Nutation instability of spinning solid rocket motor spacecraft

The variation of mass,and moment of inertia of a spin-stabilized spacecraft leads to concern about the nutation instability.Here a careful analysis on the nutation instability is performed on a spacecraft propelled by solid rocket booster (SRB).The influences of specific solid propellant designs on transversal angular velocity are discussed.The results show that the typical SRB of End Burn suppresses the non-principal axial angular velocity.On the contrary,the frequently used SRB of Radial Burn could amplify the transversal angular velocity.The nutation instability caused by a design of Radial Burn could be remedied by the addition of End Burn at the same time based on the study of the combination design of both End Burn and Radial Burn.The analysis of the results proposes the design conception of how to control the nutation motion.The method is suitable to resolve the nutation instability of solid rocket motor with complex propellant patterns.     

再入飞行器自适应最优姿态控制

针对再入飞行器姿态控制问题，应用自适应动态规划（ADP）理论设计了姿态控制器。将再入飞行器的姿态控制建模为非线性系统的最优控制问题，提出单网络积分型强化学习（SNIRL）算法进行求解，该算法简化了积分型强化学习（IRL）算法在迭代计算中的执行-评价双网络结构，只需要采用评价网络估计值函数就可以求得最优控制律，其收敛性得到了理论证明。基于SNIRL算法设计了自适应最优控制器，并证明了闭环系统的稳定性。通过数值仿真校验了SNIRL算法比IRL算法计算效率更高，收敛速度更快，并校验了自适应最优姿态控制器的有效性 。     

基于深度学习的组合体航天器模型预测控制

利用模型预测算法先预测控制结果后控制的类人行为特点，借助深度学习在多参数寻优上的优势，提出了一种基于卷积神经网络的模型预测控制算法，满足航天工程低硬件需求，实现组合航天器多场景下姿态控制律的重构。该算法首先利用模型预测控制将组合航天器从初始状态控制到预期状态，然后将控制过程中状态量用于3层3核卷积神经网络的训练，训练完成后，用该卷积神经网络代替模型预测对组合航天器进行控制，从而降低计算资源需求。仿真校验表明：该算法可预测5个控制周期内的控制参数，相比传统模型预测算法所需硬件计算时间降低约5倍，在一般硬件环境下30 s内即可完成各场景下的组合航天器姿态控制，控制精度在10 -4 量级。     

基于超静定配平的机动载荷控制风洞试验

介绍了俯仰机动载荷减缓(MLA)在某运输类飞机缩比风洞试验模型上的应用,旨在通过风洞试验研究一种基于超静定配平原理的机动载荷控制方法。首先,对模型飞机纵向超静定配平方法进行了研究并从理论上揭示通过其减缓机动载荷的基本原理;然后,依据超静定配平原理设计了MLA控制律,通过反馈模型飞机等效过载驱动副翼偏转减小机翼载荷,同时偏转升降舵来保持飞机的俯仰机动性能;最后,依次实施了超静定配平试验,气动伺服弹性稳定性试验以及机动载荷减缓试验,分别用以确定MLA控制律参数,检查控制系统稳定性以及获取俯仰机动时的系统响应。试验结果表明:在MLA控制律作用下,机翼根部弯矩增量比MLA控制律关闭时减小了10%以上,而模型飞机的俯仰机动性能基本保持不变;MLA控制律的加入使控制增稳系统稳定性略有下降;通过超静定配平试验确定MLA控制参数的方法有效提升了MLA控制律设计可靠性,使翼根弯矩减缓量接近目标值。研究工作为运输类飞机的机动载荷控制设计与试验提供了一种可行途径。     

自主机动条件下的实时定轨方法

中继卫星在跟踪自主机动用户目标时,由于机动轨道未知,需要利用中继卫星下传的星载GNSS(Global Navigations Satellite System,全球导航卫星系统)数据进行实时轨道确定与预报,为中继卫星跟踪提供实时的引导信息,以方便中继卫星快速捕获目标和连续稳定跟踪。针对该类用户目标的任务需求,讨论了基于星载GNSS数据自主机动条件下的实时定轨方法,建立了连续推力机动力学模型。以某一型号卫星的实测数据进行分析验证,并对轨道机动进行辨识,计算的机动加速度和机动时间与试验单位提供的结果一致。针对卫星不同机动情况,5min的观测数据定轨预报10min的弧段,最大位置误差小于8km,可以为中继卫星快速捕获提供高精度的引导信息。     

