| MEMS热膜式壁面剪应力传感器微弱信号检测 |
| |
| 引用本文： | 孙海浪,田于逵,金磊,张璇,谢华. MEMS热膜式壁面剪应力传感器微弱信号检测[J]. 实验流体力学, 2017, 31(2): 39-43. DOI: 10.11729/syltlx20170016 |
| |
| 作者姓名： | 孙海浪 田于逵 金磊 张璇 谢华 |
| |
| 作者单位： | 1.中国船舶科学研究中心, 水动力学国防科技重点实验室, 江苏 无锡 214082 |
| |
| 基金项目： | 国家重大科学仪器设备开发专项2013YQ04091107 |
| |
| 摘 要： | MEMS热膜式壁面剪应力传感器的输出信号是带有基础电压的微弱电压信号,无法通过放大器直接放大的方法实现高精度测量。文章提出在输出信号放大前增加信号平衡环节,在保留有效信号的前提下减小基础电压,再通过放大的方法实现其高精度测量,有效解决了MEMS热膜式壁面剪应力传感器微弱信号检测的难题。文章介绍了MEMS热膜式壁面剪应力传感器微弱信号检测的技术方案、关键技术、测试检验及试验应用实例。
|
| 关 键 词： | 微机电系统 热膜 壁面剪应力 传感器 微弱信号检测 |
| 收稿时间： | 2016-12-15 |
Weak signal detection of MEMS hot-film wall shear stress sensors |
| |
| Affiliation: | 1.National Key Laboratory of Science and Technology on Hydrodynamics, China Ship Scientific Research Center (CSSRC), Wuxi Jiangsu 214082, China2.Hangzhou Onforever Power Technology Co. Ltd, Hangzhou 311112, China |
| |
| Abstract: | The weak signal of MEMS hot-film wall shear stress (WSS) sensors is hard to detect by direct amplification due to the inherent basic voltage. An effective method to solve this problem is proposed, which is to add an output-balancing system (OBS) before the signal is amplified. The basic voltage is decreased while the signal is retained. The development of the output-balancing system is presented, including the technical scheme, key technologies, examination and application. |
| |
| Keywords: | |
| 本文献已被 CNKI 等数据库收录！ |
| 点击此处可从《实验流体力学》浏览原始摘要信息 |
|
点击此处可从《实验流体力学》下载全文 |
|
