Ambiguity Functions for Quadratic Phase-Coded Pulse Trains

The matched filter ambiguity function is presented for a burst waveform composed of repeated subbursts, each one of which consists of N pulses in which the phase is varied quadratically from pulse to pulse. The resulting ambiguity function exhibits small residual ambiguities along the delay axis separated by the reciprocal of the pulse repetition frequency (PRF). A cross-ambiguity function is derived which reduces these ambiguities to zero amplitude. A third cross-ambiguity function is presented for a receiver matched to a generalized Hamming weighted repeated quadratic burst. The location in the delay/Doppler plane of the waveform ambiguities for these waveforms is compared with that of an uncoded pulse burst.     

Ambiguity properties of quadratic congruential coding

The ambiguity characteristics of multiple access frequency hop codes based on standard quadratic congruences are investigated in the light of results obtained for codes based on Costas arrays and extended quadratic congruences. While the autoambiguity properties are found to be very similar to those of Costa codes, i.e. nearly ideal, the cross-ambiguity properties of quadratic congruential codes are much better. These results are valid across the whole class of code sets considered, but they are obtained at some expense in the pulse compression characteristics of the codes. A uniform upper bound is placed on the entire cross-ambiguity function surface, and bounds are placed on the amplitude of spurious peaks in the autoambiguity function. These bounds depend on the time-bandwidth product and code length exclusively and lead naturally to a discussion of the design tradeoffs for these two parameters. Examples of typical autoambiguity and cross-ambiguity functions are given to illustrate the performance of quadratic congruential coding with respect to Costas coding     

Time-frequency hop codes based upon extended quadratic congruences

Time-frequency hop codes are developed that can be used for coherent multiuser echolocation and asynchronous spread spectrum communication systems. They represent a compromise between Costas codes, which have nearly ideal autoambiguity but not so good cross-ambiguity properties, and linear congruential codes, which have nearly ideal cross-ambiguity but unattractive autoambiguity properties. Extended quadratic congruential code words are shown to have reasonably good autoambiguity and cross-ambiguity properties across the whole class of code sets considered. A uniform upper bound is placed on the entire cross-ambiguity function surface, and bounds are placed on the position and amplitude of spurious peaks in the autoambiguity function. These bounds depend on the time/bandwidth product and code length exclusively and lead naturally to a discussion of the design tradeoffs for these two parameters. Examples of typical autoambiguity and cross-ambiguity functions are given to illustrate the performance of the new codes     

Clutter Suppression Properties of Weighted Pulse Trains

A common but troublesome requirement on radar sensors is the detection of a target in the interference from undesired scatterers, or clutter. Systems with coherent processing of pulse trains are uniquely suited for the purpose because, with pulse trains, it is possible to concentrate the receiver output for particular values of Doppler and thus suppress the clutter by Doppler filtering. This paper discusses to what degree the effectiveness of the method can be enhanced by tapering, or weighting, of the pulse amplitudes. The general results are illustrated by computer-plotted response functions for weighted pulse trains. The clutter suppression efficiency of weighting is calculated both for unilateral weighting in the receiver and for bilateral weighting in both receiver and transmitter. The significance of additional phase weighting is discussed and the results for pure amplitude weighting are compared with publishedwork on phase and amplitude weighting.     

Group-Complementary Array Coding for Radar Clutter Rejection

A radar waveform design technique which utilizes Lagrange's method of multipliers to control temporal sidelobes and to reduce Doppler sidelobes is described. This classical method of constrained optimization is applied to the problem of synthesizing a radar wave-form where mismatch loss is the objective function to be minimized. The associated constraints are taken from expressions for the composite temporal sidelobes of the cross-correlation response and the peak correlation response where sets of code words are used to modulate a series of radar pulses. The resulting code sets and receiver reference sets are called group-complementary and produce a trench parallel to or on the range axis of the cross-ambiguity surface.     

