基于最小一乘的跑道入口高度计算

跑道入口高度是关系着飞机能否安全着陆的关键参数,在其计算中需要采用曲线拟合预测的方法。目前大多是采用基于最小二乘准则的拟合方式。由于最小二乘准则的局限性,当下滑道随机误差不满足正态分布,在飞行数据中出现异常点时会给预测带来较大误差。将最小一乘方法引入到跑道入口高度计算问题中,提高了算法的稳健性,很好地克服了这一问题。     

永磁约束电子束轨迹实验研究

通过设计并运用一种直流电子束轨迹简易测量方法,开展了永磁约束电子束轨迹实验研究,得到了永磁铁环对60~80 ke V电子束约束作用的实验数据。结果表明:该测量方法方便有效,结果较为准确;永磁铁对电子束聚焦作用明显,并呈现出一定的规律性。对永磁铁约束电子束研究工作奠定了基础。     

15-5PH沉淀硬化不锈钢磁粉检测磁痕分析

针对航空15-5PH马氏体沉淀硬化不锈钢在磁粉检测过程中发现的条状、片状和长直磁痕显示进行了总结。分析了不同磁痕显示的特点及微观组织情况,最终确定了磁痕的性质。结合不同热处理状态下的磁特性分析,确立了纯洁度磁粉检测的工艺流程以及磁痕判别方法。研究发现沉淀硬化不锈钢在磁粉检测过程中磁痕显示主要是由铁素体和组织不均匀造成的。研究结论为航空制造过程中沉淀硬化不锈钢的磁粉检测的磁痕判定以及规范的制定提供依据,确保磁粉检测工作的顺利进行。     

热处理对FeCo-2V-0.5Cr软磁合金力学与磁学性能的影响

针对FeCo-2V-0.5Cr软磁合金,研究了真空热处理时间对其微观组织结构、力学与磁学性能的影响规律,发现在800℃下热处理时间为2h左右时,合金的抗拉强度和延伸率达到最佳,同时仍保持良好的软磁性能,抗拉强度、延伸率以及矫顽力分别为867.8MPa、10.4%以及2.0Oe。进一步对该合金进行附加磁场下的真空热处理,重点研究了合金的交流损耗与矫顽力随附加磁场方式包括磁场撤除温度与磁场下保温时间的变化规律,发现适当的磁场热处理对合金相关力学性能影响不大,但由于合金中产生了单轴各向异性而使合金矫顽力进一步降至1.6Oe。     

石英加速度计零件毛刺控制

针对现阶段石英加速度计零件的毛刺问题,分析了现有处理方法的缺陷.从被动去除和主动控制两条途径入手,以轭铁零件为例,在加工中引用了少无毛刺加工技术,并引进了新的去毛刺方法.强度检测结果表明,这两种方法的运用显著改善了毛刺控制的效果,值得推广和运用.     

风扇/压气机周向模态识别中传感器角度偏差的影响

基于任意角度压缩感知(CS)方法分析了传感器安装角度偏差对风扇/压气机周向模态识别重构的影响,设计了一套自适应角度优化程序修正重构误差。利用数值试验探究了传感器角度偏差和数量对周向模态重构结果的影响,研究表明:当角度偏差等级为2.5%时,平均重构误差达到10%以上,若保证重构误差基本不变,将传感器数量从7个增加至25个,仅可以将角度偏差等级放宽至4%。而采用小生境微种群遗传算法进行自适应角度优化,在20 dB信噪比下,通过自适应角度优化可将角度偏差等级从2.5%放宽至10%,降低了传感器安装的精度要求。成功优化了一款冷却风扇在前三阶叶片通过频率下的主要周向声模态重构幅值。自适应角度优化算法有效提升了基于压缩感知的风扇/压气机周向模态重构可靠性。     

The effects of the solar magnetic polarity and the solar wind velocity on Bz-component of the interplanetary magnetic field

We have studied the effect of both solar magnetic polarity and the solar wind velocity on the Bz-component of the interplanetary magnetic field, IMFBz, for the minimum activity of the solar cycles 21, 22, 23 and 24. We made a statistical study of IMFBz in the first section which is considered as an extension of Lyatsky et al. (2003). They made a statistical study of IMFBz for two periods of minimum solar activity 22 and 23 related to 1985–1987 and 1995–1997 when the solar magnetic field had opposite polarity. Our results seem to be consistent with the results obtained by Lyatsky et al. (2003). We found that there is a dependence of IMFBz on the IMFBx and the solar magnetic polarity for the minimum periods of the selected four solar cycles. In addition, we found that there is a dependence of IMFBz on the solar wind velocity.     

Comparison between observed ionospheric foF2 and IRI-2001 predictions over periods of severe geomagnetic activities at Grahamstown,South Africa

The observed ionospheric F2 critical frequency (foF2) values over a South Africa mid-latitude station, Grahamstown, (geographic coordinates: 33.3°S, 26.5°E), were analysed and compared with International Reference Ionosphere (IRI) model, using the CCIR (Comite´ Consultatif International des Radio communications) and URSI (Union Radio-Scientifique Internationale) coefficients, during four geomagnetically disturbed days in the year 2000. These days are April 5, May 23, August 10 and September 15. The data were analysed for five days around the storm day. Comparisons between the IRI-2001 predicted foF2 values, using both CCIR and URSI coefficients and the observed values are shown with their root-mean-square error (RMSE) and the relative deviation module mean (rdmm) for the various storm periods. The CCIR option performed more accurately than the URSI option.     

Solar flare forecasting model supported with artificial neural network techniques

Nowadays operational models for solar activity forecasting are still based on the statistical relationship between solar activity and solar magnetic field evolution. In order to set up this relationship, many parameters have been proposed to be the measures. Conventional measures are based on the sunspot group classification which provides limited information from sunspots. For this reason, new measures based on solar magnetic field observations are proposed and a solar flare forecasting model supported with an artificial neural network is introduced. This model is equivalent to a person with a long period of solar flare forecasting experience.     

磁转速表指针摆动的故障分析

就磁转速表活动系统的动态特性以及在附加交变力矩的作用下，指针摆动随转速变化的规律，从理论上进行了分析，并结合实际探讨了指针摆动的故障原因。