基于Pro/E软件的卫星三维建模方法的探讨

主要对基于Pro/E软件的卫星三维建模和高效率、高可靠性、低成本的总装设计方法等进行了初步的研究和探讨。     

正确认识山农信道容量定理

山农信道容量定理公式中的信道带宽恒为信源所发出的消息信号的带宽 ,是信道带宽的理论最小极限 ;它不同于现代通信工程中传输已调制信号时所需要的信道带宽。这是本文所证明的基本结论。这一结论将限制信道容量定理的普适性和实用性。     

极光区电离层Hall电导率的观测及其在E层电子加热情况下的特征

本文利用欧洲的ＥＩＳＣＡＴ雷达观测资料及与这配合的地磁观测数据，用电离层参数直接计算和地面磁场反演两种方法导出了极区电离层Ｈａｌｌ电导率，特别显示出在强对流电场激发的Ｅ层等离子体不稳定波对电子加热情况下，电导率明显增高。     

Initial nighttime ionospheric observations with advanced ionospheric probe onboard FORMOSAT-5

FORMOSAT-5 satellite was launched into a sun-synchronous orbit at 720 km altitude with 98.28° inclination on 25 August 2017. The onboard scientific payload, Advanced Ionospheric Probe (AIP) is capable of measuring topside ionospheric ion density, cross-track flow velocities, ion composition and temperature, and electron temperature. Initial observations of nighttime midlatitude ionospheric density and vertical flow velocity variations at 2230 LT sector during a few quiet magnetic days in December 2017 are studied here. Longitudinal density variations in the equatorward edge of midlatitude ionospheric trough (MIT) region are noticed. Accompanied with this density variation, the vertical flow velocities also behave differently. Although the density difference has been stated due to zonal wind effect related to the declination of the geomagnetic field lines, the vertical flow velocity variation seems to play the opposite role. All these density and vertical flow observations in the northern winter hemisphere can only be explained by the longitudinal differences in the diffusion velocity coming down from the protonsphere (plasmasphere). In addition, the hemispheric asymmetry in the vertical flow velocity can also be explained by the interaction between the topside ionosphere and the protonsphere. The observed vertical flow variations near MIT at different longitudes should present a new potential tool for the study of MIT formation.     

High temporal resolution global PWV dataset of 2005–2016 by using a neural network approach to determine the mean temperature of the atmosphere

Atmospheric water vapour plays an important role in phenomena related to the global hydrologic cycle and climate change. However, the rapid temporal–spatial variation in global tropospheric water vapour has not been well investigated due to a lack of long-term, high-temporal-resolution precipitable water vapour (PWV). Accordingly, this study generates an hourly PWV dataset for 272 ground-based International Global Navigation Satellite System (GNSS) Service (IGS) stations over the period of 2005–2016 using the zenith troposphere delay (ZTD) derived from global-scale GNSS observation. The root mean square (RMS) of the hourly ZTD obtained from the IGS tropospheric product is approximately 4 mm. A fifth-generation reanalysis dataset of the European Centre for Medium-range Weather Forecasting (ECMWF ERA5) is used to obtain hourly surface temperature (T) and pressure (P), which are first validated with GNSS synoptic station data and radiosonde data, respectively. Then, T and P are used to calculate the water vapour-weighted atmospheric mean temperature (Tm) and zenith hydrostatic delay (ZHD), respectively. T and P at the GNSS stations are obtained via an interpolation in the horizontal and vertical directions using the grid-based ERA5 reanalysis dataset. Here, Tm is calculated using a neural network model, whereas ZHD is obtained using an empirical Saastamoinen model. The RMS values of T and P at the collocated 693 radiosonde stations are 1.6 K and 3.1 hPa, respectively. Therefore, the theoretical error of PWV caused by the errors in ZTD, T and P is on the order of approximately 2.1 mm. A practical comparison experiment is performed using 97 collocated radiosonde stations and 23 GNSS stations equipped with meteorological sensors. The RMS and bias of the hourly PWV dataset are 2.87/?0.16 and 2.45/0.55 mm, respectively, when compared with radiosonde and GNSS stations equipped with meteorological sensors. Additionally, preliminary analysis of the hourly PWV dataset during the EI Niño event of 2014–2016 further indicates the capability of monitoring the daily changes in atmospheric water vapour. This finding is interesting and significant for further climate research.     

