Ground Compatibility Tests for Gravity Measurement of SELENE: Accuracies of Two- and Four-Way Doppler and Range Measurements

The Japanese lunar mission Selenological and Engineering Explorer (SELENE) was launched in September 2007 and continued its mission until June 2009, when the main orbiter impacted with the surface of the Moon. SELENE consisted of three satellites: Main, Rstar, and Vstar. Rstar’s tasks were to forward up-link signals from the Usuada Deep Space Center (UDSC) to Main, and to down-link returning signals from Main to UDSC. We refer to this tracking sub-system as a four-way Doppler measurement. In contrast, conventional tracking systems between Rstar and UDSC as well as between Main and ground stations are referred to as two-way Doppler and range measurements. Using Main and Rstar, we successfully observed the gravity field over the farside of the Moon. Because four-way Doppler measurements via a relay sub-satellite were a fundamental experiment in space for Japanese space agencies, compatibility of radiometric instruments onboard Main and Rstar to UDSC were carefully examined at the UDSC using components manufactured for flight models. These tests not only proved the feasibility of the four-way Doppler measurements but also provided biases and variations of the four-way Doppler and two-way Doppler and range measurements that were later taken into account during the processing of tracking data and the analysis of the lunar global gravity field.     

Biodosimetry of heavyions by interphase chromosome painting

We report measurements of chromosomal aberrations in peripheral blood lymphocytes from cancer patients undergoingradiotherapy treatment. Patients with cervix or esophageal cancer were treated with 10 MV X-rays produced at a LINAC accelerator, or high-energy carbon ions produced at the HIMAC accelerator at the National Institute for Radiological Sciences (NIRS) in Chiba. Blood samples were obtained before, during, and after the radiation treatment. Chromosomes were prematurely condensed by incubation in calyculin A. Aberrations in chromosomes 2 and 4 were scored after fluorescence in situ hybridization with whole-chromosome probes. Pre-treatment samples were exposed in vitro to X-rays, individual dose-response curves for the induction of chromosomal aberrations were determined, and used as calibration curves to calculate the effective whole-body dose absorbed during the treatment. This calculated dose, based on the calibration curve relative to the induction of reciprocal exchanges, has a sharp increase after the first few fractions of the treatment, then saturates at high doses. Although carbon ions are 2–3 times more effective than X-rays in tumor sterilization, the effective dose was similar to that of X-ray treatment. However, the frequency of complex-type chromosomal exchanges was much higher for patients treated with carbon ions than X-ray.     

Ballooning activities in Japan

The Scientific Balloon Center of ISAS/JAXA has carried out two balloon campaigns at Sanriku, Iwate, Japan every year. Ten to twelve balloon vehicles are launched annually for scientific and engineering experiments. Since 2005, a Brazilian balloon campaign has also been conducted in cooperation with INPE. In the 2006 Brazilian campaign, large and heavy payloads up to 1500 kg for astronomy will be launched. New generation balloons, such as super-pressure balloons and high-altitude balloons with ultra-thin films, are being developed. The current status and prospect of the Japanese scientific ballooning are discussed.     

Surface Composition of Vesta: Issues and Integrated Approach

The instruments on the Dawn spacecraft are exceptionally well suited to characterize and map the surface composition of Vesta in an integrated manner. These include a framing camera with multispectral capabilities, a high spectral resolution near-infrared imaging spectrometer, and a gamma-ray and neutron spectrometer. Three examples of issues addressed at Vesta are: (1) What is the composition of Vesta??s interior and differentiation state as exposed by the Great South Crater? (2) How has space weathering affected Vesta, both globally and at a local scale? and (3) Are volatiles or hydrated material present on Vesta??s surface? We predict that Dawn finds many surprises, such as an olivine-bearing mantle exposed near the south-pole, a weakly or un-weathered surface that has been relatively recently resurfaced, and a very thin layer of surficial volatiles derived from interaction with the solar wind.     

Deriving the Absolute Reflectance of Lunar Surface Using SELENE (Kaguya) Multiband Imager Data

The absolute reflectance of the Moon has long been debated because it has been suggested (Hillier et al. in Icarus 151:205–225, 1999) that there is a large discrepancy between the absolute reflectance of the Moon derived from Earth-based telescopic data and that derived from remote-sensing data which are calibrated using laboratory-measured reflectance spectra of Apollo 16 bulk soil 62231. Here we derive the absolute reflectance of the lunar surface using spectral data newly acquired by SELENE (Kaguya) Multiband Imager and Spectral Profiler. The results indicate that the reflectance of the Apollo 16 standard site, which has been widely used as an optical standard in previous Earth-based telescopic and remote-sensing observations derived by Multiband Imager, is 47% at 415 nm and 67% to 76% at 750 to 1550 nm of the value for the Apollo 16 mature soil measured in an Earth-based laboratory. The data also suggest that roughly 60% of the difference is caused by the difference in soil composition and/or maturity between the 62231 sampling site and the Apollo 16 standard site and that the remaining 40% difference can be explained by the difference between the compaction states of the laboratory and the actual lunar surface. Consideration of the compaction states of the surface soil demonstrates its importance for understanding the spectral characteristics of the lunar surface. We also explain and evaluate data analysis procedures to derive reflectance from Multiband Imager data.     

Analytical expression for distant retrograde orbits around a small natural satellite

An analytical expression for distant retrograde orbits (DROs) is obtained in this study. Owing to the fact that a planar DRO is a closed orbit and can be expressed as an approximately elliptical orbit, respective geometries and periods of DROs are analytically calculated. A switching point, where various properties of planar DROs change abruptly with an increase in the orbital radius, is determined. The Mars–Deimos system is taken as a case study in this work. The proposed method can be applied to cases where the Hill’s approximation of the restricted three-body problem is valid. Numerical calculations are performed to validate the proposed method.     

