利用有限元方法逼近飞行器轨道主动段扰动引力

为了克服引力位系数模型计算飞行器轨道主动段扰动引力所存在的计算量大，并且难以进行实时计算的缺点，提出利用有限元内插的方法对主动段扰动引力进行逼近。根据有限元分析中区域剖分插值的原理，采用了对飞行器轨道周围有限范围的空间区域进行有限元剖分的方式，计算出各剖分单元每个顶点处的扰动引力，然后利用剖分单元各顶点的扰动引力分量内插出飞行器轨道点对应的扰动引力分量值。计算过程和结果表明，这种方法能够快速、精确可靠地逼近飞行器轨道主动段扰动引力，满足了有关文献中所提出的要求。     

跨大气层和空间区域飞行器的液体推进剂管理

根据大气层飞行环境与机动飞行特点,以及空间飞行环境与液体推进剂特点,分析了跨大气层和空间区域飞行器的保证重力场和失重状态下均无夹气液体输送、控制液体推进剂质心位移、剩余推进剂空间排放和重复使用等液体推进剂管理技术要求。阐述了相应的关键技术,如包括无夹气输送、液体质心位移控制、失重状态下的流体动力、参数确定和结构设计等管理模式确定,以及包括模型参数确定、模型、状态模拟和验证等的管理模式试验。     

离散事件动态系统的GSMP模型及扰动分析

对离散事件动态系统（ＤＥＤＳ）的仿真过程建立了包含中断事件集和驱动事件集的广义半马尔可夫过程（ＧＳＭＰ）模型，对参数的无穷小扰动所引起的系统状态转移时刻进行了扰动分析，最后，讨论了扰动分析所需要的可变换条件和样本性能函数的关系，并提出值得进一步研究的问题。     

飞机最快上升转弯轨迹的计算

70年代初,Miele A等人提出SGRA方法用于优化飞行轨迹计算。但方法存在时间加权系数难于确定、长时间的飞行轨迹计算积分精度不易控制及要计算数字微分等不足。对此提出一改进梯度方法,并计算了某型战斗机从亚音速三维转弯升高到超音速的最短时间飞行轨迹。结果表明,本方法稳定有效,为解决飞机最快机动轨迹的优,乜提供了一种行之有效的手段。     

钛合金板材激光弯曲成形的研究

 对常温下钛合金板材进行了激光弯曲成形研究。分析了激光功率、扫描速度、光斑大小对板材弯曲变形的影响,获得理想工艺参数范围为:功率1 .0～1 .2 k W、扫描速度2～3 m/min、光斑直径6～7mm。同时分析了板材厚度、宽度及扫描次数对材料弯曲变形的影响,为钛合金板材弯曲成形提供了一种新途径。     

弹道导弹制导计算中扰动引力的快速赋值

主动段扰动引力是引起弹道导弹制导方法误差的主要因素。因此,要提高导弹的制导精度,就必须能够在弹上实时计算扰动引力。但现有方法在计算快速性和存储量之间无法得到有效协调。为此,把广义延拓逼近思想引入有限元逼近方法中,将插值单元周围节点的信息也包含到单元内一点扰动引力的计算当中,建立了一种新的数学模型。对所选发射空域,在发射坐标系中进行了直角坐标划分。计算结果表明,这种方法能够更加精确地逼近弹道导弹主动段的扰动引力,在600 km×250 km×6 km的主动段飞行区域内,只需要保存60个节点数据,就能使由逼近误差导致的落点偏差小于10 m,是一般有限元逼近方法精度的4倍以上。     

