共查询到20条相似文献,搜索用时 359 毫秒
1.
针对现代无人机上采用非线性飞行控制的趋势,概述了动态逆方法的发展、特点及应用。结合无人机飞行控制特点,基于奇异摄动原理,将无人机非线性运动方程分解为快慢不同的3个模态,采用动态逆方法设计了无人机非线性状态逆控制器,仿真结果表明,动态逆控制器能够较好地实现对无人机的跟踪控制。 相似文献
2.
针对航天器编队飞行时相对位置保持精度要求高的特点,采用基于线性变参数模型的多项式特征结构配置方法设计椭圆轨道航天器间相对位置控制算法。对于线性变参数控制系统,本文将基于线性定常系统的多项式特征结构配置方法推广以确保系统性能与变化参数间的独立性。在特征结构配置时,先设计带参数变化的控制器结构后计算出带未知控制器增益的设计闭环传递函数,接着将其与含有闭环系统性能的期望传递函数在三个条件下进行匹配,进而获得未知控制器增益的表达式。在设计实际控制椭圆轨道编队飞行MIMO相对位置保持算法时,将系统期望传递函数设为解耦形式来实现三轴位置控制间的解耦控制,达到提高系统控制性能的目的。最后进行相应的数学仿真,其结果表明该算法能够保证系统的高精度位置保持要求。 相似文献
3.
4.
5.
6.
小型无人机自主飞行控制系统的实现 总被引:9,自引:0,他引:9
介绍了5kg级小型无人机的结构原理,分析了无人机自主飞行控制系统的结构、功能、特点及控制原理,采用嵌入式系统、GPS、电子罗盘和红外传感器等设计了无人机的飞行姿态控制、导航控制、任务控制系统和弹射与伞降系统。大量飞行实践和比赛飞行表明,这种小型无人机可执行既定任务并具有良好的场地适应性和自主飞行性能。 相似文献
7.
8.
9.
10.
无人机神经网络动态逆控制器设计研究 总被引:1,自引:1,他引:0
针对无人机动态逆控制器存在的明显缺陷,采用在线神经网络对逆误差进行补偿,设计了神经网络动态逆控制器.构造了一种单隐层神经网络结构,证明了整个闭环系统的稳定性,给出了稳定的在线神经网络权值调整算法.通过仿真验证了该方案的鲁棒性、对故障的适应性以及在作动器纯延时下的响应性能,证明了在线神经网络对动态逆控制器具有明显的改善作用.对于无人机先进飞行控制系统的设计研究具有重要的参考价值. 相似文献
11.
介绍了一种新的刚体转动的四元数模型。这些模型可以提高再定向控制的对边界条件的适应能力,在此基础上还介绍了这些模型的一些实际应用。 相似文献
12.
A. A. Davydov 《Cosmic Research》2011,49(4):335-344
A communication satellite (small spacecraft) injected into a geosynchronous orbit is considered. Flywheel engines are used
to control the rotational spacecraft motion. The spacecraft after the emergency situation has passed into a state of uncontrolled
rotation. In this case, no direct telemetric information about parameters of its rotational motion was accessible. As a result,
the problem arose to determine the rotational satellite motion according to the available indirect information: current taken
from the solar panels. Telemetric measurements of solar panel current obtained on the time interval of a few hours were simultaneously
processed by the least squares method integrating the equations of rotational satellite motion. We present the results of
processing 10 intervals of the measurement data allowing one to determine the real rotational spacecraft motion and to estimate
the total angular momentum of flywheel engines. 相似文献
13.
The problem of optimal control over many-revolution spacecraft orbit transfers between circular coplanar orbits of satellites is considered. The spacecraft flight is controlled by a thrust vector of a jet engine with restricted thrust (JERT). The mass expenditure is minimized at a limited time of flight. The optimal control problem is solved based on the maximum principle. The boundary value problem of the maximum principle is solved numerically using the shooting method. A modified computation scheme of the shooting method is suggested (multi-point shooting), as well as a method (correlated with the scheme) of choosing the initial approximation with the use of a solution to the optimization problem in the impulse formulation. The scheme and method allow one to construct many-revolution spacecraft orbit transfers. 相似文献
14.
热变形对天线指向机构的指向精度具有重要影响,但利用传统的设计方法很难实现对指向精度的准确计算,尤其是热变形对指向精度影响的研究工作更是少见。为此建立了机构的三维实体热-结构耦合有限元分析模型,根据有限元分析结果并结合机构的运动链关系,构建了各关键运动副运动误差的计算方法;在此基础上实现了机构指向误差的计算,研究了运动副名义、最大以及最小配合间隙条件下,温度载荷对各关键运动副运动误差和指向精度的影响。研究结果表明,温度载荷对关键运动副的运动误差以及机构的指向精度具有重要影响,随着温度载荷偏离常温数值的增加,指向误差不断增大,名义配合间隙条件下的指向误差最大。 相似文献
15.
16.
17.
18.
金属网由于柔韧性好、使用方便等优势而在电缆屏蔽工程上得到广泛应用。本文对电缆用的金属网屏蔽效能进行工程计算,通过计算,对金属网不同材料、不同规格、单层与双层屏蔽及有缝隙情况下的屏蔽效能进行比较与分析,对工程应用有一定的指导意义。 相似文献
19.
为满足航天器微振动环境模拟的需要,开展了多自由度微振动时域波形复现控制方法研究。首先,介绍了基于时域波形复现的多自由度微振动环境模拟控制理论方法。其次,针对六自由度微振动激励系统,应用MATLAB软件建立了基于实测传递函数矩阵的多输入多输出微振动激励仿真系统,针对微振动时域波形复现闭环控制过程进行了算法编程,并给出了仿真的闭环控制流程图。最后,通过算例对多自由度微振动时域波形复现进行了数值仿真,以给定的白噪声为输入,模拟对实际存在的系统非线性、测量误差等影响因素的控制效果。仿真结果验证了多自由度微振动时域波形复现控制方法的可行性及有效性,所得结论可以为研究多自由度微振动时域波形复现控制系统提供参考。 相似文献
20.
The problem of determining an estimation of current spacecraft motion parameters on the stage of its descent is solved on the basis of readings of an optoelectronic navigation system and additional information from the self-contained inertial navigation system at the most general assumptions on the nature of motion of the object and the statistical properties of the noise of the measuring devices. 相似文献