Diurnal and seasonal variations in long-term changes in the E-layer critical frequency

Long-term changes in the E-layer critical frequency, foE, at three stations of the European region (Juliusruh, Slough and Rome) and also at Moscow and Wakkanai stations are analyzed by the method developed by the authors and described in detail in the previous papers. It is found that Juliusruh and Slough stations demonstrate a well-pronounced change in foE (a trend) during two previous decades. At the same time, the same features of the behavior of the aforementioned trend k(foE) are obtained. The trend is positive and negative in the morning and evening hours, respectively. Similar diurnal behavior of k(foE) is found also for Moscow station but with lower absolute values of the trends. A well-pronounced seasonal behavior of k(foE) is detected at Juliusruh and Slough: the trend is minimal and maximal in the summer period and at the end of fall—beginning of winter, respectively. The maximal amplitude in the morning hours reaches +0.04?MHz per year, whereas the minimal amplitude in evening hours is ?0.06?MHz per year. No systematic changes exceeding by the magnitude 0.01?MHz per year are found for Rome and Wakkanai stations. It is assumed that the observed trends are related to changes (trends) in the meridional wind bringing NO molecules from the auroral oval to lower latitudes.     

工业CT检测技术在5 kN发动机研制中的应用

针对5 kN发动机结构焊缝和复合材料喷管不可检不可测的难题,开展了工业CT检测技术研究。分析了复杂结构焊缝和复合材料喷管的常规方法检测难点,利用工业CT检测技术穿透能力强、不受工件复杂结构影响的优势,对5 kN发动机产品中的电子束焊缝、氩弧焊焊缝、复合材料喷管等结构进行了检测试验,得到了良好的检测效果。结果表明,工业CT检测技术可以识别5 kN发动机产品中的气孔、未焊透、分层、裂纹等缺陷,并实现对缺陷的定位与测量,可为焊缝质量评估提供依据。     

E10.7指数在软X射线谱段的修正应用

表征EUV辐射通量的E10.7指数在越来越多的研究和应用中被用来代替传统的F10.7指数.X射线对地球D层和E层的电离起着重要作用,但由于D层观测数据的不足和E层电离源的多样性,难以被用来考虑X射线对电离层的影响.火星电离层下层的电离源几乎是单一的软X射线,这为研究X射线对电离层的作用提供了可能性.通过研究火星电离层下层的峰值电子浓度对E10.7的依赖关系,发现即便经过必要的修正,这种关系对不同的观测时段并不具备一致性.通过理论推导和数据分析,得到了一种特别用于描述太阳软X射线辐射通量的新指数,即Xs指数,用来替代E10.7指数.Xs指数在描述火星电离层下层对太阳辐射的依赖关系时,不同的观测时段有很好的一致性,表明Xs指数在表征太阳软X射线辐射强度方面比E10.7指数更加合适.      

C/E复合材料网格缠绕结构三维建模与模具设计

通过对圆柱螺旋线和圆锥螺旋线参数方程的推导,实现了网格结构及模具的三维建模。三维模型的建立,可实现结构空间协调,缩短设计周期,节省研制经费,提高生产效率。在此基础上提出了可行的金属模具设计方案,找到了切实可行的模具加工方法,并在工程中加以应用,取得了较好效果。     

MA 及原位-热压合成TiC/ Ti5 Si3 复合材料

以Ti粉、Si粉和C粉为原料,利用高能球磨及热压工艺合成了TiC/Ti5Si3陶瓷复合材料。研究了工艺条件尤其是热压温度对合成产物相组成及微观结构的影响,并结合DSC、XRD和SEM对反应合成机理进行探讨。结果表明:通过优化合成工艺,高能球磨12 h,热压温度1 400℃时,烧结6 h得到了高纯度的TiC/Ti5Si3陶瓷复合材料;合成过程为:反应开始时发生Ti+C■TiC,反应ΔG=-167.72 kJ/mol。2 h时发生5TiC+8Si■Ti5Si3+5SiC,反应ΔG=-62.12 kJ/mol,当6 h时发生3SiC+8Ti■Ti5Si3+3TiC,反应ΔG=-697.8 kJ/mol。显微结构表明:TiC/Ti5Si3复合材料的合成过程伴随Si熔融,该材料以TiC-Si-Ti5Si3形式相结合,其中Si为黏结剂。