CW alternatives to the coherent pulse train-signals and processors

Continuous wave (CW) signals phase modulated by a periodic waveform, and their corresponding receivers, are discussed. The combined response in delay and Doppler is almost identical to the (ideal) response of the coherent pulse train. The receivers are matched to an integral number N of modulation periods of the transmitted signal. CW implies a duty cycle of 100%. However, the signal duration need not be longer than N+2 periods. The CW signals have the advantage that their peak power is equal to the average power. Their disadvantages are more complicated receiver processing and the need for two antennas     

Cascaded detector for multiple high-PRF pulse Doppler radars

A postdetection design methodology for a multiple high-pulse-repetition frequency (PRF) pulse Doppler radar has been developed. The postdetection processor consists of an M out of N detector where range and target ambiguities are resolved, followed by a square-law detector which enhances the minimum signal-to-noise (S/N) power-ratio per pulse burst performance. For given probabilities of false alarm and detection, formulas are derived from which the three thresholds associated with the cascaded detector can be found. Fundamental tradeoffs between the minimum S/N required, number of ghosts, and the number of operations (NOPs) that the cascaded detector must perform are identified. It is shown that the NOPs and the number of ghosts increase and the minimum S/N required decreases as the binary M out of N detector passes more detections to the square-law detector     

False alarm control using Doppler estimation

A technique which uses maximum-likelihood estimates (MLEs) of target Doppler and target amplitude is developed for rejecting clutter residues. Multiple estimates are made and consistency checks are applied to the estimates. Simulation results indicate that for large clutter-to-noise ratios (C/N⩾55 dB) the probability of false alarm from clutter residues is reduced from 1.0 to below 0.01     

Tracking multiple targets with correlated measurements andmaneuvers

The problem of tracking N targets with correlation in both measurement and maneuver statistics is solved by transforming to a coordinate frame in which the N targets are decoupled. For the case of N identical targets, the decoupling is shown to coincide with a transformation to a set of nested center-of-mass coordinates. Absolute and differential tracking accuracies are compared with suboptimal results to show the improvement that is achieved by properly exploiting the correlation between targets     

On the uniform sampling of a sinusoidal signal

It is generally accepted that a monochromatic signal such as sin 2πWt (W>0) must be sampled at a uniform rate greater than the ostensible Nyquist rate of 2W samples per to effect a reconstruction of the signal. It is shown that a sinusoid of frequency W Hz is completely determined by its samples taken at the uniform rate of 2r samples per second, where r>0 is arbitrary subject only to the restriction that W ≠kr for any positive integer k. In particular, a pure sinusoid may be sampled uniformly without loss of information at arbitrarily small rates     

Adaptive canceler and pulse compressor interactions

Performance results for the sidelobe level of a compressed pulse that has been preprocessed through an adaptive canceler are obtained. The adaptive canceler is implemented using the sampled matrix inversion algorithm. Because of finite sampling, the quiescent compressed pulse sidelobe levels are degraded due to the preprocessing of the main channel input data stream (the uncompressed pulse) through an adaptive canceler. It is shown that if N is the number of input canceler channels (main and auxiliaries) and K is the number of independent samples per channel, then K/N can be significantly greater than one in order to retain sidelobes that are close to the original quiescent sidelobe level (with no adaptive canceler). Also it is shown that the maximum level of degradation is independent of whether pulse compression occurs before or after the adaptive canceler if the uncompressed pulse is completely contained within the K samples that are used to calculate the canceler weights. This same analysis can be used to predict the canceler noise power level that is induced by having the desired signal present in the canceler weight calculation     

The autocorrelation of m-sequences over nonprime finitefields

Nonbinary m-sequences (maximal length sequences) for spread-spectrum communication systems that have a two-level autocorrelation are presented. The autocorrelation function of an m -sequence over the Galois field of q elements GF(q), where q=p^k, for p a prime and k an integer greater than 1, is developed and shown to be bilevel when the elements of GF(q) are expressed as elements of a vector space over the pth roots of unity     

Mismatched-filter design for periodic binary phased signals

A mismatched filter design is introduced whereby the receiver filter coefficients are optimized with the property that all sidelobes of the cross-correlation function (CCF) are zero. Some results are given for binary sequences and the associated mismatched filters. For each length N>2 there exist at least one sequence and an associated mismatched filter with an ideal impulselike CCF, which means that there are no sidelobes at all in the receiver output signal     

Estimation of radar detection and false alarm probability

The accuracy with which detection and false alarm probabilities can be estimated with a limited amount of measured radar data is addressed. A simple simulation method for estimating the statistical performance of a radar detection system is presented. Confidence limits and a rule of thumb for accuracy for the estimated probabilities are presented along with procedures for calculating them. It is concluded that the minimum value of N used in a detection radar signal simulation should be 10/P_FA when the simple simulation method is used, where P_FA is the probability of false alarm, and that a value closer to 100/P _FA is preferable     

Efficient algorithms for finding the K best paths througha trellis

A set of algorithms is presented for finding the best set of K mutually exclusive paths through a trellis of N nodes, with worst-case computation time bounded by N³log n for a fixed-precision computation. The algorithms are based on a transformation of the K-path trellis problem into an equivalent minimum-cost network flow (MCNF) problem. The approach allows the application of efficient MCNF algorithms, which can obtain optimal solutions orders of magnitude faster than the algorithm proposed by J.K. Wolf et al. (1989). The resulting algorithms extend the practicality of the trellis formulation (in terms of required computations) to multiobject tracking problems with much larger numbers of targets and false alarms. A response by Wolf et al. is included     

Finding the best set of K paths through a trellis withapplication to multitarget tracking

