共查询到20条相似文献,搜索用时 62 毫秒
1.
2.
通过对气?固两相间动量和能量相互作用解耦处理,建立了一种适于模拟真空环境气固两相混合物羽流的DSMC双向耦合算法与固体颗粒空间输运变化特性的TPMC计算技术。仿真了固体火箭发动机两相羽流流场和固体颗粒在远离发动机喷口数十公里空间扩散运动分布特性,通过将计算结果与典型文献结果及理论分析比较确认,证实本文方法的准确可靠性。结果表明,固体颗粒对气相的扩散有一定的阻滞作用;仅在离发动机喷口一定距离,气相对固体颗粒有较大影响,致颗粒温度下降、速度增加;颗粒温度随发动机喷口距离增大而减小,一直要在远离喷口上百公里颗粒温度才随轴向位置趋于平衡,且不同尺寸的颗粒温度差别较大,对指导外层空间高真空环境气固两相羽流传输影响工程研制具有重要意义。 相似文献
3.
4.
5.
微型固体姿控发动机微喷管内气粒两相流动规律的CFD-DSMC研究 总被引:1,自引:0,他引:1
微型固体姿控发动机在航天领域具有广泛的应用前景。以基于MEMS技术的微喷管为研究对象,首先通过计算微喷管中的克努森数,得到了微喷管中的气相流动状态;然后,采用CFD-DSMC方法,模拟了微喷管中的气粒两相流动,并研究了颗粒相质量分数和粒径对气相流动的影响。结果表明,在所研究的来流条件下,微喷管中的连续介质假设是成立的;气相与颗粒相间的动量和能量交换,导致气相马赫数降低、温度升高,同时也导致颗粒相速度增加、温度降低;颗粒相质量分数和粒径均能显著影响气相的马赫数和温度。 相似文献
6.
7.
SRM点火瞬态凝相粒子对火焰传播过程的影响 总被引:3,自引:0,他引:3
以Fluent计算软件为工具、时均化N\|S方程、RNG k-ε湍流模型、P1辐射模型、颗粒 轨道模型为基础、美国“大力神4”运载火箭助推发动机PQM -1为算例,采用流固耦合传热的火焰传播边界条件,建立了二维轴对称纯气相流动和气固两 相流动模型,分析了大长径比SRM点火瞬态凝相粒子对火焰传播过程的影响。分析结果表明 ,与纯气相流动模型相比,两相流模型中凝相粒子的辐射、阻尼、拖拽等作用改变了火焰在 装药燃气通道、径向翼槽内的传播过程;两相流动模型可正确预示大长径比SRM的初始发火 点和火焰传播过程。 相似文献
8.
9.
10.
针对纳米铁基金属燃料发动机技术,建立颗粒燃烧模型与喷管两相流动控制模型,基于VC++软件自主编程,对纳米铁基金属燃料发动机喷管内颗粒相速度、颗粒温度、颗粒粒径、质量传递速率、颗粒速度滞后、温度滞后、流体密度、压强、雷诺数、马赫数、气相速度、气相温度等参数进行模拟仿真,重点研究了0.4~1.0 μm颗粒粒径和10~40凝... 相似文献
11.
金属网由于柔韧性好、使用方便等优势而在电缆屏蔽工程上得到广泛应用。本文对电缆用的金属网屏蔽效能进行工程计算,通过计算,对金属网不同材料、不同规格、单层与双层屏蔽及有缝隙情况下的屏蔽效能进行比较与分析,对工程应用有一定的指导意义。 相似文献
12.
为满足航天器微振动环境模拟的需要,开展了多自由度微振动时域波形复现控制方法研究。首先,介绍了基于时域波形复现的多自由度微振动环境模拟控制理论方法。其次,针对六自由度微振动激励系统,应用MATLAB软件建立了基于实测传递函数矩阵的多输入多输出微振动激励仿真系统,针对微振动时域波形复现闭环控制过程进行了算法编程,并给出了仿真的闭环控制流程图。最后,通过算例对多自由度微振动时域波形复现进行了数值仿真,以给定的白噪声为输入,模拟对实际存在的系统非线性、测量误差等影响因素的控制效果。仿真结果验证了多自由度微振动时域波形复现控制方法的可行性及有效性,所得结论可以为研究多自由度微振动时域波形复现控制系统提供参考。 相似文献
13.
14.
15.
16.
17.
O. V. Kholostova 《Cosmic Research》2008,46(3):264-272
In a central Newtonian gravitational field, the motion of a dynamically symmetrical satellite along an elliptical orbit of arbitrary eccentricity is considered. The particular motion of the satellite is known when its axis of symmetry is perpendicular to the orbit plane, and the satellite rotates about this axis with a constant angular velocity (cylindrical precession). A nonlinear analysis of stability of this motion has been performed under the assumption that the geometry of the satellite mass corresponds to a thin plate. At small values of orbit eccentricity e the analysis is analytical, while numerical analysis is used for arbitrary values of e. 相似文献
18.
工质粘性对两股射流撞击雾化特性影响试验研究 总被引:2,自引:0,他引:2
为揭示工质粘性对两股射流撞击雾化特性的影响规律,在大气开放环境下开展了不同粘度系数工质的射流撞击雾化试验。由相位多普勒粒子分析仪(PDPA)测量了撞击点下游10 mm,20 mm,30 mm与40 mm平面位置处液滴的粒径分布和速度分布等信息。试验结果表明:粘度系数增大,雾场某点处的液滴粒径有增大的趋势,运动速度有减小的趋势;雾场液滴粒径达到平衡状态时与撞击点的距离将会增加;撞击点下游某一平面的液滴平均运动速度将会减小;当粘度系数一定时,距离撞击点越远,该平面的液滴平均运动速度越小。 相似文献
19.
S. A. Zelepugin A. A. Konyaev V. N. Sidorov I. E. Khorev V. K. Yakushev 《Cosmic Research》2008,46(6):529-539
We present the results of comprehensive experimental and theoretical investigations of encounter with a barrier of a group of bodies thrown with a high-velocity. Throwing of a group of particles (from two to twelve bodies) was realized on a ballistic route using powder and light-gas units of different calibers in the range of velocities 500–3500 m/s. The process of particle throwing was controlled by acting aerodynamic forces. In experiments on collisions with barriers of a finite thickness (which imitates the protective shield of spacecraft) the number of particles in a homogeneous stream was varied from 2 to 7 at changing the flux density (distances between particles). Experimental data are obtained on variations of the area and mass of back-surface splinters. Numerical calculations simulated a knock of 2 to 4 particles against a barrier in the cases of normal impact and at an angle. The calculations were performed in three-dimensional formulation and applying criteria of complete destruction of material. The appearance of additional destruction centers in the barrier due to mutual influence of particles is revealed. Simple criteria are obtained for estimating the degree of interference of particles and the character of barrier destruction. 相似文献