Double Dither Loop for Pseudonoise Code Tracking

A new type of phase detector for pseudonoise code tracking is introduced and analyzed in comparison with the delay lock loop (DLL) and tau-dither loop (TDL) configurations. It is shown that the double dither loop (DDL) combines the best features of the DLL and the TDL in that the DDL is insensitive to gain and offset imbalances and does not suffer the 3-dB degradation in noise performance typically associated with the TDL. The double dither concept is applicable to other dual channel detectors such as in a Costas-type carrier tracking loop.     

Effect of Particular Gain Changes upon LFM Sidelobes

The envelope variation of an LFM waveform due to transmitter droop or receiver STC tends to cause range sidelobes. A parametric analysis of the magnitude of the sidelobes has been performed. It is shown that the sidelobes can be quite high at the matched filter output, but are low at the output of the sidelobe reduction filter. 40-dB sidelobes can be achieved even with a 4-dB envelope droop. It is shown that these results are consistent with conventional paired-echo theory. Similar results are shown to hold for droop variations of the filter transfer function.     

Maritime Communications via Satellites Employing Phased Arrays

This paper examines the feasibility of providing maritime mobile telecommunications as a new service via satellites. A global system with a capacity of 10 duplex voice/data channels (plus an interrogation/reply channel) per satellite is described. The capability is achieved with a 0-dB gain UHF antenna in the ship and a UHF phased array in the satellite, which produces 11 steerable beams, each with 30-dB peak gain. The links between satellite and shore are assumed to be at SHF. A dedicated satellite weighs 320 kg, which can be launched with an up-rated Thor-Delta. The prime power requirement of 730 watts is provided by an oriented solar array.     

红外热像检测技术在吸波涂层缺陷研究中的应用

采用红外热像技术探索了一种吸波材料脱粘缺陷无损检测的方法。在铝合金基材上制备具有不同脱粘缺陷的吸波材料。采用红外热像检测系统监测热激励后材料样品表面的温度变化。通过对热图像和温度变化数据的分析,获得材料表面或缺陷的特征。试验表明这一方法可以有效地检测出铝合金基材上铁磁性吸波涂层脱粘缺陷,测量简便、结果直观,对涂层无损坏,可以实现吸波涂层施工中吸波涂层质量和使用过程中涂层可靠性的监控。     

Coherent Doppler tomography-a technique for narrow band SAR

Some concerns regarding a technique of narrowband synthetic aperture radar (N-SAR) imaging called coherent Doppler tomography (CDT), which may be a good candidate for spaceborne applications, are addressed. Using a single-frequency signal, are addressed. Using a single-frequency signal, resolution of two tenths of a wavelength can be achieved in the point spread function if the radar platform circles the ground path to be imaged. However, the high sidelobe level of -8-dB in the point spread function results in an unacceptable dynamic range. To reduce the sidelobe level, two approaches are presented: coherent processing using multiple discrete frequencies and noncoherent subaperture processing. Simulation results demonstrate that the sidelobe level is substantially reduced by both methods. However, the resolution is degraded and the computational overhead is greatly increased for noncoherent subaperture processing. Also presented is a possible satellite geometry configuration that could utilize N-SAR processing to provide high-resolution global mapping capability     

Planetary Radio Astronomy Receiver

Voyager (Mariner Jupiter/Saturn 1977) spacecraft will carry the first experiment specifically designed to measure low-frequency nonthermal planetary radio emissions. The technical aspects of the planetary radio astronomy instrument are described here. Signals from 10-m orthogonal monopoles are processed to measure polarization and for either maximum sensitivity or observation of rapid temporal variations. The 0.3-?V/?kHz (i.e., -117 dBm/kHz with a 50-12 source) sensitivity and the 140-dB dynamic range achieved allow signals to be observed from near earth through planetary encounter. Stepped-or fixed-frequency operation is commandable over a range of 1.2 kHz to 40.5 MHz with internal calibration for absolute amplitude measurement.     