On cross-ambiguity properties of Welch-Costas arrays

We discuss cross-ambiguity properties of a specific family of Costas arrays called Welch-Costas (W-C) arrays. These properties are of interest in multiuser radar and sonar system, especially since Costas arrays are known to possess ideal auto-ambiguity functions. The theory of W-C arrays is reviewed. It is then proved that only pairs of W-C arrays can have at most two hits in their cross-ambiguity function (best possible case). The maximum number of hits in the cross-ambiguity functions of a family of W-C arrays is shown to be a function of the number of W-C arrays in the family. The upper bound on the number of hits in the cross ambiguity functions for a family of W-C arrays is also derived. Specific examples of how reducing the number of W-C arrays improves the cross-ambiguity properties are given for various types of prime numbers     

A Generalized Clutter Computation Procedure for Airborne Pulse Doppler Radars

A general procedure for analyzing ground clutter effects in airborne pulse Doppler radars is described. The quantity computed is the expected clutter power at the output of any specified range gate/ Doppler filter processing cell. The procedure has been computerized and is quite general with respect to antenna gain pattern, clutter cross section variation, PRF, pulse and range gate shapes, and the various receiver processing functions. It is applicable only to distributed ground clutter and linear processing, and excludes the dynamic effects of continuous antenna scanning. To exemplify the use of the procedure, two studies conducted for a postulated high PRF radar are described, and the results are presented.     

Cochannel Interference Analysis between Spaceborne and Terrestrial Radars

An analysis of cochannel interference between spaceborne and terrestrial radars is presented. A generic modeling methodology is applied, which, it is felt, will represent the worst-case situation. In order to account for Doppler shifts, auto-and cross-ambiguity functions ions have been developed for determining matched filter outputs. The results support the ability of such radar systems to coexist relatively harmoniously utilizing currently accepted assignment procedures.     

Matched Filter Criteria and Range Weighting for Weather Radar

The effective weighting function for weather radar is defined. This weighting function considers the effects of both the transmitted signal and the receiver filter. It is used to assign effective ranges to samples taken at prescribed times. For uniformly distributed targets it is shown that "signal"-to-noise ratio depends on the receiver filter, transmitted signal envelope, and receiver noise spectral density. Maximization of this signal-to-noise ratio when range resolution constraints are imposed is discussed, and a receiver design approach specifically adapted for Doppler weather radars is developed.     

Multiple Access Frequency Hopping Patterns with Low Ambiguity

A technique is discussed for the design of multiple access frequency hopping patterns which will allow a number of users to communicate reliably over a limited bandwidth in the presence of Doppler and timing asynchronies. The patterns are based on a subset of the Reed-Solomon codewords. They possess nearly flat ambiguity and cross-ambiguity functions and thus could be useful as discrete radar signals. In addition the structure of the patterns permits a straightforward Implementation.     

Mismatched Filtering of Sonar Signals

A replica correlator (matched filter) is an optimum processor for a receiver employing a pulse of continuous wave (CW) signal in a white Gaussian noise background. In an active sonar, however, when the target of interest has low Doppler shift and is embedded in a high reverberation background, this is not so. High sidelobes of the correlator frequency response pass a significant portion of the signal contained in the mainlobe of the reverberation spectrum. In order to reduce the sidelobes of the correlator output spectrum and at the same time keep the increase in its 3 dB bandwidth to a small amount, we propose lengthening of the replica of the transmitted signal and weighting it by a Kaiser window. It is demonstrated that by extending the weighted replica by 50 percent compared with the transmitted signal, it is possible to reduce the sidelobe levels to at least 40 dB below the mainlobe peak, with the concomitant increase of the 3 dB band-width by less than 5 percent. The degradation in signal-to-noise ratio (SNR) performance for such a ?mismatched? filter receiver with respect to the matched filter is less than 1.5 dB.     

Effects of Doppler Mismatch on Combined Barker Codes

The output response of a matched filter for several cases of combined Barker codes is computed for various amounts of Doppler mismatch. It is shown that combined Barker codes, like conventional Barker codes, are extremely sensitive to Doppler shift.     

Clutter Suppression by Complex Weighting of Coherent Pulse Trains

Uniform coherent pulse trains offer a practical solution to the problem of designing a radar signal possessing both high range and range-rate resolution. The Doppler sensitivity provides some rejection of off-Doppler (clutter) returns in the matched filter receiver. This paper considers the use of a processor in which members of the received pulse train are selectively weighted in amplitude and phase to improve clutter suppression. The techniques described are particularly suitable for rejecting interference entering the processor through ambiguous responses (range sidelobes) of the signal. The complex weights which are derived are optimum in the sense that they produce the maximum clutter suppression for a given detection efficiency. In determining these weights, it is assumed that the distribution of clutter in range and range rate relative to targets of interest is known. Thus, clutter suppression is achieved by reducing the sidelobe levels in specified regions of the receiver response. These techniques are directly applicable to array antennas; the analogous antenna problem would be to reduce sidelobe levels in a particular sector while preserving gain. Complex weighting is most successful when the clutter is limited in both range and velocity.     

