Effects of Band Limiting on the Detection of Binary Signals

PCM/NRZ systems operating in the presenceof noise and in a band-limited channel areconsidered. Two types of bit detectors arestudied, integrate and dump, and sample. Theincreased signal power needed to give thesame performance as an optimum detectorand a broad-band channel is computed. Theresults depend on the bit pattern. The averageeffect of band-limiting over all bit patternsand two extreme cases are plotted for eachdetector. The results show that integrate anddump is always superior to sample and that ifthe sample detector is used, one should bandlimit before sampling at a frequency of 0.6times the bit rate.     

极弱信号环境下GPS位同步和载波跟踪技术

为解决环路未锁定、无法找出正确的导航数据位跳变点时极弱全球定位系统(GPS)信号跟踪问题,通过分析信号跟踪模型和相关器1 ms采样数据特性,将最优路径动态规划算法应用于GPS位同步,并提出基于平方根无迹卡尔曼滤波(SRUKF)和位同步结合的载波联合跟踪算法。建立了适合位同步的SRUKF载波环参数估计模型,针对位同步的实现条件和无相位频率先验信息的情况,将位同步模块提前,研究设计了环路未锁定时串行和并行两种弱信号跟踪方案。位同步跟踪完成后环路采用单独的SRUKF工作方式。实验结果证实该文提出的算法具有较高的数据位边缘检测概率(EDR)和参数估计性能,而无须关心环路是否处于锁定状态,能够对载噪比低至22 dB/Hz的弱信号实现跟踪。     

PCM/FM aeronautical telemetry in frequency selective multipath interference

The performance of PCM/FM using a delay-line detector in multipath interference is analyzed. In aeronautical telemetry applications, the multipath interference causes a in the signal spectrum which is web modeled by a channel composed of a line-of-sight signal and a strong specular reflection with magnitude /spl Gamma/ and excess delay less than a bit time. Analysis shows that the bit error probability is strongly dependent on the location of the within the spectrum. The bit error probability averaged over the location is also analyzed. For the case of no predetection filtering, the average bit error probability is dependent on the depth of the but not on the width. The loss in performance (relative to the AWGN environment) is bounded by (1-/spl Gamma/)/sup -2/ which is the depth of the . For the case of predetection filtering, the average bit error probability is dependent on both the width and depth of the . The performance loss is bounded by (1-/spl Gamma/)/sup -2/spl Gamma// which is less than that for the case of no predetection filtering.     

数据电路误码的模拟方法

分析数据电路中不同调制方式下的误码分布,对随机数进行数学变换产生不同的误码图案,从而给出数据电路模拟器中误码的模拟方法。     

On the Acquisition Time for an Apollo Ranging Code

An Apollo ranging system is considered whose phase reference is obtained by a phase-locked loop for bit synchronization. The bit phase reference is noisy, and the error probability for the ranging code is shown to depend on the input signal energy per bit to noise density ratio. The procedure of computing the acquisition time for the ranging code is then presented and the acquisition time for a lunar ranging code is plotted versus the input signal-to-noise density ratio.     

Optimum Estimation of Bit Synchronization

In digital communication systems, optimum estimation and detection algorithms require that precise knowledge of the bit transition time be known to the receiver before bit-by-bit detection can be made. This paper presents the derivation of Bayes or maximum a posteriori estimation algorithms for optimum estimation of bit timing. Performance of the optimum system is evaluated and suboptimal realizations suggested.     

CAN总线位定时控制的研究

在研究了CAN总线位定时工作原理的基础上,为优化网络性能,实现CAN通信网同步,该文提出了一种对CAN通信网波特率、采样点位置及数目的计算方法。在参数计算中主要考虑时钟频偏和传输延时两个因素,并通过具体的CAN通信网说明如何分步计算位定时参数。     

