Study of ionospheric D region changes during solar flares using MF radar measurements

During solar flares, the X-ray radiation suddenly increases, resulting in an increase in the electron density of the atmospheric D region and a strong absorption of short-wave radio waves. Based on Langfang medium frequency (MF) radar, this paper analyzed the variation characteristics of D region in the lower ionosphere from 62 km to 82 km. The analysis focused on multiple C-level and M-level solar flare events before and after the large-scale flare event at 11:53 (UT) on September 6, 2017. The results show that it is difficult to detect the electron density over 70 km in Langfang during solar flares, but the electron density value can be obtained as low as 62 km, and the stronger the flare intensity, the lower the detectable electron density height. Besides, the equal electron density height, the received power of X and O waves will also be significantly reduced during the flares, and the reduction of equal electron density height has a weak linear relationship with flare intensity.     

Scientific objectives and payloads of Tianwen-1, China’s first Mars exploration mission

This paper describes the scientific objectives and payloads of Tianwen-1, China’s first exploration mission to Mars. An orbiter, carrying a lander and a rover, lifted-off in July 2020 for a journey to Mars where it should arrive in February 2021. A suite of 13 scientific payloads, for in-situ and remote sensing, autonomously commanded by integrated payload controllers and mounted on the orbiter and the rover will study the magnetosphere and ionosphere of Mars and the relation with the solar wind, the atmosphere, surface and subsurface of the planet, looking at the topography, composition and structure and in particular for subsurface ice. The mission will also investigate Mars climate history. It is expected that Tianwen-1 will contribute significantly to advance our scientific knowledge of Mars.     

某航天器输氢管道系统结构完整性评估

为保障某航天器在服役年限内不发生事故，针对航天器上采用插入焊接技术的精密管道系统进行结构完整性评估。在考虑到系统存在整圈的环形未焊透缺陷基础上，结合工程实践，假设在焊接区域存在更危险的平面缺陷。首先，开展高压气相热充氢试验下的标准拉伸和三点弯试验得到管道系统材料"J-75"在临氢环境下应力应变曲线和断裂韧性。其次，采用有限元程序计算系统在内压、惯性载荷与离面位移作用下的应力分布，考虑到间隙配合中的不确定性，改变模型中的最大间隙多次模拟计算，发现最大应力位置基本不变，以此区域作为假想缺陷的具体萌生区域。最后，采用失效评估图（FAD）方法对存在4种缺陷模式的系统分别进行结构完整性评估。通过引入安全裕度的概念，发现系统在含有初始尺寸（0.15 mm）的4种平面缺陷时，均处于安全状态，并且安全裕度都在2倍以上；通过工程临界分析（ECA）发现随着缺陷尺寸的增大，系统中含有缺陷2（位于管道焊接区域最大应力处的轴对称平面且沿焊深方向扩展的缺陷）时最为危险，且当缺陷深度超过0.61 mm时将断裂失效；考虑到测试数据的弥散性，针对系统最危险的模式，以安全裕度为可靠性指标，将失效评估图方法与可靠性评价相结合，得到系统在含有尺寸为0.15 mm的缺陷2情况下保有足够安全裕度的可靠性下限值超过0.999 5。     

过氧化氢/紫外线/臭氧氧化技术处理肼类污水的应用

采用放大试验规模（处理量1 m³/h）的H₂O₂（过氧化氢）/UV（紫外线）/O₃（臭氧）氧化技术处理肼类推进剂污水，在30.0±1.6 ℃，pH=9.0±0.2的条件下，研究肼类的过氧化氢增强光解臭氧化降解。对比不同氧化技术的协同效应以及对污水降解的影响，重点考察过氧化氢、紫外线、臭氧和初始浓度等工艺参数对降解效果的影响，对氧化技术的应用进行了优化。研究结果表明：该技术可使COD去除率提高27.66%，肼类的降解速率随着过氧化氢投加量、紫外线辐射强度、O₃投加速率和水质地提高而升高，随着初始质量浓度的提高而下降。在最佳工艺下，处理5 000 mg/L质量浓度的废水，处理60 min时，COD去除率分别为98.62%（偏二甲肼）、99.17%（甲基肼）、99.94%（肼）和93.25%（单推-3）。     

