风扇进口噪声预测模型的改进

针对Heidmann模型对风扇进口低频噪声(1k Hz)预测结果偏低的情况,通过引入风扇叶尖弦长雷诺数和相关几何参数改进了Heidmann模型中风扇进口宽频噪声的频谱修正函数,确定了其中频谱修正系数为0.085。对比改进模型和Heidmann模型的风扇进口噪声预测结果发现:在亚声速工况下,改进的模型很好地改善了风扇进口低频噪声的预测结果,改进幅值可以达到约45d B;而在超声速工况下,由于风扇进口产生的组合单音噪声成为风扇进口噪声的主要组成部分,除了在小于100Hz的频域内,改进的模型与Heidmann模型的预测结果差别不大。     

对统计MIMO雷达的噪声调频干扰功率分配研究

简要介绍多输入多输出雷达的信号模型及其目标检测方式,并针对其信号的独特形式在传统噪声调频的基础上提出一种改良的噪声调频干扰方式,进而通过仿真证明此改良干扰方式的有效性.     

Investigations into sensing characteristics of circular thin-plate electrostatic sensors for gas path monitoring

Circular thin-plate electrostatic sensors are promising in gas path monitoring due to their advantages of non-intrusiveness and easy installation. The spatial sensitivity and filtering effect are two important performance parameters. In this paper, an analytically mathematical model of induced charge on a circular thin-plate electrode is first derived. Then the spatial sensitivity and filtering effect of the circular electrostatic sensor are investigated by numerical calculations. Finally,experimental studies are performed to testify the theoretical results. Both theoretical and experimental results demonstrate that circular thin-plate electrostatic sensors act as a low-pass filter in the spatial frequency domain, and both the spatial filtering effect and the temporal frequency response characteristics depend strongly on the spatial position and velocity of the charged particle. These conclusions can provide guidelines for the optimal design of circular thin-plate electrostatic sensors.     

一种基于机动辨识预测的空空导弹导引律

现有的空空导弹导引头在有噪声和干扰的环境下获得目标精确信息存在时间延迟,且新一代目标的机动能力更强,不对导弹加以补偿会造成较大脱靶量,所以需对目标状态有效预测。针对新一代目标规避空空导弹常用的大机动模式,为满足新一代空空导弹发展需求,设计了一种新型复合导引律。从目标自身出发,研究高机动目标规避导弹采用的典型机动形式,对机动轨迹进行离线建模,构建具有扩展能力的目标机动模型库。设计自适应滤波器对测量噪声进行降噪。同时,利用模型库设计了机动辨识预测器,对目标实际机动进行在线辨识。基于在线辨识的结果对目标机动进行预测,并对时间延迟进行补偿和修正,实现对高机动目标的精确打击。仿真结果表明:该方法对不同类型的机动目标均有较高的预测精度和命中精度。     

Noise analysis of continuous GPS coordinate time series for CMONOC

The Crustal Movement Observation Network of China (CMONOC) is one of the major scientific infrastructures, mainly using Global Positioning System (GPS) measurements, to monitor crustal deformation in the Chinese mainland. In this paper, decade-long coordinate time series of 26 continuous GPS sites of CMONOC are analyzed for their noise content using maximum likelihood estimation (MLE). We study the noise properties of continuous GPS time series of CMONOC for the unfiltered, filtered solutions and also the common mode signals in terms of power law plus white noise model. In the spatial filtering, we remove for every time series a common mode error that was estimated from a modified stacking of position residuals from other sites within ∼1000 km of the selected site. We find that the common mode signal in our network has a combination of spatially correlated flicker noise and a common white noise with large spatial extent. We demonstrate that for the unfiltered solutions of CMONOC continuous GPS sites the main colored noise is a flicker process, with a mean spectral index of ∼1. For the filtered solutions, the main colored noise is a general power law process, indicating that a major number of the filtered regional solutions have a combination of noise sources or local effects. The velocity uncertainties from CMONOC continuous GPS coordinate time series may be underestimated by factors of 8–16 if a pure white noise model is assumed. In addition, using a white plus flicker noise model, the median values of velocity errors for the unfiltered solutions are 0.16 (north), 0.17 (east) and 0.58 (vertical) mm/yr, and the median values for the filtered solutions are 0.09 (north), 0.10 (east) and 0.40 (vertical) mm/yr.     

CCD信号采样位置选取方法的研究

针对CCD输出信号中的复位噪声,文章介绍了处理复位噪声较为常用的方法--相关双采样技术,并对相关双采样技术中采样位置选取的方法进行分析和研究,最后进行了实验验证.结果表明:用文中方法选取的采样位置进行相关双采样,可以较好的减小CCD输出信号中复位噪声的影响,提高信噪比.     

空客A320飞机驾驶舱异响故障的排除

针对航线维护中一起不寻常的驾驶舱啸叫故障,参考空客公司的建议,结合实际航线维护经验,总结出系列驾驶舱异常噪声故障的可能来源,对类似故障的排除和隔离具有一定的参考意义。     

An artificial neural network approach for aerodynamic performance retention in airframe noise reduction design of a 3D swept wing model

With the progress of high-bypass turbofan and the innovation of silencing nacelle in engine noise reduction, airframe noise has now become another important sound source besides the engine noise. Thus, reducing airframe noise makes a great contribution to the overall noise reduction of a civil aircraft. However, reducing airframe noise often leads to aerodynamic perfor-mance loss in the meantime. In this case, an approach based on artificial neural network is intro-duced. An established database serves as a basis and the training sample of a back propagation (BP) artificial neural network, which uses confidence coefficient reasoning method for optimization later on. Then the most satisfactory configuration is selected for validating computations through the trained BP network. On the basis of the artificial neural network approach, an optimization pro-cess of slat cove filler (SCF) for high lift devices (HLD) on the Trap Wing is presented. Aerody-namic performance of both the baseline and optimized configurations is investigated through unsteady detached eddy simulations (DES), and a hybrid method, which combines unsteady DES method with acoustic analogy theory, is employed to validate the noise reduction effect. The numerical results indicate not merely a significant airframe noise reduction effect but also excel-lent aerodynamic performance retention simultaneously.     

某型客车噪声源的测试与研究

本文通过对某型客车的噪声测试分析，识别出该型客车的主要噪声源，为进一步采取有效的降噪措施提供了必要依据。     

舰载飞机自动着舰系统设计方法

研究了舰载飞机自动着舰系统（ACLS）的综合设计方法，其中包括油门系统、姿态控制、ACLS控制律、雷达噪声滤波和甲板运动补偿的设计方法。并对ACLS进行了仿真。