模型燃烧室中值班火焰稳定器的燃烧不稳定性研究

针对值班火焰的燃烧不稳定性问题，通过试验得到了不同当量比工况下的火焰结构、压力脉动信号和热释放脉动信号。对脉动信号进行傅立叶分析，获得了脉动信号的频率和振幅。结果表明，随着当量比增加，火焰形态发生变化，燃烧室内发生了164Hz三阶模态向109Hz二阶模态的转换。对火焰平均结构、火焰瞬态结构和火焰正交分解（POD）结果进行分析后发现，漩涡脱落频率和燃烧室某一阶声学模态耦合是维持燃烧不稳定性的机理，耦合的强弱和漩涡脱落的尺度大小决定了热声振荡的振幅大小，火焰形态的变化导致热释放中心位置的变化是引起模态转换的机理。     

多孔介质微燃烧器内的火焰驻定机理研究

为解释毫米尺度多孔介质燃烧器中火焰可在一个当量比范围内驻定的物理现象,搭建了二维非稳态数学物理模型,利用数值计算方法定性研究了氢气/空气预混气在部分填充不锈钢网的微通道内的火焰传播特性。通过分析浸没火焰及表面火焰的温度分布特点并量化燃烧室内的预热和散热发现：火焰驻定在多孔介质内的不同位置时对应的传热特性存在差异,是控制火焰传播速度在一定当量比范围内保持恒定的关键因素,而预热及散热的相对大小可作为衡量传热对火焰宏观影响的重要参数。对火焰的的总预热与总散热之比R越临近多孔介质入口边界变化越剧烈,导致浸没火焰易驻定在多孔介质的中上游区域；多孔介质对火焰的预热虽在多孔介质出口边界外减小,但与多孔介质散热之比Rp呈上升趋势,使得低流速工况下易形成表面火焰。同时,R随当量比的变化规律导致多孔介质下游火焰的稳定性相对较弱。     

Effects of swirler position on flame response and combustion instabilities

This study is concerned with the experimental and theoretical investigation of the combustion instabilities in a premixed swirl combustor. It is focused on the effects of the swirl mixing distance on the intrinsic thermoacoustic mode. The swirler as an origin of the swirling flow is also the source of the flow disturbance, which has effects on the flame response. The location of the swirler is varied in the experiment to study the effect on combustion instabilities and flame transfer functions. ...     

Detailed modeling of aluminum particle combustion——From single particles to cloud combustion in Bunsen flames

A numerical model for aluminum cloud combustion which includes the effects of interphase heat transfer, phase change, heterogeneous surface reactions, homogeneous combustion,oxide cap growth and radiation within the Euler–Lagrange framework is proposed. The model is validated in single particle configurations with varying particle diameters. The combustion process of a single aluminum particle is analyzed in detail and the particle consumption rates as well as the heat release rates due to the v...     

Similarity phenomena of lean swirling flames at different bulk velocities with acoustic disturbances

In this study, flame responses to acoustic disturbances with different frequencies and amplitudes were experimentally investigated in a lean premixed swirl-stabilized combustor operating at different bulk velocities. The total heat release rate fluctuations and spatial CH* chemiluminescence distributions were captured using a photomultiplier tube and high-speed camera, respectively. The results indicate that the heat release rate exhibits a relatively drastic oscillation and high-order harmonics for low-frequency disturbances. When the bulk velocity and forcing frequency were doubled simultaneously, similar flame structures were observed in the CH* chemiluminescence distributions. As the bulk velocity increases, the gain of the Flame Describing Function (FDF) extends toward the higher frequencies, and the delay time of the flame response decreases. The similarity among FDFs at different bulk velocities was effectively captured by introducing a non-dimensional parameter, defined as the ratio of the flame response delay to the forcing time scale, to replace the dimensional forcing frequency. Furthermore, the availability of the newly defined non-dimensional parameter was verified for flames with different swirl numbers, as this played an important role in determining the flame structures and associated unsteady heat release rate.     

空间用9Cr18 钢PIII 复合离子注入表面改性工艺研究

采用等离子体浸没离子注人(PⅢ)技术对9Cr18轴承钢表面进行了双注入及共注入Ti+N工艺处理.测试了处理前后试样的显微硬度及真空摩擦因数,并表征分析了表面磨损形貌.结果表明:处理后试样的显微硬度都有大幅提高,最大增幅达68.7％；表面真空摩擦因数由0.15下降到0.08；磨斑尺寸及粗糙度分别减少了54.4％和37.4％.双注入与共注入方式在相同参数下,双注入处理后的试样表面综合性能更加优异.     

轴承钢等离子体基离子注碳复合改性层化学结构的研究

通过激光Ｒａｍａｎ光谱、Ｘ射线光电子谱以及电阻和显微硬度的测试，研究了ＧＣｒ１５钢及镀钛ＧＣｒ１５钢试样经乙等离子基离子注入所得表面改性层的化学结构。     

基于滑动弧的燃烧室头部强化燃烧特性

为了研究基于滑动弧的燃烧室头部强化燃烧效果，探究了燃烧室头部的点火过程以及不同等离子体电源输入功率下的点/熄火边界，利用像增强系统获得了CH*基团的分布云图。实验结果表明：输入功率的增大使得燃烧室的点/熄火边界均得到拓展，与160 W工况相比，输入功率为320 W时，点火边界平均拓宽约17.6%，与未放电相比，输入功率为320 W时，熄火边界平均拓宽约45.3%，滑动弧放电对熄火边界拓宽效果明显；当滑动弧能够点燃来流新鲜混合气时，输入功率的增加使得CH*基团分布向上游移动，当输入功率为320 W时，燃烧火焰驻留在燃烧室头部，当滑动弧激励器仅具有助燃作用时，输入功率的增加使得局部CH*基团辐射强度增强，热释放速率增加。     

First measurements of periodicities and anisotropies of cosmic ray flux observed with a water-Cherenkov detector at the Marambio Antarctic base

A new water-Cherenkov radiation detector, located at the Argentine Marambio Antarctic Base (64.24S-56.62 W), has been monitoring the variability of galactic cosmic ray (GCR) flux since 2019. One of the main aims is to provide experimental data necessary to study interplanetary transport of GCRs during transient events at different space/time scales. In this paper we present the detector and analyze observations made during one full year. After the analysis and correction of the GCR flux variability due to the atmospheric conditions (pressure and temperature), a study of the periodicities is performed in order to analyze modulations due to heliospheric phenomena. We can observe two periods: (a) 1 day, associated with the Earth’s rotation combined with the spatial anisotropy of the GCR flux; and (b) $～$ 30 days due to solar impact of stable solar structures combined with the rotation of the Sun. From a superposed epoch analysis, and considering the geomagnetic effects, the mean diurnal amplitude is $～$ 0.08% and the maximum flux is observed in $～$ 15 h local time (LT) direction in the interplanetary space. In such a way, we determine the capability of Neurus to observe anisotropies and other interplanetary modulations on the GCR flux arriving at the Earth.     

红外探测设备抗烟幕干扰试验及评估方法

红外探测设备抗烟幕干扰能力是其抗干扰能力的重要部分。常规方法对场地和实施要求很高,试验次数安排有限。文章对该试验设计的关键问题开展分析和研究,根据红外探测设备作用距离与目标能量的关系,采用"等效试验"构建外场静态试验干扰环境,并合理选择试验因素采用均匀设计方法进行试验设计,确定抗干扰试验方案和评估方法。该方案可指导试验获得科学合理有效的数据,从而实现烟幕干扰环境下红外探测设备的抗干扰能力的准确评估。