悬浮浇注对铝铜合金组织遗传性的影响

采用悬浮浇注法研究了ＺＬ２０１合金的遗传现象及其组织性能的影响,通过分析试件的凝固特性,对合金的组织遗传机理进行了初步探讨,结果表明：悬浮剂的中入使合金的凝固时间缩短,凝固速度增加,促进了合金结晶组织的细化,当加入３％ｗｔ悬浮剂合金组织的有明显改善且力学性能σｂ和δ分别提高了８．８％和２３．１％,证明熔体中的弥散质点是组织遗传“基因”的观点。     

Leakage performance of floating ring seal in cold/hot state for aero-engine

Rotating experimental investigations were carried out to study the oil sealing capability of two different floating ring seals in cold/hot state for aero-engine. High-speed Floating Ring Seal(HFRS) is a seal with the inner diameter of 83.72 mm and maximum speed of 38000 r/min, and Low-speed Floating Ring Seal(LFRS) is another seal with the inner diameter of 40.01 mm and maximum speed of 18000 r/min. In hot state, sealing air with the temperature of 371 K and oil with the temperature of 343 K was employed to model the working conditions of an aero-engine. Comparisons between floating ring seal and labyrinth seal were done to inspect the leakage performance.More attention was paid to the critical pressure ratio where the oil leakage began. Results show that the critical pressure ratio in cold state is obviously larger than that in hot state for both seals. An underlying sealing mechanism for floating ring seal is clarified by the fluid film, which closely associates with the dimensionless parameter of clearance over rotating diameter(2 c/Dr). Another fantastic phenomenon is that the leakage coefficient in hot state, not the leakage magnitude, is unexpectedly larger than that in cold state. Overall, the leakage performance of the floating ring seal is better than the labyrinth seal.     

Diversity of Comets: Formation Zones and Dynamical Paths

The past dozen years have produced a new paradigm with regard to the source regions of comets in the early solar system. It is now widely recognized that the likely source of the Jupiter-family short-period comets (those with Tisserand parameters, T > 2 and periods, P, generally < 20 years) is the Kuiper belt in the ecliptic plane beyond Neptune. In contrast, the source of the Halley-type and long-period comets (those with T < 2 and P > 20 years) appears to be the Oort cloud. However, the comets in the Oort cloud almost certainly originated elsewhere, since accretion is very inefficient at such large heliocentric distances. New dynamical studies now suggest that the source of the Oort cloud comets is the entire giant planets region from Jupiter to Neptune, rather than primarily the Uranus-Neptune region, as previously thought. Some fraction of the Oort cloud population may even be asteroidal bodies formed inside the orbit of Jupiter. These comets and asteroids underwent a complex dynamical random walk among the giant planets before they were ejected to distant orbits in the Oort cloud, with possible interesting consequences for their thermal and collisional histories. Observational evidence for diversity in cometary compositions is limited, at best. This revised version was published online in June 2006 with corrections to the Cover Date.     

复合材料MMB试件I-II混合型层间裂纹扩展分析

基于经典层合板理论及双线性黏聚区本构关系，建立了含一般分层裂纹层合板的理论模型，对I-Ⅱ混合型弯曲（MMB）断裂试件进行了裂纹扩展理论分析。提出了一种I-Ⅱ混合型断裂叠加模型，引入I型裂纹分量的刚体转动位移，同时考虑了裂纹长度超过试件半长后中部载荷分量对裂纹扩展的闭合效应，并根据黏聚区力学响应，分段获得了位移函数通解。结合叠加模型的边界条件与连续性条件，分析了MMB试件的裂纹扩展过程，求解获得了载荷-位移曲线。通过与梁模型预测以及试验结果进行对比，验证了本文模型对I-Ⅱ混合型裂纹扩展预测的有效性和准确性，并讨论了初始断裂模式混合比及闭合效应对裂纹扩展过程的影响。结果表明：初始Ⅱ型裂纹比重较大时，中部载荷的闭合效应更为明显，可能出现I型裂纹完全闭合的情况；裂纹扩展过程中，当裂纹长度小于试件半长时，断裂混合比基本保持常数；当裂纹扩展超过试件半长后，闭合效应明显，混合裂纹形式逐渐向单一型断裂模式退化。     

Effect of drag reducing riblet surface on coherent structure in turbulent boundary layer

The characteristics of turbulent boundary layer over streamwise aligned drag reducing riblet surface under zero-pressure gradient are investigated using particle image velocimetry. The formation and distribution of large-scale coherent structures and their effect on momentum partition are analyzed using two-point correlation and probability density function. Compared with smooth surface, the streamwise riblets reduce the friction velocity and Reynolds stress in the turbulent boundary layer, indicating the drag reduction effect. Strong correlation has been found between the occurrence of hairpin vortices and the momentum distribution. The number and streamwise length scale of hairpin vortices decrease over streamwise riblet surface. The correlation between number of uniform momentum zones and Reynolds number remains the same as smooth surface.     

