首页 | 本学科首页   官方微博 | 高级检索  
     

不同形状喷嘴的旋流冲击射流压力损失和传热特性实验
引用本文:徐亮,任德祖,马永浩,兰进,高建民. 不同形状喷嘴的旋流冲击射流压力损失和传热特性实验[J]. 航空动力学报, 2018, 33(11): 2678-2686. DOI: 10.13224/j.cnki.jasp.2018.11.014
作者姓名:徐亮  任德祖  马永浩  兰进  高建民
作者单位:西安交通大学 机械制造系统工程国家重点实验室,西安 710049
基金项目:国家重点研发计划项目(2018YFB1106405); 陕西省自然科学基金(2015JQ5126); 中央高校基本科研业务专项基金(xjj2018044)
摘    要:提出了一种旋流喷嘴,即圆孔内径设有四条螺旋槽道的类螺纹孔喷嘴。实验对比研究了同一螺旋角下三类旋流喷嘴(插件、内置扭转带、导叶片)与螺纹孔喷嘴在雷诺数为6000、12000下靶面传热特性。分析了各喷嘴对应的气源室压力与流量系数。实验结果表明,螺纹孔喷嘴在靶面的中心区保持了高的传热效率,驻点努塞尔数比其他三种喷嘴高出29.7%~43.3%,当射流空间受限时(半封闭空间)所有喷嘴的努塞尔数下降了40%~60%,内置插件喷嘴下降幅度最大;另外,四种旋流喷嘴中,内置插件喷嘴的气源腔室压力最大,比最小的螺纹孔喷嘴高出一个数量级还多,压力损失系数的分析表明螺纹孔喷嘴的压力损失系数最小,仅是内置插件喷嘴的1/4左右,且雷诺数增大一倍,内置插件喷嘴的压力损失系数平均下降14%,下降幅度最大。 

关 键 词:旋流冲击射流   旋流实验装置   旋流结构   螺纹孔喷嘴   换热   压力损失系数
收稿时间:2017-07-21

Pressure loss and heat transfer characteristics experiment of swirling impinging jet with different shape nozzles
Abstract:A type of swirl nozzle, i.e., a threaded hole nozzle with four spiral grooves on the diameter of the hole was proposed. The heat transfer characteristics of the three kinds of swirl nozzles (insert, built-in torsion belt and guide vane) with the helical hole nozzle at the same helix angle when the Reynolds numbers were 6000,12000 were investigated. The pressure and flow coefficient of the air supply chamber corresponding to each nozzle were analyzed. The experimental results showed that the spiral hole nozzle had a high heat transfer efficiency in the central area of the target surface, and the stagnation Nusselt number was 29.7%-43.3% higher than the other three nozzles. When the jet space was limited (semi-enclosed space), the Nusselt number of dropped down by 40% to 60%, and the built-in plug nozzles had the largest drop. In addition, the four kinds of swirl nozzles had the largest air supply chamber pressure of the built-in plug nozzle, one order of magnitude higher than the smallest screw hole nozzle. The analysis of the pressure loss coefficient showed that the pressure loss coefficient of the nozzle hole was the smallest, only about 1/4 of the built-in plug nozzle, the Reynolds number was doubled, and the pressure loss coefficient of the built-in plug nozzle dropped by 14% on average.
Keywords:swirling impinging jet  swirl jet experimental device  swirl structure  screw hole nozzle  heat transfer  pressure loss coefficient
点击此处可从《航空动力学报》浏览原始摘要信息
点击此处可从《航空动力学报》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号