均匀各向同性大气湍流对声爆传播特性的影响

基于离散Fourier模态有限和生成的随机大气湍流场，采用修正波形参数方法，开展了均匀各向同性大气湍流对典型超声速客机声爆传播特性的影响分析。计算采用的超声速客机模型为自行生成的简化超声速公务机模型。首先，应用航空工业空气动力研究院自主研制的CFD软件ARI_Overset在三维空间求解Navier-Stokes方程，得到作为声爆远场传播初始值的近场空间压力分布；其次，基于Von Karman能量谱，采用离散Fourier模态有限和形式生成随机均匀各向同性大气湍流场；最后，采用修正波形参数方法模拟了声爆信号在随机速度湍流场中的传播过程。数值结果表明：各向同性大气湍流对于地面声爆特征有重要影响。与无湍流状态相比，均匀各向同性大气湍流使得地面声爆特征增强的概率约为55%，使得地面声爆特征减弱的概率约为45%，故总体而言大气湍流效应更倾向于增强地面声爆特征；均匀各向同性大气湍流对于声爆传播路径影响相对较小，但是这一变化仍会导致地面信号接收点的不确定性。     

DME Interference mitigation for L-DACS1 based on system identification and sparse representation

L-band digital aeronautical communication system 1 (L-DACS1) is a promising candi-date data-link for future air-ground communication, but it is severely interfered by the pulse pairs (PPs) generated by distance measure equipment. A novel PP mitigation approach is proposed in this paper. Firstly, a deformed PP detection (DPPD) method that combines a filter bank, correlation detection, and rescanning is proposed to detect the deformed PPs (DPPs) which are caused by mul-tiple filters in the receiver. Secondly, a finite impulse response (FIR) model is used to approximate the overall characteristic of filters, and then the waveform of DPP can be acquired by the original waveform of PP and the FIR model. Finally, sparse representation is used to estimate the position and amplitude of each DPP, and then reconstruct each DPP. The reconstructed DPPs will be sub-tracted from the contaminated signal to mitigate interference. Numerical experiments show that the bit error rate performance of our approach is about 5 dB better than that of recent works and is closer to interference-free environment.     

Numerical investigation on flow nonuniformity-induced hysteresis in scramjet isolator

Numerical simulation and theoretical analysis were conducted to study the hysteresis inside scramjet isolator during the reciprocating process of back pressure variation. It is revealed that only a regular reflection is theoretically possible for two leading shocks when the inflow Mach number is greater than 2.0, and no hysteresis can occur in the transition between shock reflection types. Nevertheless, wall suction, gas injection, and background waves cause non-uniformity of the incoming flow and would make hysteresis possible. Besides the classical hysteresis in the transition between shock reflection, new kinds of hysteresis were found in both the deflection angle of separated boundary layer and the location of the shock train. Moreover, the occurrence of hysteresis in the deflection angle of the separated boundary layer is accompanied with the shock reflection hysteresis. In the case with background waves or gas injection, hysteresis in the starting position of leading shock was observed too. As back pressure decreases, the leading shock does not follow the same path as that as the back pressure increases, and it is anchored at the location where the background shock or the injection interacts with the leading shock. It is inferred that, if two strong adverse pressure gradient regions move towards and interact with each other, hysteresis will take place when they start to separate.     

Alfvén gravity waves in viscous solar plasma: Effect of the background flow

We study the Propagation and damping properties of Alfvén gravity waves in the presence of the vertical magnetic field in the viscous solar plasma under influence of the background flow by deriving a fourth order dispersion relation in terms of the Doppler shifted frequency. We derive the dispersion relation under WKB and Boussinesq approximation. We study the damping of Alfvén gravity waves for the wave frequencies less than and greater than the Brunt-Väisälä frequency. We find that the Brunt-Väisälä frequency divides the frequency ranges where the weakly or strongly damped oscillations occur. The background flow exhibits a strong effect on weakly damped oscillations and a weak effect on the strongly damped oscillations. We also notice that the damping of both the strong and weakly damped oscillations depend on the Brunt-Väisälä frequency and wave number. The effect of the background flow is also being governed by the Brunt-Väisälä frequency and wave number. We also study the properties of gravity wave mode after filtering the Alfvén wave mode by minimizing the magnetic field and noticed that the background flow shows a very strong effect on the gravity wave mode.