航天器浮动电位的初步分析

为了研究表面充电引起的浮动电位情况,我们采用等效电容的方法分析了近赤道低轨道高度条件下航天器的等效电容及充电时间问题,初步总结了浮动电位对航天器可能产生的影响。根据计算结果可以认为在低轨道等离子体环境中航天器会达到浮动电位的平衡状态。
     

一种通用的信号调理板卡的设计

测试系统中常见的被测信号有:直流电压信号、交流电压信号和直流电流信号,而这些不同类型的被测信号之间往往又是浮地信号,这给地面测试带来了很大的麻烦。本文分别针对上述不同类型的浮地被测信号,详细介绍了如何将这些信号前后端隔离,并且调理成适于A/D采集模件测量的方法。该方案的引入可有效的简化测试设备,降低测试成本。     

Polar caps and auroral zones under idealized axisymmetric magnetic fields

The geomagnetic field, modified by the solar wind, determines the shape, area and location of polar caps and auroral zones, among other magnetosphere and upper atmosphere characteristics. Since the field varies greatly with time it is of interest to analyze polar caps and auroral zones variations linked to magnetic field variations of intensity and pattern. Polar caps and auroral zones locations and areas for various single harmonic axial field configurations are obtained analytically assuming a simple magnetopause model. As the axial degree n increases, the polar caps and auroral zones total number, given by n + 1 and 2n respectively, also increase. However, their total areas decrease from a larger value in the case of an axial dipole to a minimum for an axial octupole (n = 3), and then increase for increasing degrees. The increasing rate is much higher in the auroral zones case to the point that it exceeds the dipolar value at n = 5 while in the polar caps case this occurs at n = 8. The absolute latitudes of the auroral zones and polar caps that reside around the geographical poles increase with axial degree. Our results represent an end-member case of the evolution of auroral zones and polar caps during polarity reversals if the transition involves axial dipole energy cascade to higher axial degrees. Evidence for such an energy transfer is found in the historical record of the geomagnetic secular variation.     

受限空间内三级旋流流场和燃烧性能研究

为研究受限空间内三级旋流器流场特征和对应的燃烧性能,对不同方案三级旋流器开展了试验和仿真研究,分析了2种典型流场（贴壁流场和锥形流场）特性及其对火焰形态、燃烧室性能指标的影响。结果表明,通过控制三级孔特征可实现三级旋流器下游贴壁流场和锥形流场之间的转变。三级孔为30°时,旋流器的高湍动能有利于强化燃油雾化,同时形成贴壁的大尺寸回流区有利于燃油在主燃区的空间扩散和均匀分布,能够改善燃烧室点熄火性能,但会导致主燃区火焰筒壁温较高。     

Remote sensing detection of gold related alteration zones in Um Rus area, Central Eastern Desert of Egypt

Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) and Phased Array L-band Synthetic Aperture Radar (PALSAR) images covering the Um Rus area in the Central Eastern Desert of Egypt were evaluated for mapping geologic structure, lithology, and gold-related alteration zones. The study area is covered by Pan-African basement rocks including gabbro and granodiorite intruded into a variable mixture of metavolcanics and metasediments. The first three principal component analyses (PCA1, PCA2, PCA3) in a Red-Green-Blue (RGB) of the visible through shortwave-infrared (VNIR + SWIR) ASTER bands enabled the discrimination between lithological units. The results show that ASTER band ratios ((2 + 4)/3, (5 + 7)/6, (7 + 9)/8) in RGB identifies the lithological units and discriminates the granodiorite very well from the adjacent rock units.The granodiorites are dissected by gold-bearing quartz veins surrounded by alteration zones. The microscopic examination of samples collected from the alteration zones shows sericitic and argillic alteration zones. The Spectral Angle Mapper (SAM) and Spectral Information Divergence (SID) supervised classification methods were applied using the reference spectra of the USGS spectral library. The results show that these classification methods are capable of mapping the alteration zones as indicated by field verification work. The PALSAR image was enhanced for fracture mapping using the second moment co-occurrence filter. Overlying extracted faults and alteration zone classification images show that the N30E and N-S fractures represent potential zones for gold exploration. It is concluded that the proposed methods can be used as a powerful tool for ore deposit exploration.