A new steering approach for VSCMGs with high precision

A new variable speed control moment gyro (VSCMG) steering law is proposed in order to achieve higher torque precision. The dynamics of VSCMGs is established, and two work modes are then designed according to command torque:control momentum gyro (CMG)/reaction wheel (RW) hybrid mode for the large torque case and RW single mode for the small. When working in the CMG/RW hybrid mode, the steering law deals with the gimbal dead-zone nonlinearity through compensation by RW sub-mode. This is in contrast to the conventional CMG singularity avoidance and wheel speed equalization, as well as the proof of definitely hyperbolic singular property of the CMG sub-mode. When working in the RW single mode, the motion of gimbals will be locked. Both the transition from CMG/RW hybrid mode to RW single mode and the reverse are studied. During the transition, wheel speed equalization and singularity avoidance of both the CMG and RW sub-modes are considered. A steering law for the RWs with locked gimbals is presented. It is shown by simulations that the VSCMGs with this new steering law could reach a better torque precision than the normal CMGs in the case of both large and small torques.     

民用飞机控制律对偏航机动载荷影响分析

飞机机动过程中方向舵快速大幅偏转会使方向舵和垂尾上产生较大气动载荷并传递到后机身,导致 驾驶员来回往复蹬舵造成安全事故。针对 CCAR-25部25.351条规定的偏航机动情况及 CS-25部25.353规定的偏航机动新条款——方向舵往复偏转,本文首先对两种偏航机动条款分别进行分析;然后考虑控制律进行 偏航机动情况机动仿真计算;最后通过比较分析飞机响应运动参数及垂尾载荷计算结果,并分析控制律对偏航 机动载荷的影响。结果表明:对于偏航机动,考虑控制律后飞机的响应幅度有所缓减,导致垂尾载荷有所降低; 对于偏航机动新条款,由于方向舵反向偏转导致侧滑角贡献和方向舵偏度贡献垂尾载荷两者叠加,从而导致垂 尾载荷大幅增加;P-Beta控制律有效降低了方向舵往复偏转的垂尾载荷。     

机载单站只测向定位最优机动研究

概述了机载单站只测向定位最优机动求解算法，研究了基于最大方位角变化率准则下的观测机机动轨迹，得到理论上的最优定位机动，并结合实际运用，分析出两种近似最优的机动：“一”形（直线形）机动和S形机动，通过仿真，验证了这2种机动方式在一定条件下可以等效于最优机动，具有良好的定位效果。     

执行器故障下的运载火箭非奇异终端滑模容错控制

针对存在未知外部干扰和执行器卡死故障的运载火箭，提出了一种基于非奇异终端滑模面的姿态跟踪控制算法。首先，建立了考虑干扰和执行器卡死故障的运载火箭姿态控制系统多输入多输出系统模型；然后定义了运载火箭姿态跟踪系统模型，针对定义的模型，设计了一种非奇异终端滑模面，使得系统在执行器故障情况下仍能较为精确地跟踪参考信号。基于李雅普诺夫函数证明了运载火箭姿态跟踪控制系统的稳定性和有限时间收敛特性。数值仿真检验了本文基于非奇异终端滑模运载火箭姿态跟踪控制算法的有效性。     

Development,integrated investigation,laboratory and in-flight testing of Chibis-M microsatellite ADCS

Design, analytical investigation, laboratory and in-flight testing of the attitude determination and control system (ADCS) of a microsatellites are considered. The system consists of three pairs of reaction wheels, three magnetorquers, a set of Sun sensors, a three-axis magnetometer and a control unit. The ADCS is designed for a small 10–50 kg LEO satellite. System development is accomplished in several steps: satellite dynamics preliminary study using asymptotical and numerical techniques, hardware and software design, laboratory testing of each actuator and sensor and the whole ADCS. Laboratory verification is carried out on the specially designed test-bench.In-flight ADCS exploitation results onboard the Russian microsatellite “Chibis-M” are presented. The satellite was developed, designed and manufactured by the Institute of Space Research of RAS. “Chibis-M” was launched by the “Progress-13M” cargo vehicle on January 25, 2012 after undocking from the International Space Station (ISS). This paper assess both the satellite and the ADCS mock-up dynamics. Analytical, numerical and laboratory study results are in good correspondence with in-flight data.