A flexible processor for a digital adaptive array radar

A digital beamforming processor for an adaptive array radar is described. The functionality and the architecture of the processor are strongly driven by a goal of achieving adaptive null depths in the 60-dB to 70-dB range, which necessitates substantial preprocessing of each channel. In particular, conversion to baseband quadrature channels is accomplished digitally using a single A/D converter per channel, and FIR (finite impulse response) equalizing filters are employed in each channel to match channel transfer functions. The processor is highly modular, and this not only distributes the total processing load, but also the I/O (input/output) bandwidth requirement. This is accomplished by distributing the adaptive beamforming algorithm systolically across a linear array of processing nodes. The processor is expandable to a different number of channels and sufficiently flexible to be applied to other problems of an array signal processing nature. Experimental data presented demonstrate that the processor is capable of supporting channel-to-channel cancellation of interfering signals to the level of -65 dB     

Radar Performance with Multipath Using the Complex Angle

The complex angle (CA) method for resolving a low angle target from its multipath signal is evaluated in the presence of system noise. It is shown that standard deviation improvements of around 3-to-1 can be achieved at a 20-dB signal-to-noise power ratio relative to a normal monopulse system without the CA. It is also shown that the CA method is unbiased, giving bias improvements of as much as 100 times relative to normal monopulse. Evaluation of the assumptions in the technique shows very little sensitivity to knowledge of the reflecting surface's conductivity or dielectric constant. However, the method is somewhat sensitive to knowledge of surface roughness.     

吸波涂层用酚氧树脂粘结剂研究

选用酚氧树脂作为吸波涂层（ＲＡＣ）粘结剂，研究了溶剂、分子量、固化剂对ＲＡＣ主要力学与物化性能的影响。结果表明、酚氧树脂ＲＡＣ可室温固化，附着力、柔韧性和耐冲击性能可满足飞行器的使用要求。     

A Sequential Detector

The PRSD detector improves radar performance by controlling the distribution of energy in space, thus making a radar adaptive to its environment. An increase in performance over classical detectors may be realized in any of several ways: 1) greater maximum range; 2) smaller minimum detectable targets; 3) higher data rates; 4) lower average transmitted power, which allows smaller size and weight of equipment. The model of the PRSD detector described herein was tested with a semi-agile beam radar, and gave measured field performance improvement (for this particular radar) equivalent to an S/N increase ranging from 5 to 22 dB with a mean of 9.5 dB. This increase is greater than the 5-dB improvement predicted for the system in a white noise environment because many of the field tests were at locations subjected to heavy interference. The PRSD detector was extremely effective reducing the interference. In this paper, we will briefly review the theory of operation, describe the equipment and the method of test, and present experimental data. The data presented here are essential to a complete understanding of sequential detection since a rigorous theory encompassing multiple range bin radar has not been developed at this time. Finally, an extensive bibliography is appended.     

Enhanced variable dimension filter for maneuvering target tracking

An enhancement of the variable dimension (VD) filter for maneuvering-target tracking is presented. The use of measurement concatenation, a procedure whereby fast sampled measurements are stacked while maintaining their proper relationships with the states, leads to significant reduction in estimation error by low processing rate algorithms. The use of double decision logic (DDL) for the maneuver onset and ending detection as well as appropriate procedures for reinitialization of the estimation filters results in improved maneuver detection and filter adaptation. Simulation results show the performance of the proposed enhanced variable dimension (EVD) filter     

Analog clutter cancellation algorithms for dynamic range reduction

A technique that effectively reduces the dynamic range of the input signal in a radar receiver prior to digitization is presented. The dynamic range reduction is accomplished through a process that predicts the next radar return signal from the previous return signals, generates a replica waveform, and subtracts this replica waveform from the radar return signal prior to digitization. This process allows the radar return signal to be digitized without distortion by an analog-to-digital converter (ADC) having a limited dynamic range. The full dynamic range of the radar return signal is then restored by adding the replica waveform to the ADC output. Test and evaluation results using both synthetic and recorded radar data demonstrate in excess of a 30-dB reduction in the dynamic range of the signal at the ADC input when strong clutter is present     

An X-Band Focussed-Beam Interferometer for Plasma Diagnostics

A microwave interferometer which permits the measurement of phase shift in a plasma independent of propagation path attenuation over a 30-dB dynamic range is described. Results are presented from an experimental evaluation of measurement accuracy of the interferometer instrument.     

