首页 | 本学科首页   官方微博 | 高级检索  
     

二元收扩喷管设计参数对气动性能影响的数值研究
引用本文:施小娟,吉洪湖,斯仁. 二元收扩喷管设计参数对气动性能影响的数值研究[J]. 航空动力学报, 2016, 31(8): 1799-1810. DOI: 10.13224/j.cnki.jasp.2016.08.002
作者姓名:施小娟  吉洪湖  斯仁
作者单位:南京航空航天大学能源与动力学院江苏省航空动力系统重点实验室, 南京 210016
摘    要:采用正交试验设计方法进行喷管气动性能数值模拟算例的设计,综合研究了二元收扩喷管8个设计参数对气动性能的影响,研究的设计参数包括圆到矩超椭圆型面过渡段几何参数(长径比、横截面积变化率、长半轴变化率、短半轴变化率)和主喷管段几何参数(喉部宽高比、喉部型面半径比、收敛半角、扩张半角),并且对喉部宽高比、喉部型面半径比、收敛半角、扩张半角等4个参数对喷管气动性能影响的灵敏度进行了分析.结果表明:喉部型面半径比RW/R8是二元收扩喷管气动性能影响的最主要参数,因此在喷管设计中应尽量增大RW/R8,尤其是在收敛半角α较大时,增大RW/R8可使喷管气动性能明显增大;喉部宽高比不是二元收扩喷管气动性能影响的主要参数;二元收扩喷管的气动性能几乎与过渡段型面无关. 

关 键 词:二元收扩喷管   气动性能   正交试验   灵敏度分析   设计参数
收稿时间:2014-12-02

Numerical investigation of geometric parameters' influence to aerodynamic performance of two dimensional convergent and divergent nozzle
SHI Xiao-juan,JI Hong-hu and SI Ren. Numerical investigation of geometric parameters' influence to aerodynamic performance of two dimensional convergent and divergent nozzle[J]. Journal of Aerospace Power, 2016, 31(8): 1799-1810. DOI: 10.13224/j.cnki.jasp.2016.08.002
Authors:SHI Xiao-juan  JI Hong-hu  SI Ren
Affiliation:Jiangsu Province Key Laboratory of Aerospace Power System, College of Energy and Power Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing 210016, China
Abstract:The computational cases were designed using the orthogonal experiment design method. The effect of eight geometric parameters on the aerodynamic performance of two dimensional convergent and divergent (2D-CD) nozzle was investigated. The geometric parameters studied include length to diameter ratio, cross-sectional area change rate, long half shaft rate, short half shaft rate of the super elliptic transition section, and throat width to height ratio, throat radius ratio, convergence half angle, divergent half angle of primary nozzle. The sensitivity analysis of throat aspect ratio, throat radius ratio, convergent half angle, divergent half angle on aerodynamic performance was performed. The results show that throat radius ratio is the main parameter of 2D-CD nozzle''s aerodynamic performance, therefore the throat radius ratio should be increased in the 2D-CD nozzle design, especially when the convergent half angle is larger. Width to height ratio of throat is not a major parameter of 2D-CD nozzle''s aerodynamic performance. The aerodynamic performance of 2D-CD nozzle is independent of transition duct.
Keywords:two dimensional convergent and divergent (2D-CD)nozzle  aerodynamic performance  orthogonal experiment  sensitivity analysis  geometric parameters
本文献已被 万方数据 等数据库收录!
点击此处可从《航空动力学报》浏览原始摘要信息
点击此处可从《航空动力学报》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号