the transfer function involves solving linear simultaneous equations only. An important aspect of the method is the decoupled manner in which the polynomials A(z) and B(z) are determined. The author presents two slightly different derivations of the linear equations involved, one based on the properties of divided differences and the other using Vandermonde matrices or, equivalently, Lagrange interpolation. A matrix synthesized from the given frequency response samples is shown to have a rank equal to the number of poles in the system     

CFAR data fusion center with inhomogeneous receivers

Detection systems with distributed sensors and data fusion are increasingly used by surveillance systems. A system formed by N inhomogeneous constant false alarm rate (CFAR) detectors (cell-averaging (CA) and ordered statistic (OS) CFAR detectors) is studied. A recursive formulation of an algorithm that permits a fixed level of false alarms in the data fusion center is presented, to set the optimum individual threshold levels in the CFAR receivers and the optimum `K out of N' decision rule in order to maximize the total probability of detection. The algorithm also considers receivers of different quality or with different communication channel qualities connecting them with the fusion center. This procedure has been applied to several hypothetical networks with distributed CA-CFAR and OS-CFAR receivers and for Rayleigh targets and interference, and it was seen that in general the fusion decision OR rule is not always the best     

Frequency diversity in millimeter wave satellite communications

Dual-band frequency diversity seems to be an effective fade countermeasure to rain-induced attenuation in satellite communications above 20 GHz. This method, particularly suited for satellites operating in two frequency bands, typically K_a band and C or K_u band, achieves very low levels of outage probability especially where the rain fades are severe. A theoretical analysis of a frequency diversity system is performed to evaluate the amount of reserve capacity needed to counteract fading in a satellite network. The problems that arise in implementing adaptive fade countermeasures because of the dynamic characteristics of fading are discussed, and the results of the simulations performed using the attenuation time series at 11.6 GHz, measured with the Sirio satellite throughout four years, are presented     

Nonparametric rank detectors on quantized radar video signals

Uniform randomization of ties is required for defining distribution-free ranks of independent and identically distributed quantized samples. Formulas of rank probabilities are given and applied to radar detection under quantized video samples. For some detectors, and assuming Gaussian noise, the asymptotic loss L_∞(q) is calculated versus the normalized quantization step q, and the loss L(q) is estimated by Monte Carlo simulations. Both of these resulted in monotonic functions of q (0<q<1.1) that are independent of the other parameters. Furthermore, L(q)≈L_∞(q )⩽0.45 dB, as q<0.8. The quantization step q is normalized with respect to the noise standard deviation     

A parallel square-root algorithm for modified extended Kalmanfilter

A parallel square-root algorithm and its systolic array implementation are proposed for performing modified extended Kalman filtering (MEKF). The proposed parallel square-root algorithm is designed based on the singular value decomposition (SVD) and the Faddeev algorithm, and a very large scale integration (VLSI) systolic array architecture is developed for its implementation. Compared to other square root Kalman filtering algorithms, the proposed method is more numerically stable. The VLSI architecture described has good parallel and pipelining characteristics in applying to the MEKF and achieves higher efficiency. For n-dimensional state vector estimations, the proposed architecture consists of O(2n²) processing elements and uses O ((s+17)n) time-steps for a complete iteration at each instant, in contrast to the complexity of O((s+6) n³) time-steps for a sequential implementation, where s≈log n     

Low-altitude target detection by coastline operated marine radar

Relevant to a Richian family of fluctuating targets with a composite background of sea-plus-land clutter, the performance prediction of a radar operating in near-coastal regions is elucidated by assuming noncoherent integration of the pulses. Considering the dominance of land clutter, a modified K-distributed statistic is indicated for the overall clutter envelope; and the corresponding probability of false alarm and probability of detection are deduced for fixed threshold detection (s) based on N pulses integrated in the presence of the sea-plus-land clutter and the noise. Even when the target offers a dominant scattered echo, the worst situations of the land clutter affecting the detection performance are indicated     