SNR/bandwidth tradeoff in coherent radar sampling

It is shown that if the pulse-repetition frequency of a coherent pulse-Doppler radar is at least twice the Doppler bandwidth, one may, using appropriate downconversion, sample the radar signal at half the Nyquist rate with no loss in range resolution and no folding of Doppler frequencies. This results in a 3-dB loss of signal-to-noise ratio     

Detection Performance of Logarithmic Receivers Employing Video Integrators

The detection performance of logarithmic receivers in Rayleigh and non-Gaussian clutter is investigated. In Rayleigh clutter the performance is determined for steady, Swerling case 1, and Swerling case 2 targets. The detection loss of logarithmic receivers is generally less than the ? log n loss conjectured by Green, but consistent with the 1.08-dB asymptotic loss established by Hansen. The Swerling case 2 loss, important in frequency- agility applications, canbe severe for a small number of integrated pulses and high Pd, and apparently approaches the 1.08-dB asymptotic loss as a lower bound. Graphs of GramCharlier series cumulants are provided to allow determination of logarithmic-receiver performance. Curves are presented to allow the detection performance of logarithmic receivers in log-normal and Weibull clutter to be determineds.     

Performance Degradation of MTI Circuits Due to Amplitude Limiting

The loss in output signal-to-noise ratio (SNR) due to amplitude limiting is obtained for a radar circuit consisting of a bandpass limiter, coherent demodulator, matched filter, and moving-target-indicator (MTI) filter. The circuit is used in scanning MTI radars. The tandem connection of the limiter and coherent demodulator is a model for the saturation of the intermediate-frequency (IF) demodulator of an MTI radar. Results on special functions are used to obtain simple formulas for the loss in output SNR relative to a linear IF demodulator when the input SNR is less than -15 dB and the number of hits per 3-dB beamwidth exceeds 15.     

飞行器表面电磁缺陷及雷达吸波材料应用

从飞行器表面电磁特性和电磁缺陷分析入手,就如何使用雷达吸波材料进行了探讨,提出了采用雷达吸波材料或特种良导电材料,针对电磁缺陷进行修复的雷达吸波材料应用思路。该方法可减少雷达吸波材料的使用量,从而减轻飞行器重量,提高其性能,降低成本,改善维修性。并进行了试验验证。     

基于MATLAB的样条插值

首先论述了VC和MATLAB各自的优缺点,然后提出了VC与MATLAB混合编程的三种方法。并详细阐述了如何通过基于动态链接库(DLL)实现VC和MATLAB混合编程的技术,重点介绍了在MATLAB生成动态链接库中封装开发好的算法,以及如何在集成环境中调用DLL,并实现了Cardinal样条插值。该方法充分发挥了VC和MATLAB各自的优势,提高了编程效率,为科学技术研究提供了强大的技术支持。     

Directivity-Bandwidth Limitations on Retrodirective Data Links

In a retrodirective array, frequencies differing from the pilot signal retrodirect at different angles from that of the pilot. For the retrodirected beamwidth to cover the reception point over the desired bandwidth, the product of directivity and fractional bandwidth squared cannot exceed a maximum value. This value is dependent only upon the angular retrodirection range, with smaller angular ranges allowing a higher product. For example, a ±30 degree angular range and 5 percent bandwidth allows 36-dB directivity.     

Tribological performance of hydrogenated diamond-like carbon coating deposited on superelastic 60NiTi alloy for aviation self-lubricating spherical plain bearings

It is imperative to develop a novel matching of metallic substrate and self-lubricating coating for aircraft spherical plain bearing in a wide range of service conditions. As a new type of superelastic material, 60NiTi alloy meets the performance requirements of aerospace bearing materials, but exhibits poor tribological performance, especially under the conditions of dry sliding friction. A Hydrogenated Diamond-Like Carbon (H-DLC) coating was deposited on the 60NiTi alloy to improve its tribological performance. The microstructure and mechanical behavior of the 60NiTi alloy and its H-DLC coating were explored. Results show that improvement of friction and wear performance of the H-DLC coating deposited on the 60NiTi substrate is mainly achieved by graphitization at the friction interface and the transfer film produced on the counterpart ball. The increased friction load leads to intensification of graphitization at the friction interface and formation of continuous and compact transfer film on the surface of the counterpart ball.