复合材料叠层结构孔口附近应力分析方法研究

本文在总结前人对复合材料结构开口的应力集中研究的基础上,根据孔口附近应力场的特点,提出了一种适于工程应用的复合材料叠层结构开口附近应力分析的有限元改进算法。由于应力计算精度的改进仅在孔边、拐角等高应力梯度区域局部进行,且改进后的单元能进一步精确描述应力集中区的应力场。因而,使用该方法计算孔边应力,用较少的单元就能得到满意的精度,大大减少了计算费用和时间。 文中选择了一些有代表性的考题验证了该方法的有效性。并着重研究了带有圆角矩形孔的复合材料层板结构的孔边应力分布,给出应力集中系数随圆角半径的变化规律、孔边加强对应力集中的改善以及±45°纤维铺层比例对孔边应力分布的影响,得到了一些对工程部件开口设计有用的数据资料。     

典型电离层多普勒记录及其讨论

由于地面电离层多普勒频率偏移测量具有时间连续、设备相对简便等固有特征，它特别适合于扰监测。本文在整理北京大学电离层高频多普勒台站观测资料的基础上，给出了一些典型电离层多普勒效应观测现象，这些现象反映了多普勒的细致分析对电离层形态学研究有其特殊意义。利用IRI模型，对多普勒频移的太阳耀斑效应及电离层不规则结构对多普勒频移的影响进行了模拟计算，理论结果与观测基本一致，从而大体上解释了这些响应的物理机制。论文最后对观测到的一种特殊的记录类型－－S型描迹的具体成因作了详细的分析和讨论，指出在一定条件下，以一定相位速度水平传播的声重波可以产生这类记录，给出了相位速度和振幅等声重波参数与记录描迹形状的关系，这对从多普勒频移记录推演电离层中的波动特征有一定的帮助。     

MONITORING OF ENERGETIC PARTICLE ENVIRONMENT INSIDE THE CHINA-BRAZIL EARTH RESOURCE SATELLITE

On 14 October 1999, the Chinese-Brazil earth resource satellite (CBERS-1) was launched in China. On board of the satellite there was an instrument designed at Peking University to detect the energetic particle radiation inside the satellite so the radiation fluxes of energetic particles in the cabin can be monitored continuously. Inside a satellite cabin, radiation environment consists of ether penetrated energetic particles or secondary radiation from satellite materials due to the interactions with primary cosmic rays.Purpose of the detectors are twofold, to monitor the particle radiation in the cabin and also to study the space radiation environment The data can be used to study the radiation environment and their effects on the electronics inside the satelhte cabin. On the other hand, the data are useful in study of geo-space energetic particle events such as solar proton events, particle precipitation and variations of the radiation belt since there should be some correlation between the radiation situation inside and outside the satellite.The instrument consists of two semi-conductor detectors for protons and electrons respectively. Each detector has two channels of energy ranges. They are 0.5-2MeV and ≥2MeV for electrons and 5-30MeV and 30-60MeV for protons. Counting rate for all channels are up to 104/(cm2@s)and power consumption is about 2.5 W. There are also the additional functions of CMOS TID (total integrated dose) effect and direct SEU monitoring. The data of CBMC was first sent back on Oct. 17 1999 and it's almost three years from then on. The detector has been working normally and the quality of data is good.The preliminary results of data analysis of CBMC not only reveal the effects of polar particle precipitation and radiation belt on radiation environment inside a satellite, but also show some important features of the geo-space energetic particle radiation.As one of the most important parameters of space weather, the energetic charged particles have great influences on space activities and ground tech nology. CBMC is perhaps the first long-term on-board special equipment to monitor the energetic particle radiation environment inside the satellite and the data it accnmulated are very useful in both satellite designing and space research.     

化学物质释放人工改变电离层

考虑中性气体在电离层高度的扩散过程和相应的电离层离子化学过程，研究了利用主动化学物质释放来改变电离层的方法，理论计算了H2O和SF6两种气体释放后电离层随时间的响应过程，结果表明，在电离层高度上气体的扩散过程非常迅速，电离层F区的电子密度有很大程度的减少，而扩散慢且化学反应快的气体对电离层的影响更大，就更加有利于电离层洞的形成。     

余辉等离子体的实验研究

利用调制脉冲产生的余辉等离子体的参数测量表明:等离子体空间电位和电子温度的衰变是重要的,它在余辉等离子体的密度衰变过程研究中必须予以考虑.对容器中余辉等离子体密度径向分布的测量结果与理论预言是一致的.     

利用MF雷达对耀斑期间电离层D区电子密度的观测研究

利用MF雷达观测资料对X级别耀斑爆发期间在66-80km高度之间的电子密度进行了研究，观测到了耀斑爆发期间电子密度的突然增加，在较低高度上的电子密度的时间变化趋势与耀斑的软X射线辐射通量相关．电子密度的变化强度依赖于具体的耀斑参数，有些耀斑引起的电子密度增加高达400cm^-3，有些仅为100cm^-3左右．但耀斑期间在这一高度区间增加的总电子含量增量仅占耀斑辐射引起的整个电离层总电子含量增量的千分之一左右．最后，利用恢复阶段电子密度的时间变化过程估算了1997年11月4日耀斑期间部分高度上的有效复合系数．     

直升机“地面共振”力学模型的探讨

 <正> I_B 桨叶绕垂直铰的转动惯量I_(?),I_(?),I_(?) 机身绕过其重心O的x,y,z 轴的转动惯量ι 桨叶长度m_B 单片桨叶的质量     

基于层次分析法的飞行模拟训练评价体系设计

为科学完善地描述飞行模拟训练中的应急处置程序,提升飞行员专业驾驶技术水平,本文提出飞行模拟训练评价体系,并通过层次分析法构造3阶判断矩阵,检测矩阵一致性指标为0.037,具有可接受性;并采用关联度进行数据分析量化计算,为飞行训练考核标准奠定理论基础。     

火箭橇体进水现象研究

在考核过载承受能力的火箭橇试验后,橇体内发现有水,从空气动力学的角度,对火箭橇体进水现象进行了初步分析,并利用FLUENT软件对进水原因进行了初步研究,通过分析,发现结构在穿越跨音速阶段时,由于内外压差的变化将导致内部或外部产生水汽。该发现为结构设计提供有益的建议。     

Time Sequence Change-Point Model of Electrostatic State Parameters of Aircraft Engine

Electrostatic monitoring technology of particle charging information can facilitate online monitoring of aero-engine,which effectively enhances engine fault diagnosis and health managements.Unlike traditional engine state monitoring technologies,aircraft engine monitoring by gas path electrostatic monitoring not only covers the predicted information source itself,but also detects the information that can provide an early warnings for initial fault states through gas path charging levels.This paper establishes a non-stationary time sequence change-point model for anomaly recognition of electrostatic signals based on change-point theory combined with difference method of non-stationary time series.Finally,electrostatic induction data were utilized by the engine life test for a particular aircraft to validate the proposed algorithm.The results indicate that the activity level and the event rate were0.5—0.8(nc)and 50%,respectively,which were far greater than 4—12(pc)and 0—4% under normal working conditions of the engine.