On the origin of the grooves on Phobos

L-grooves are the consequence of layered structure of Phobos, which are made up of parallel layers of different composition or hardness.     

Two low-cost phased arrays

In a phased array antenna, the phase shifters (or T/R modules in an active aperture phased array) with their beam-steering control circuitry along with the feed network account for the major hardware cost. This paper presents two antenna array configurations that use simpler feed, simpler phase-shifting and simpler beam-steering control circuitry for realizing low-cost phased arrays. Both are lens configurations. The first one uses a Radant lens, which provides a medium that is loaded with diodes and provides the needed phase shift by switching the diodes on and off. The other configuration employs a ferroelectric dielectric material whose dielectric constant can be varied with an applied DC bias voltage. It is shown that the ferroelectric lens may have further advantages of smaller thickness, simpler beam-steering controls and lower cost     

High resolution grazing incidence telescopes for the EUV-regime

Much experience has been gathered over the past two decades in the building of grazing incidence X-ray telescopes. Based on the performance data of the best X-ray optics, the requirements for building an EUV-telescope with sub-arcsecond angular resolution are estimated.Proceedings of the Conference Solar Physics from Space, held at the Swiss Federal Institute of Technology Zurich (ETHZ), 11–14 November 1980.     

Dual spacecraft observations of energetic particles in the vicinity of the magnetopause,bow shock,and the interplanetary medium

This article presents some of the new and important particle features that have been detected in the energy range 1 keV to 290 keV by the ISEE-1 and -2 spacecraft near the magnetopause, bow shock, and the interplanetary space. Only examples of data from the first few orbits, when the spacecraft were on the front side, are shown.Paper presented at 13th ESLAB Symposium, Innsbruck, Austria (June 5, 1978).     

Heterodyne spectroscopy of astronomical and laboratory sources at 8.5 μm using diode laser local oscillators

The first 8.5m infrared heterodyne spectrometer has been constructed using tuneable semiconductor (PbSe) diode lasers and was used to measure absorption line profiles of N₂O in the laboratory and black body emission from the Moon and from Mars. Spectral information was recorded over a 200 MHz bandwidth using an 8-channel filter bank. The resolution was 25 MHz (6 × 10^–6 m) and the minimum detectable (black-body) power was 1 × 10^–16 W for 8 min of integration. The results demonstrate the usefulness of heterodyne spectroscopy for the study of remote and local sources in the infrared.We wish to thank Dr Jack Butler and Craig Simpson (Arthur D. Little, Inc.) for their continuing (and successful) efforts to grow better diode lasers during the course of this experiment. We thank the National Radio Astronomy Observatory for the loan of a 40-channel filter bank and associated mini-computer.We thank en masse the dozens of people who loaned equipment to us for the duration of this experiment, and the commercial firms (especially Harshaw, Inc.) which expedited orders for crucial equipment. We thank Dr Bertram Donn, Dr Norman Ness, and Dr George Pieper for administrative, scientific, and financial support; and we thank Mr James Faris for technical assistance and Dr Sol Glicker for preparation of sample gas cells. We thank Dr Thomas Clark for providing the Kohoutek ephemeris, sighting printout, and predicted molecular line positions and for advice and the loan of some equipment. Finally, we wish to acknowledge the strong support accorded us by our wives and families who scarcely saw us during this period.     

Validation of aerosol measurements by the satellite sensors SAM II and SAGE

The satellite sensors SAM II and SAGE have been developing a global data base on stratospheric aerosols since they were launched in October 1978 and February 1979, respectively. The validity of this data base has been tested by numerous comparisons with other measurements made by lidars, balloon-borne particle counters, and aircraft-borne impactors and filters. Because the satellite sensors measure extinction and the correlative sensors measure other properties (e.g., backscatter, number, mass), special techniques are required to convert each measured property to other properties and to quantify conversion uncertainties and measurement uncertainties. Use of these techniques in two major comparative experiments shows that the SAM II and SAGE extinction measurements agree with each other and with values derived from dustsonde, lidar, and filter measurements. In addition, the comparative experiments have highlighted the uncertainties of each type of sensor and stimulated further efforts to reduce these uncertainties.     

Storage stability of screwpress-extracted oils and residual meals from CELSS candidate oilseed crops.

The efficacy of using screwpress extraction for oil was studied with three Controlled Ecological Life-Support System (CELSS) candidate oilseed crops (soybean, peanut, and canola), since use of volatile organic solvents for oil extraction likely would be impractical in a closed system. Low oil yields from initial work indicated that a modification of the process is necessary to increase extraction efficiency. The extracted oil from each crop was tested for stability and sensory characteristics. When stored at 23 degrees C, canola oil and meal were least stable to oxidative rancidity, whereas peanut oil and meal were least stable to hydrolytic rancidity. When stored at 65 degrees C, soybean oil and canola meal were least stable to oxidative rancidity, whereas peanut oil and meal were least stable to hydrolytic rancidity. Sensory evaluation of the extracted oils used in bread and salad dressing indicated that flavor, odor intensity, acceptability, and overall preference may be of concern for screwpress-extracted canola oil when it is used in an unrefined form. Overall results with screwpress-extracted crude oils indicated that soybean oil may be more stable and acceptable than canola or peanut under typical storage conditions.     

Control aspects of efficient rocket propulsion systems

The means for enhancing the efficiency of rocket propulsion of spacecraft is considered in terms of the control of propellant consumption, trajectory planning, and in-flight operations management. Particular attention is given to techniques by which all the fuel and oxidizer are consumed completely by mixture adjustment as an example of a terminal control system providing significant propulsion efficiency.     

VLSI processors for signal detection in SETI

The objective of the Search for Extraterrestrial Intelligence (SETI) is to locate an artificially created signal coming from a distant star. This is done in two steps: (1) spectral analysis of an incoming radio frequency band, and (2) pattern detection for narrow-band signals. Both steps are computationally expensive and require the development of specially designed computer architectures. To reduce the size and cost of the SETI signal detection machine, two custom VLSI chips are under development. The first chip, the SETI DSP Engine, is used in the spectrum analyzer and is specially designed to compute Discrete Fourier Transforms (DFTs). It is a high-speed arithmetic processor that has two adders, one multiplier-accumulator, and three four-port memories. The second chip is a new type of Content-Addressable Memory. It is the heart of an associative processor that is used for pattern detection. Both chips incorporate many innovative circuits and architectural features.