联邦学习安全与隐私保护综述

联邦学习是一种新型的分布式学习框架，它允许在多个参与者之间共享训练数据而不会泄露其数据隐私。但是这种新颖的学习机制仍然可能受到来自各种攻击者的前所未有的安全和隐私威胁。本文主要探讨联邦学习在安全和隐私方面面临的挑战。首先，本文介绍了联邦学习的基本概念和威胁模型，有助于理解其面临的攻击。其次，本文总结了由内部恶意实体发起的3种攻击类型，同时分析了联邦学习体系结构的安全漏洞和隐私漏洞。然后从差分隐私、同态密码系统和安全多方聚合等方面研究了目前最先进的防御方案。最后通过对这些解决方案的总结和比较，进一步讨论了该领域未来的发展方向。     

Parametric Modeling of Circuit Model for AC Glow Discharge in Air

In the parametric modeling of the circuit model for glow discharge in air,a new method for the design of glow discharge circuit model is presented.The new circuit model is an important reference for the design of plasma power supply,the simulation of glow discharge plasma actuator and the simulation of glow discharge plasma anemometer.The modeling approach consists in developing an electrical model of the glow discharge in air based on circuit components.The structure of the circuit model is established according to the theoretical analysis and the experimental device.Then the parameters of the circuit model are obtained based on the circuit analysis.Finally,the circuit model is verified by comparing the simulation current with the experimental current.This model takes into account the whole framework of the air glow discharge including the sheath and the plasma area.The built circuit model is feasible and reliable,thus being instructive for the investigation of the glow discharge in air.     

Aircraft Engine Gas Path Fault Diagnosis Based on Hybrid PSO-TWSVM

Twin support vector machine(TWSVM)is a new development of support vector machine(SVM)algorithm.It has the smaller computation scale and the stronger ability to cope with unbalanced problems.In this paper,TWSVM is introduced into aircraft engine gas path fault diagnosis.The generalization capacity of Gauss kernel function usually used in TWSVM is relatively weak.So a mixed kernel function is used to improve performance to ensure that the TWSVM algorithm can better balance a strong generalization ability and a good learning ability.Experimental results prove that the cross validation training accuracy of TWSVM using the mixed kernel function averagely increases 2%.Grid search is usually applied in parameter optimization of TWSVM,but it heavily depends on experience.Therefore,the hybrid particle swarm algorithm is introduced.It can intelligently and rapidly find the global optimum.Experiments prove that its training accuracy is better than that of the classical particle swarm algorithm by 5%.     

捆绑火箭POGO振动动力学模型的研究

确定了捆绑火箭POGO振动动力学模型中蓄压器的最佳安装位置,简化了液体捆绑火箭动力学模型。基于AMESim软件搭建捆绑火箭动力学仿真模型,分析了蓄压器的安装位置对捆绑火箭POGO振动系统的系统阻尼比的影响,以及贮箱、直管、泵和推力室产生的作用力对系统阻尼比的影响。结果表明:蓄压器安装在芯级氧路和助推氧路的系统阻尼比提升最大,POGO振动的抑制效果最好;推力室产生的作用力对系统阻尼比的影响占主导地位,故仅需考虑推力室产生的作用力,以简化捆绑火箭POGO振动动力学模型。该研究可应用于POGO振动的仿真过程。     

超大口径环形天线包带展开过程动力学仿真

中间柔性包带是环形可展开天线的重要组成部分。中间包带拔销器解锁后，复材包带与环形桁架同步展开。因复材包带柔性较强，它会绕根部固定端进行回弹，因此展开过程存在金属接头和桁架上复材薄壁管件碰撞风险。随着天线口径增大，该风险会持续增大。基于柔性多体动力学理论对超大型口径环形可展开天线包带展开过程进行动力学建模仿真，并在此基础上分析得出包带展开过程金属接头到环形桁架最小距离主要和复材包带阻尼率以及桁架预展速度相关。通过进一步研究发现：复材包带阻尼率越高，展开过程金属接头到环形桁架最小距离越大；桁架预展速度越快，展开过程金属接头到环形桁架最小距离越小。此外，对逆止回弹机构失效这一在轨极端条件下包带展开过程进行建模仿真，分析得出包带在该条件下展开过程金属接头到环形桁架最小距离变化规律。该研究可为超大口径环形天线结构优化设计及包带在轨展开预示提供依据。