Frequency hop multiple access codes based upon the theory of cubiccongruences

The need for families of frequency-hop codes which have mutually small auto-ambiguity and cross-ambiguity functions is discussed. Current coding methods are reviewed. A new family of frequency-hop codes based upon the number-theoretic concept of cubic congruences is introduced. It is shown that for about 50% of the prime numbers, families of full codes exist which have at most two coincidences for any time-frequency shift in their auto-ambiguity functions and at most three coincidences in the set of mutual cross-ambiguity functions     

Poly-phase codes and optimal filters for multiple user ranging

A technique is introduced to select poly-phase codes and optimal filters of a pulse compression system that have specific temporal and frequency characteristics. In the particular problem under study, multiple vehicles are assigned unique codes and receiver filters that have nearly orthogonal signatures. Narrowband users, that act as interference, are also present within the system. A code selection algorithm is used to select codes which have low autocorrelation sidelobes and low cross correlation peaks. Optimal mismatched filters are designed for these codes which minimize the peak values in the autocorrelation and the cross correlation functions. An adjustment to the filter design technique produces filters with nulls in their frequency response, in addition to having low correlation peaks. The method produces good codes and filters for a four-user system with length 34 four-phase codes. There is considerable improvement in cross and autocorrelation sidelobe levels over the matched filter case with only a slight decrease in the signal-to-noise ratio (SNR) of the system. The mismatched filter design also allows the design of frequency nulls at any frequency with arbitrary null attenuation, null width, and sidelobe level, at the cost of a slight decrease in processing gain     

Tracking Accuracies with Position and Rate Measurements

Tracking accuracies for the radial component of motion are computed for a track-while-scan radar system which obtains position and rate data during the dwell time on a target These results will be of interest to persons developing trackers for pulse Doppler surveillance radars. The normalized accuracies, computed for a two state Kalman tracking filter with white noise maneuver capability, are shown to depend upon two parameters, r = 4?0/?aT2 and s = ?dT/?0. The symbols ?0 and ?d are the position and rate measurement accuracies, respectively, ?a is the standard deviation of the white noise maneuver process and T is the antenna scan time. The scalar tracking filter equations are derived and numerical results are presented. Lower steady state tracking errors plus the earlier attainment of steady state accuracies are the direct consequence of incorporating the rate measurements into the tracking filter.     

Reception of pulsed signals by detuned receiver: addenda andcorrections

The parameters of a pulse perturbed by passage through a filter were examined in a variety of cases in a previous paper by the author (ibid., vol.AES-4, p.486-9, May 1968). One case not covered is that of a rectangular pulse passed through a detuned Gaussian filter; that case is presented, as is the case of a swept Gaussian pulse passed through such a filter, which may be dispersive. Corrections are included for two tabular entries in the original paper concerning a Gaussian pulse fed to an ideal bandpass filter when the time-bandwidth product and detuning are large     

一种模块化航空有源滤波器的研究

 航空有源滤波器(AAPF)是解决飞机供电系统中电能质量问题的一种先进方案,而模块化设计对航空有源滤波器灵活性、可维护性和可靠性的提升作用巨大。首先提出并研究了一种新型模块化航空有源滤波器,分析了主电路数学模型及其混合载波PWM(CH-PWM)调制方式;其次基于损耗对比分析进行了主电路拓扑优化,推导了模块均压控制律并给出了系统控制策略;最后进行了仿真和实验验证。结果表明,模块化航空有源滤波器能够有效补偿航空电网中由典型非线性负载产生的谐波和无功电流分量,三相电网电流的总谐波畸变率(THD)均在5%以下,补偿效果显著。     

Modified Barker Code Approximating Huffman's Impulse-Equivalent Sequence

It is shown by use of D.A. Huffman's polynomial representation for a finite sequence of contiguous pulses in a pulse train that Barker's binary-coded sequences can be modified, by a weighting of pulse amplitudes, to a condition where time sidelobes in the pulse compressed signal are substantially reduced. In such a pulse amplitude modification there is a sacrifice in pulse train energy since each pulse does not have maximum energy. Results here are provided for Barker's sequence of length 13 only.     

转子后总压旋态误差的研究

总压测量时,测点气流的真实总压是p~*(不考虑探针的干扰),而探针感受到的压力是p_(?)转子后旋态使气流方向有大幅度变化(如图1,在近场尾迹中可达40°),因此一般p_(?)不一定与真实压力恒等,测试系统最后得到指示压力P_(?)工程上一般要求总压的质量平均值p_m~*,而在指示端得到的是指示压力的时间平均值芦p_(H(?)),故旋态误差为