| 9SiCr合金刃具钢在不同介质淬火后性能比较 |
| |
| 引用本文： | 程赫明,谢建斌,李建云.9SiCr合金刃具钢在不同介质淬火后性能比较[J].航空材料学报,2004,24(4):14-17. |
| |
| 作者姓名： | 程赫明 谢建斌 李建云 |
| |
| 作者单位： | 昆明理工大学,工程力学系,云南,昆明,650093 |
| |
| 基金项目： | 国家自然科学基金资助项目(10162002) |
| |
| 摘 要： | 通过对9SiCr合金刃具钢在清水、锭子油和高压气体等淬火介质中淬火对比实验,研究了9SiCr合金刃具钢在不同介质淬火工艺处理后的性能。研究结果表明,水淬火时试件表面与中心的温差较大,锭子油次之,高压气体较小;试件高压气体淬火时,温度梯度小,整个断面冷却比较均匀,可以预计,相应的热应力和热变形也比较小;应用适当压力的氮气能够实现淬透性比较好的9SiCr合金刃具钢的淬火处理。
|
| 关 键 词： | 9SiCr合金刃具钢 气体淬火 温度 相变 |
| 文章编号： | 1005-5053(2004)04-0014-04 |
| 修稿时间： | 2003年11月17 |
Comparison of properties of 9SiCr alloy steel in various quenching media after quenching |
| |
| CHENG He-ming,XIE Jian-bin,LI Jian-yun.Comparison of properties of 9SiCr alloy steel in various quenching media after quenching[J].Journal of Aeronautical Materials,2004,24(4):14-17. |
| |
| Authors: | CHENG He-ming XIE Jian-bin LI Jian-yun |
| |
| Abstract: | The mechanical properties and microstructure of 9SiCr alloy steel after quenching in various quenching media were investigated. The results showed that (1) the temperature differences between center and surface of cylinder were: the largest during water quenching, the lower during oil quenching and the lowest during gas quenching; (2) the temperature gradient of work-piece is smaller during gas quenching, it can be predicted that corresponding thermal strain and distortion is also smaller than that during water and oil quenching; (3) the gas quenching technology in proper pressure can be realized for good hardenability 9SiCr alloy steel. |
| |
| Keywords: | 9SiCr alloy steel gas quenching temperature phase transformation |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