北斗导航接收机高增益相干积分算法

近年来,针对弱信号的高灵敏度接收机已逐渐成为国内外的研究热点。加长相干积分时间可以提高信噪比,从而跟踪到更弱的信号。但是,北斗导航接收机跟踪环路并不可以无限加长相干积分时间,相干积分时间的长短和功效还受到卫星导航电文比特跳变的限制。为了消除导航电文比特跳变对相干积分的影响,提出了一种改进的基于最大似然估计的北斗信号位同步方法,完成位同步后再利用先猜后检的方法便可以实现长相干积分。利用软件接收机进行编程设计,仿真结果表明：该长相干积分算法能够稳定可靠地实现对弱信号的跟踪,20ms相干积分环路信噪比约提升12dB,40ms相干积分环路信噪比约提升15dB,80ms相干积分环路信噪比约提升17dB,提高了北斗导航接收机的灵敏度。     

湍流信道条件下大气无线光通信系统差错性能分析比较

介绍了湍流信道条件下光强闪烁的对数正态分布模型和负指数分布模型,仿真分析比较了两种信道模型条件下无线光通信系统的差错性能。仿真结果表明,平均接收功率相同时,弱湍流条件下,系统的误比特率明显低于强湍流的情况;误比特率为10。时,弱湍流信道闪烁指数为0．25情况下,系统所需的平均接收光功率为-51．5dBm,而强湍流下,系统所需的平均接收光功率为一17．1dBm,比弱湍流下多需34．4dB的平均接收光功率。分析结果表明,弱湍流对数正态分布信道模型和强湍流负指数分布模型不能很好地描述中湍流信道模型,对此有待进一步研究。     

Multiplexing Asynchronous Signals Using Bit Stuffing and Retiming Techniques

This paper discusses the problem of multiplexing asynchronous signals which are clocked from independent sources. Two solutions are offered to this problem: one provides a continuous transmission over a fixed period of time proportional to the bit rate integrity duration, and the other utilizes a bit stuffing technique. The former approach is used when the asynchronous signals are clocked from highly stable clocks, and also when the bit rate integrity period is on the order of a few hours. The latter approach is employed when the signal clocks are relatively less stable or the bit rate integrity period is very long. The reliability of these techniques is analyzed, and their efficiencies are evaluated and found to be most satisfactory. Synchronization procedures and probabilities of false lock and failure to lock are also described. In addition, a multiplex system illustrating these techniques is presented. The system multiplexes four input channels at a one megabit rate for each.     

脉冲等离子体推力器的性能分析

脉冲等离子体推力器(PPT)的性能受多方面因素的影响,包括放电参数以及推力器本体结构等。通过对脉冲等离子体推力器的工作原理和物理学模型的分析,研究了PPT的效率、比冲、推力、元冲量、推功比等性能参数与电极结构、电气参数的关系,并设计了实验,对效率、比冲、元冲量等与放电能量、电极间距的关系进行了验证。结果表明,效率、比冲、元冲量均随放电能量的提高而增大,元冲量在电极间距为50 mm时大于间距为30 mm、40 mm时的值。根据实验结果,提出了设计高性能PPT的一些优化条件,对PPT的设计有参考意义。     

Extrapolation Technique for Long Term Bit Error Rate Determination

An extrapolation method is presented for determination of characteristic curves of long term bit error rate (BER) versus signal-to-noise ratio (SNR) for digital communication equipment. The method is to obtain a single reliable data point at a BER of 10-4 or 10-5 and then to draw a theoretically shaped curve through this reference. The technique is validated by both theoretically and experimentally demonstrating that variations of the internal anomalies that contribute to bit errors in digital communications receivers cause the BER curves to shift laterally, but that the curves retain their characteristic shape. Use of this extrapolation method can reduce test time by 3 to 4 orders of magnitude.     

Noncoherent Detection of Split-Phase FSK by Multiple Predetection Filtering

When the cumulative drift in the center frequency of a binary split-phase FSK signal exceeds the peak deviation of the signal, a conventional noncoherent receiver (i.e., one provided with only two IF filters) may be unable to achieve the probability of error per bit which the designer desires. This limitation may be overcome if the receiver is provided with a bank of more than two contiguous filters (each followed by an envelope detector) tospan the total IF band the instantaneous IF signal might occupy. It is shown that the probability of error per bit for such a receiver is a function of 1) the ratio F of peak frequency deviation to peak frequency drift, 2) the number M of IF filter/detectors, and 3) the signal-to-noise ratio ? in the output of the filter containing the signal. It is further shown thatfor a given value of F an increase in M reduces the amount of transmitter power the communication system designer must provide to yield a given probability of error per bit.     

