Single event upset investigations on the “Flying Laptop” satellite mission

The radiation effects in electronic parts are called single-event effects, which are deemed to be critical for space missions. This paper presents the Single Event Upsets that were observed in an onboard memory device of the Low Earth Orbit “Flying Laptop” satellite mission during its in-orbit operation. The Single Event Upsets were carefully mapped on the satellite orbital space itself and their root causes were investigated together with their rates of occurrence. Subsequently, the events were traced to show several root cause sources such as (i) trapped energetic protons leaking to low altitudes within the South Atlantic Anomaly, (ii) Solar Energetic Particles emitted by an impulsive event on 10 September 2017, and (iii) Galactic Cosmic Rays. A profound analysis was carried out on the observed flight data, and its corresponding results are actually in agreement with the standard energetic particle models. The presented results provide another important insight on the Single Event Upsets for future Low Earth Orbit satellite missions.     

The future role of relay satellites for orbital telerobotics

Orbital robotics focuses on a variety of applications, as e.g. inspection and repair activities, spacecraft construction or orbit corrections. On-Orbit Servicing (OOS) activities have to be closely monitored by operators on ground. A direct contact to the spacecraft in Low Earth Orbit (LEO) is limiting the operational time of the robotic application. Therefore, geostationary satellites are desirable to relay the OOS signals and extend the servicing time window. A geostationary satellite in the communication chain not only introduces additional boundary conditions to the mission but also increases the time delay in the system. The latter is not very critical if the servicer satellite is operating autonomously. However, if the servicer is operating in a supervised control regime with a human in the loop, the increased time delay will have an impact on the operator’s task performance.     

A study of reaction wheel configurations for a 3-axis satellite attitude control

The satellite reaction wheel’s configuration plays also an important role in providing the attitude control torques. Several configurations based on three or four reaction wheels are investigated in order to identify the most suitable orientation that consumes a minimum power. Such information in a coherent form is not summarized in any publication; and therefore, an extensive literature search is required to obtain these results. In addition, most of the available results are from different test conditions; hence, making them difficult for comparison purposes. In this work, the standard reaction wheel control and angular momentum unloading schemes are adopted for all the reaction wheel configurations. The schemes will be presented together with their governing equations, making them fully amenable to numerical treatments. Numerical simulations are then performed for all the possible reaction wheel configurations with respect to an identical reference mission. All the configurations are analyzed in terms of their torques, momentums and attitude control performances. Based on the simulations, the reaction wheel configuration that has a minimum total control torque level is identified, which also corresponds to the configuration with minimum power consumption.     

H2 and H∞ control options for the combined attitude and thermal control system (CATCS)

The combined attitude and thermal control system (CATCS) combines the conventional attitude control and thermal control subsystems. Its principle is based on circulating a heat conducting fluid inside a closed duct wielding the excess onboard heat in order to produce the attitude control torques. Previously only the proportional-integral (PI) controller has been tested for CATCS. In this paper two other control options for CATCS were designed based on the H₂ and H_∞ control methods to improve the attitude control performance of a small satellite. The control gain matrix with the minimum cost function is obtained by solving the Riccati equation and fed back to the system in order to achieve the system’s performance. The designed controllers can efficiently control the roll, pitch and yaw satellite attitudes. Simulations for the two techniques were carried out using Matlab and Simulink for ideal and non-ideal system models. Results show that the H₂ controller has a better attitude control performance over the H_∞ controller and PI controller itself.     

Two degree-of-freedom spacecraft attitude controller

Two degree-of-freedom controller is designed together with its governing equations for a spacecraft pitch attitude control. The attitude controller incorporates the Active Force Control (AFC) technique into the conventional Proportional-Derivative (PD) controller based spacecraft pitch attitude loop. The PD-AFC attitude controller is then employed to enhance the attitude pointing of the Combined Energy and Attitude Control System (CEACS). Numerical treatments are performed to validate the effectiveness of AFC, whereby the CEACS attitude performance is analysed from its accuracy point of view. The results show that the PD-AFC attitude control performance is superiorly better than that of the solely conventional PD type.     

Attitude pointing enhancement for combined energy and attitude control system

This paper extends the previous works that appeared in Acta Astronautica. An approach that incorporates the Active Force Control (AFC) technique into a conventional Proportional-Derivative (PD) controller is proposed for a 50 kg small satellite. Numerical treatments are performed to validate the effectiveness of AFC. The attitude control capability of the combined energy and attitude control system (CEACS) is expected to improve. The result shows an important attitude pointing enhancement for the CEACS attitude control task.