On the uniform sampling of a sinusoidal signal

It is generally accepted that a monochromatic signal such as sin 2πWt (W>0) must be sampled at a uniform rate greater than the ostensible Nyquist rate of 2W samples per to effect a reconstruction of the signal. It is shown that a sinusoid of frequency W Hz is completely determined by its samples taken at the uniform rate of 2r samples per second, where r>0 is arbitrary subject only to the restriction that W ≠kr for any positive integer k. In particular, a pure sinusoid may be sampled uniformly without loss of information at arbitrarily small rates     

Polar ionospheric disturbance effects on NNSS satellite positioning

From the analysis of the United States Navy navigation satellite system (NNSS) positioning data of about 10000 passes, it is clearly found that polar ionospheric disturbance affects the positioning. The positioning error increases with increasing geomagnetic disturbance level (local K-index), and the pass number of position fixes decreases by one or two per day when the K-index is large. These effects may arise from the spatial gradients of electron density and/or the radio wave scattering due to well-developed ionospheric irregularities inherent to the disturbed auroral ionosphere     

Multiple target angle tracking using sensor array outputs

The use of the output of an array of sensors to track multiple independently moving targets is reported. The output of each sensor in the array is the sum of signals received from each of the targets. The results of direction-of-arrival estimation by eigenvalue analysis are extended to derive a recursive procedure based on a matrix quadratic equation. The solution of this matrix quadratic equation is used to provide updated target positions. A linear approximation method for estimating the solution of the matrix equation is presented. The algorithm is demonstrated by the simulated tracking of two targets. The main advantage of the algorithm is that a closed-form solution for updating the target angle estimates has been obtained. Also, its application is straightforward, and the data association problem due to uncertainty in the origin of the measurements is avoided. However, it requires the inversion of an N×N as well as other linear operations, so that the computational burden becomes substantial as N becomes very large     

Periodic ambiguity function of CW signals with perfect periodicautocorrelation

A periodic ambiguity function (PAF) is discussed which describes the response of a correlation receiver to a CW signal modulated by a periodic waveform, when the reference signal in the receiver is constructed from an integral number N, of periods T, of the transmitted signal. The PAF is a generalization of the periodic autocorrelation function, to the case of non-zero Doppler shift. It is shown that the PAF of N periods is obtained by multiplying the PAF of a single period by the universal function sin(Nπν T)/N sin(πνT), where ν is the Doppler shift, to phase-modulated signals which exhibit perfect periodic autocorrelation when there is no Doppler shift. The PAF of these signals exhibits universal cuts along the delay and Doppler axes. These cuts are functions only of t, N and the number M, the modulation bits in one period     

The autocorrelation of m-sequences over nonprime finitefields

Nonbinary m-sequences (maximal length sequences) for spread-spectrum communication systems that have a two-level autocorrelation are presented. The autocorrelation function of an m -sequence over the Galois field of q elements GF(q), where q=p^k, for p a prime and k an integer greater than 1, is developed and shown to be bilevel when the elements of GF(q) are expressed as elements of a vector space over the pth roots of unity     

Cascaded detector for multiple high-PRF pulse Doppler radars

A postdetection design methodology for a multiple high-pulse-repetition frequency (PRF) pulse Doppler radar has been developed. The postdetection processor consists of an M out of N detector where range and target ambiguities are resolved, followed by a square-law detector which enhances the minimum signal-to-noise (S/N) power-ratio per pulse burst performance. For given probabilities of false alarm and detection, formulas are derived from which the three thresholds associated with the cascaded detector can be found. Fundamental tradeoffs between the minimum S/N required, number of ghosts, and the number of operations (NOPs) that the cascaded detector must perform are identified. It is shown that the NOPs and the number of ghosts increase and the minimum S/N required decreases as the binary M out of N detector passes more detections to the square-law detector