| 关于提高数控加工劳动生产率的研究 |
| |
| 引用本文： | 李秋丰,郭榕宾.关于提高数控加工劳动生产率的研究[J].洪都科技,2007(1):42-47,41. |
| |
| 作者姓名： | 李秋丰 郭榕宾 |
| |
| 作者单位： | 洪都航空工业集团 |
| |
| 摘 要： | 数控加工技术在航空工业的运用越来越广泛,提高数控加工劳动生产率是企业关注的热点。本文通过对集团公司重点单位数控机加厂数控加工现状的典型调查、分析,找出其存在的问题,针对性地提出了改进的措施及建议,并结合改进的效果,对集团公司数控加工今后的发展作了设想。
|
| 关 键 词： | 数控加工 劳动生产率 |
| 收稿时间： | 2006-12-27 |
| 修稿时间： | 2006-12-27 |
Research on Labor Productivity Improvement in NC Machining Work |
| |
| Li Qiufeng,Guo Rongbing.Research on Labor Productivity Improvement in NC Machining Work[J].Hongdu Science and Technology,2007(1):42-47,41. |
| |
| Authors: | Li Qiufeng Guo Rongbing |
| |
| Institution: | Hongdu Aviation Industry Group |
| |
| Abstract: | NC machining technology has been used in aviation industry increasingly, which presents the emphasis of labor productivity improvement in NC machining work. This paper points out the existing problems and puts forward suggestions on improvement based on investigations and analysis of some typical cases, and make the envisagement of NC machining work in Hongdu. |
| |
| Keywords: | NC machining Labor productivity |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
