| 带螺纹塑件注射模设计及成型工艺 |
| |
| 引用本文： | 李东阳. 带螺纹塑件注射模设计及成型工艺[J]. 华北航天工业学院学报, 2014, 0(1): 10-11,15 |
| |
| 作者姓名： | 李东阳 |
| |
| 作者单位： | 北华航天工业学院机械工程系,河北廊坊065000 |
| |
| 基金项目： | 廊坊市科技局科技支撑计划项目（2011011026） |
| |
| 摘 要： | 分析螺纹塑件的结构特点、工艺要求,介绍了基于拼合结构模外卸除螺纹型环的注射模结构以及工作过程,并且对ABS的注射成型工艺进行了分析。
|
| 关 键 词： | 吸尘器螺纹塑件 注射模 螺纹型环 |
The Designing and Moulding Process of the Injection Mould for the Plastic Parts with Tread |
| |
| LI Dong-yang. The Designing and Moulding Process of the Injection Mould for the Plastic Parts with Tread[J]. Journal of North China Institute of Astronautic Engineering, 2014, 0(1): 10-11,15 |
| |
| Authors: | LI Dong-yang |
| |
| Affiliation: | LI Dong-yang(Mechanical Engineering Department, North China Institute of Aerospace Engineering, Langfang 065000, China) |
| |
| Abstract: | Structures and operating process of injection mould based on coupled structure without tread ring were introduced and the in- jection moulding process of ABS was analyzed according to structural characteristics and process requirements of plastic parts with tread attached on dust absorber. |
| |
| Keywords: | plastic parts with thread on dust absorber injection mould tread ring |
| 本文献已被 CNKI 维普 等数据库收录！ |