A solution is presented to the problem of finding the best set of K completely unmerged paths through a trellis with M _i⩾K states at depth i in the trellis, i=0, 1, 2, . . ., N. Here, `best set' means that the sum of the metrics of all K paths in the set is minimized, and `completely unmerged' means that no two paths pass through a common state. The solution involves using the Viterbi algorithm on an expanded trellis. This result is then used to separate the tracks of K targets optimally in a simplified model of a multitarget radar system. The model includes measurement errors and false alarms, but it does not include the effects of missing detections or merged measurements     

Multiple target angle tracking using sensor array outputs

The use of the output of an array of sensors to track multiple independently moving targets is reported. The output of each sensor in the array is the sum of signals received from each of the targets. The results of direction-of-arrival estimation by eigenvalue analysis are extended to derive a recursive procedure based on a matrix quadratic equation. The solution of this matrix quadratic equation is used to provide updated target positions. A linear approximation method for estimating the solution of the matrix equation is presented. The algorithm is demonstrated by the simulated tracking of two targets. The main advantage of the algorithm is that a closed-form solution for updating the target angle estimates has been obtained. Also, its application is straightforward, and the data association problem due to uncertainty in the origin of the measurements is avoided. However, it requires the inversion of an N×N as well as other linear operations, so that the computational burden becomes substantial as N becomes very large     

Convergence bounds of an SMI/Gram-Schmidt canceler in colored noise

The performance of the sampled matrix inversion (SMI) adaptive algorithm in colored noise is investigated using the Gram-Schmidt (GS) canceler as an analysis tool. Lower and upper bounds of average convergence are derived, indicating that average convergence slows as the input time samples become correlated. When the input samples are uncorrelated, the fastest SMI algorithm convergence occurs. When the input samples are correlated then the convergence bounds depend on the number of channels N, the number of samples per channels K , and the eigenvalues associated with K×K correlation matrix of the samples in a given channel. This matrix is assumed identical for all channels     

Optimal serial distributed decision fusion

The problem of distributed detection involving N sensors is considered. The configuration of sensors is serial in the sense that the Jth sensor decides using the decision it receives along with its own observation. When each sensor uses the Neyman-Pearson test, the probability of detection is maximized for a given probability of false alarm, at the Nth stage. With two sensors, the serial scheme has a performance better than or equal to the parallel fusion scheme analyzed in the literature. Numerical examples illustrate the global optimization by the selection of operating thresholds at the sensors     

Collapsing losses of peak signal integrators

Collapsing losses are computed for systems in which the peak return of K samples of noise plus one sample of signal-plus-noise are integrated over N looks. The statistical approach, collapsing losses, and an application are described. The peak integrator is found to have substantially lower collapsing losses than conventional systems in which the average, not the peak, is integrated     

Tracking multitarget in cluttered environment

A method for multitarget tracking and initiating tracking in a cluttered environment is proposed. The algorithm uses a sliding window of length uT (T is the sampling time) to keep the measurement sequence at time k. Instead of solving a large problem, the entire set of targets and measurements is divided into several clusters so that a number of smaller problems are solved independently. When a set of measurements is received, a new set of data-association hypotheses is formed for all the measurements lying in the validation gates within each cluster from time K-u+1 to K. The probability of each track history is computed, and, choosing the largest of these histories, the target measurement is updated with an adaptive state estimator. A covariance-matching technique is used to improve the accuracy of the adaptive state estimator. In several examples, the algorithm successfully tracks targets over a wide range of conditions     

Detection performance in K-distributed and correlatedRayleigh clutters

Performance prediction for a detection system employing noncoherent integration is carried out for a chi-square family of fluctuating targets in K-distributed clutter plus noise. The detection performance for Swerling 11 targets in the K-distributed clutter plus noise is compared with that in exponentially correlated Rayleigh clutter. The results show that the performance prediction based on N pulses integrated in clutter plus noise using the K-distributed clutter model may be approximately equivalent to that using the exponentially correlated Rayleigh-distributed clutter model     

Detection probability for partially correlated chi-square targets

The probability of detection of the sum of N square-law-detected pulses is derived for the case where the signal fluctuation obeys chi-square statistics with four degrees of freedom. P. Swerling's (1960) case III and IV represent the cases where the signal is completely correlated and completely decorrelated, respectively, from pulse to pulse. An exact expression for probability of detection is derived for the condition of partial signal correlation. The results given are compared with the approximate technique commonly used to handle partial signal correlation     

Two-valued sequences with perfect periodic autocorrelation

Periodic two-valued signals which exhibit two-level autocorrelation can, in many cases, be made to yield an out-of-phase autocorrelation value identically equal to zero. This can be achieved by replacing the two values of the sequence (normally +1 and -1) with the two values +1 and e^iφ, or with +1 and β (β real). Simple expression for φ and β are given, based on the parameters of the difference set to which such signals correspond. Another strategy is to transmit a sequence of +1s and -1s, but of +1s and bs (b real and negative). An expression for b is also obtained     

CFAR data fusion center with inhomogeneous receivers

Detection systems with distributed sensors and data fusion are increasingly used by surveillance systems. A system formed by N inhomogeneous constant false alarm rate (CFAR) detectors (cell-averaging (CA) and ordered statistic (OS) CFAR detectors) is studied. A recursive formulation of an algorithm that permits a fixed level of false alarms in the data fusion center is presented, to set the optimum individual threshold levels in the CFAR receivers and the optimum `K out of N' decision rule in order to maximize the total probability of detection. The algorithm also considers receivers of different quality or with different communication channel qualities connecting them with the fusion center. This procedure has been applied to several hypothetical networks with distributed CA-CFAR and OS-CFAR receivers and for Rayleigh targets and interference, and it was seen that in general the fusion decision OR rule is not always the best