Physical assessment of coastal vulnerability under enhanced land subsidence in Semarang,Indonesia, using multi-sensor satellite data

Research has been conducted in Semarang, Indonesia, to assess coastal vulnerability under enhanced land subsidence using multi-sensor satellite data, including the Advanced Land Observing Satellite (ALOS) Phased Array type L-band SAR (PALSAR), Landsat TM, IKONOS, and TOPEX/Poseidon. A coastal vulnerability index (CVI) was constructed to estimate the level of vulnerability of a coastline approximately 48.68?km in length using seven physical variables, namely, land subsidence, relative sea level change, coastal geomorphology, coastal slope, shoreline change, mean tidal range, and significant wave height. A comparison was also performed between a CVI calculated using seven parameters and a CVI using six parameters, the latter of which excludes the land subsidence parameter, to determine the effects of land subsidence during the coastal vulnerability assessment. This study showed that the accuracy of coastal vulnerability was increased 40% by adding the land subsidence factor (i.e., CVI 6 parameters?=?53%, CVI 7 parameters?=?93%). Moreover, Kappa coefficient indicated very good agreement (0.90) for CVI 7 parameters and fair agreement (0.3) for CVI 6 parameters. The results indicate that the area of very high vulnerability increased by 7% when land subsidence was added. Hence, using the CVI calculation including land subsidence parameters, the very high vulnerability area is determined to be 20% of the total coastline or 9.7?km of the total 48.7?km of coastline. This study proved that land subsidence has significant influence on coastal vulnerability in Semarang.     

Progress of super-pressure balloon development: A new “tawara” concept with improved stability

The super-pressure balloon (SPB) has been expected to be a flight vehicle that can provide a long flight duration to science. Since 1997, we have developed the SPB. Now we are at the phase of developing an SPB of a practical size. In 2009, we carried out a test flight of a pumpkin-shaped SPB with a 60,000 m³ volume. The undesirable result of this flight aroused us to resolve the deployment instability of the pumpkin-shaped SPB, which has been known as one of the most challenging issues confronting SPB development. To explore this deployment issue, in 2010, we carried out a series of ground tests. From results of these tests, we found that an SPB design modified from pumpkin, named “tawara”, can be a good candidate to greatly improve the deployment stability of the lobed SPB.     

A challenge to the highest balloon altitude

Development of a balloon to fly at higher altitudes is one of the most attractive challenges for scientific balloon technologies. After reaching the highest balloon altitude of 53.0 km using the 3.4 μm film in 2002, a thinner balloon film with a thickness of 2.8 μm was developed. A 5000 m³ balloon made with this film was launched successfully in 2004. However, three 60,000 m³ balloons with the same film launched in 2005, 2006, and 2007, failed during ascent. The mechanical properties of the 2.8 μm film were investigated intensively to look for degradation of the ultimate strength and its elongation as compared to the other thicker balloon films. The requirement of the balloon film was also studied using an empirical and a physical model assuming an axis-symmetrical balloon shape and the static pressure. It was found that the film was strong enough. A stress due to the dynamic pressure by the wind shear is considered as the possible reason for the unsuccessful flights. A 80,000 m³ balloon with cap films covering 9 m from the balloon top will be launch in 2011 to test the appropriateness of this reinforcement.     

GRACE accelerometer calibration by high precision non-gravitational force modeling

The precise modeling and knowledge of non-gravitational forces acting on satellites is of big interest to many scientific tasks and missions. Since 2002, the twin GRACE satellites have measured these forces in a low Earth orbit with highly precise accelerometers, for about 15?years. Besides the significance for the GRACE mission, these measurement data allow the evaluation of modeling approaches and the improvement of force models. Unfortunately, before any scientific usage, the accelerometer measurements need to be calibrated, namely scale factor and bias have to be regularly estimated.In this study we demonstrate an accelerometer calibration approach, solely based on high precision non-gravitational force modeling without any use of empirically or stochastically estimated parameters, using our in-house developed satellite simulation tool XHPS. The aim of this work is twofold, first we use the accelerometer data and the residuals resulting from the calibration to quantitatively analyze and validate different non-gravitational force model approaches. In a second step, we compare the calibration results to three different calibration methods from different authors, based on gravity field recovery, GPS-based precise orbit determination, and based on modeled accelerations.We consider atmospheric drag forces and winds, as well as radiation forces due to solar radiation pressure, albedo, Earth infrared and thermal radiation (TRP) of the satellite itself. For TRP, we investigate different transient temperature calculation approaches for the satellite surfaces with absorbed power from the aforementioned radiation sources. A detailed finite element model of the satellite is utilized for every force, considering orientation, material properties and shadowing conditions for each element.For cross-track and radial direction, which are mainly affected by the radiative forces, our calibration residuals are quite small when drag is not super dominant (1–3?$\text{nm}/{\text{s}}^2$ for total accelerations around $\pm$50?$\text{nm}/{\text{s}}^2$). For these directions the calibration seems to perform better than the other compared methods, where some bigger differences were found. For the drag dominated along-track direction it is vice versa, here our method is not sensitive enough because the difference between modeled and measured drag is bigger (e.g. residuals around 10?$\text{nm}/{\text{s}}^2$ for total accelerations around $\pm$70?$\text{nm}/{\text{s}}^2$ for low solar activity). In along-track direction the orbit determination based methods are more sensitive and produce more reliable results. Results for the complete GRACE mission time span from 2003 to 2017 are shown, covering different seasonal environmental conditions.