基于MC68376的CAN总线系统节点设计

阐述了Motorola公司生产的32位微控制器MC68376的TouCAN模块的硬件设计和软件编程技术。并重点介绍了CAN节点位定时的设置方法。     

MACH2 simulations of a micro laser ablation plasma thruster

In this work the detailed physical processes occurring in the high density plasma that is ejected from the solid propellant surface in a small laser ablation thruster are simulated using MACH2. Qualitative results of the laser ablation process that leads to propellant erupting from the surface and leaving behind a crater in a solid Teflon® propellant are presented. Simulations were conducted for a 0.5 μs laser pulse (FWHM) at 935 nm with laser pulse energy ranging from 20 μJ to 2 mJ. Simulation results indicate that crater diameter and depth increase with pulse energy. The impulse bit also increases with pulse energy. Specific impulse follows the opposite trend and decreases with laser pulse energy. The simulated impulse bit for a 2 mJ, 0.5 μs laser pulse over-predicts that reported in the literature for a 2 mJ, 2 ms laser ablation thruster pulse by approximately one order of magnitude and under-predicts the specific impulse by approximately one order of magnitude.     

小钻头设计与制造的改进

在机械制造中，小钻头容易破损。文章根据小钻头破损的原因，对小钻头的设计、制造及其使用提出一些改进意见及措施。     

ACAS接收机S模式信号处理算法及其实现

ACAS接收机S模式信号处理主要包括前导码检测、位与位置信度的判决、错误检测以及纠错等主要算法,分别对这些算法进行了详细研究,并用FPGA实现了这些算法。仿真结果说明该实现能够对S模式接收信号成功地解调、纠错译码。     

量化对GPS接收机捕获性能影响的研究

由于接收机输入端的信噪比对接收机的捕获性能具有很重要的意义,所以要尽量减少接收机输入端信噪比的损失。本文首先给出了含高斯白噪声的GPS信号经过不同量化位数和量化电平的量化器后的输出信噪比计算公式;然后,在此基础上分析其对接收机捕获性能的影响;最后,仿真实验表明,接收机可以在不影响捕获性能的情况下,尽量选择合适的量化位数和量化门限。实验结果也为量化器的设计提供了重要的技术参考。     

Selecting a programming language for your project

Since the mandate was dropped that the Ada language had to be used in all DoD projects, software managers have had more freedom to choose which programming language to use on their DoD projects. For most new DoD software projects that need a general purpose high-level language, Ada, C, or C++ are the main contenders, with increasing attention paid to the new language celebrity, Java. Furthermore, multilanguage systems seems to be getting increasingly popular. As a result, companies offer integrated multilanguage programming environments. Although each programming language has its own strengths and weaknesses, the reason for choosing a particular language may ultimately be based on factors having nothing to do with the technical merits of the language itself. Such factors may include the availability of compilers for the host/target, the maturity and efficiency of available compilers, the availability of programmers who already know the language, whether the language can easily interface with existing systems such as graphical user interfaces or data bases, the existence of legacy software written in a specific language, or how well the language fits in with adopted COTS products. A few common misconceptions that may affect the choice of a programming language are listed     

Sequential Piecewise Recursive Filter for GPS Low-Dynamics Navigation

The design, implementation, and performance of a real-time estimation algorithm, referred to in this paper as the sequential piecewise recursive (SPWR) algorithm, for the global-positioning system (GPS) low-dynamics navigation system is described. The SPWR algorithm for this application was implemented in single precision arithmetic (32 bit, floating point). Numerical results are presented covariance and filter gains at a slower rate than the state measurement update, and it uses U-D factor formulation to perform covariance computations. The SPWR algorithm saves real-time processing requirements without appreciable degradation of filter performance. Another important feature of the SPWR algorithm is that it incorporates pseudorange and delta-range data from each GPS satellite sequentially for navigation solution. The SPWR algorithm, for this application, was implemented in single precision arithmetic (32 bit, floating point). Numerical results are presented.