随机疲劳裂纹扩展及动态可靠性分析

在确定性袭纹扩展模型的基础上，建立了疲劳裂纹扩展的随机模型。考虑裂纹扩展引起的强度衰减，建立了实用的动态可靠性分析模型。     

优化的GM(1,1)模型及其适用范围

在已有灰色理论的基础上,利用“最小二乘法”确定GM(1,1)白化权函数的时间响应函数中的常数c,摈弃了传统GM(1,1)把原始序列中x^(0)(1)作为初始条件的欠科学的做法,构建了时间响应函数的优化模型。经大量的数据模拟和预测,发现优化的GM(1,1)模型各项指标均优于传统的GM(1,1)模型,且拓宽了其适用范围。     

基于IRI-2012模型广州地区f_0F_2实测与预测的对比分析

利用广州台站(23.2°N,113.3°E)的实测数据和IRI-2012模型提供的预测数据,对比分析了2013年广州地区f_0F2的变化特征.结果表明,IRI-2012模型能够较好预测该地区f_0F_2的变化趋势,并且CCIR参数得到的预测值比URSI参数更接近实测值;预测值与实测值存在系统偏差,在11:00 LT-06:00 LT时段,观测值均比预测值大,其他时段则相反.在日落后至午夜前时段,预测值与实测值有较大差距.绝对偏差的极值点通常出现在20:00 LT左右,最大超过4 MHz.相对偏差变化比较明显的时段是午夜后至凌晨;在02:00 LT或04:00 LT及06:00 LT附近,可能会出现双误差峰值点,最大超过0.4;但在σ变化很大的20:00 LT附近,相对偏差却变化不大.夜间增强现象会使得偏差增大,导致预测值不能很好反映实测f_0F2的变化.     

Atmospheric reentry hemisphere prediction for prograde orbits using logical disjunction

A unique logic-based algorithm for atmospheric reentry hemisphere prediction is presented for spacecraft in low-eccentricity, prograde low Earth orbits at altitudes of 300 km and lower. Using two-line element (TLE) data for initial orbit conditions, coupled with coarse estimates for spacecraft aerodynamic characteristics, the algorithm relies on logical disjunction operations based on a dual analysis of histogram and two-weighted Gaussian probability density function (PDF) fits of predicted reentry latitude data. The algorithm requires the execution of a series of parametric simulations to determine the reentry hemisphere for variations in spacecraft aerodynamic coefficients and drag reference area. When implemented, the algorithm yields accurate hemisphere predictions on average 15 days from reentry as demonstrated by historical reentry cases from 1979 to 2018. All reentry cases were selected to demonstrate the algorithm’s ability to deliver accurate reentry hemisphere predictions for spacecraft with varying physical size and mass, and reentering during different periods of solar cycle activity.     

国产工业摄影测量相机精度测评CSCD

专业的工业摄影测量相机作为摄影测量的基础,其成像质量对测量精度有着直接的影响。目前,国内的专业摄影测量相机的发展比较缓慢,且质量参差不齐,研究合适的测试方法对国内专业测量相机的精度进行测评已刻不容缓。以CIM-1相机为例,从坐标重复性、标准长度等方面对国内工业摄影测量相机的精度进行了分析研究。通过与目前国际上比较认可的INCA相机进行了实验对比,并对实验结果进行了分析评价,得到一些比较理想的结论。为我国工业摄影测量系统检定规程的制定提供参考依据。     

基于L_1自适应的超低空空投抗侧风控制律设计

针对超低空空投过程中侧风干扰与装备投放过程相耦合,影响载机飞行安全和空投任务的完成等问题,提出了基于L_1自适应的控制律设计方法。利用最优控制对系统线性部分做状态反馈并确定匹配参考模型,在此基础上,考虑系统的匹配和非匹配不确定性,设计L_1自适应控制器实现姿态保持,结合外环PID侧向轨迹控制器实现对航迹的稳定和保持。仿真结果表明,控制器具有优良的控制性能,对复杂侧风干扰和系统非线性不确定性具有很强的鲁棒性,且在高自适应增益下能有效抑制输入信号高频抖振。     

缺口件疲劳寿命预测新方法

采用有限元方法针对缺口件多轴疲劳实验结果进行模拟。结果表明,相同路径条件下,随着缺口半径减小缺口根部附近的应力梯度显著增加。基于缺口根部应变值,采用等效应变法进行疲劳寿命预测,预测结果随缺口半径的减小而偏于保守。采用应力梯度法确定有效距离,相同路径下,随着缺口半径的减小有效距离减小;依据该有效距离处的等效应变进行疲劳寿命预测,总体预测结果较为分散且偏于不安全。基于实验及有限元模拟结果,提出了基于应变梯度的有效距离确定的新方法,大部分疲劳寿命预测结果位于2倍分散带内。     

FCD1软脆光学镜片的高效研磨加工

针对FCD1软脆光学镜片高效高成品率的精密加工问题,本研究提出了一种使用复合结合剂金刚石丸片的精研加工技术,其金刚石丸片研具采用了金属、树脂和添加剂等复合结合剂。在精研过程中,丸片表层金刚石磨粒对工件的切深一致性避免了工件表面易出现的深划痕,可有效减少后道抛光工序加工时间,从而提高FCD1软脆光学镜片的生产效率和成品率。     

DME Interference mitigation for L-DACS1 based on system identification and sparse representation

L-band digital aeronautical communication system 1 (L-DACS1) is a promising candi-date data-link for future air-ground communication, but it is severely interfered by the pulse pairs (PPs) generated by distance measure equipment. A novel PP mitigation approach is proposed in this paper. Firstly, a deformed PP detection (DPPD) method that combines a filter bank, correlation detection, and rescanning is proposed to detect the deformed PPs (DPPs) which are caused by mul-tiple filters in the receiver. Secondly, a finite impulse response (FIR) model is used to approximate the overall characteristic of filters, and then the waveform of DPP can be acquired by the original waveform of PP and the FIR model. Finally, sparse representation is used to estimate the position and amplitude of each DPP, and then reconstruct each DPP. The reconstructed DPPs will be sub-tracted from the contaminated signal to mitigate interference. Numerical experiments show that the bit error rate performance of our approach is about 5 dB better than that of recent works and is closer to interference-free environment.     

Ionospheric F2-Layer critical frequency retrieved from COSMIC radio occultation: A statistical comparison with measurements from a meridional ionosonde chain over Southeast Asia

In this paper, we compared the F2-Layer critical frequency (foF2) derived from FORMOSAT-3/COSMIC radio occultation (RO) and ionosondes at Chiang Mai, Chumphon and Kototabang during the years 2008–2015 to evaluate the performance of COSMIC RO over Southeast Asia region. The results show that the time development of foF2 values derived from COSMIC RO generally agrees well with those from ionosonde measurements. However, the differences between the foF2 derived from COSMIC RO and that derived from ionosonde observations display latitudinal dependence. COSMIC RO tends to underestimate foF2 at Chiang Mai and Kototabang, which is near to the north EIA crest and the south one, respectively, while a little overestimate foF2 at Chumphon, which is close to the geomagnetic equator. COSMIC RO agrees best with ionosonde at Chumphon and worst at Chiang Mai. At each ionosonde station, the quality of COSMIC RO data degrades with the increase of solar activity. In addition, at the station Chiang Mai and Kototabang, COSMIC RO performs better in summer than in equinox and winter. Furthermore, the differences in foF2 derived from COSMIC RO and that from ionosonde measurements vary with local time, i.e., the differences in foF2 are generally smaller at night and larger in noontime when equatorial ionization anomaly (EIA) is well developed.