Water Cherenkov detectors:MILAGRO

This paper discusses the properties of using the water Cherenkov technique to detect air showers in the few hundred GeV to 100 TeV energy range. The responses of a 6 m² 2 m deep water Cherenkov counter and that of a 6 m² 10cm thick scintillator-lead sandwich counter to air shower electrons and photons is described. The advantages of water Cherenkov detector is outlined. Its application to do VHE gamma ray astronomy is discussed with particular reference to the MILAGRO telescope currently under construction. Milagro, a water-Cherenkov detector to do gamma ray astronomy above 100 Gev, uses an existing pool 60m × 80m by 8m, located in the Jemez mountains near Los Alamos, NM. The threshold of the MILAGRO detector is comparable to atmospheric Cherenkov detectors, however it has several advantages over these optical detectors. MILAGRO can operate 24 hours a day in all weather conditions and it has an open aperture which allows it to view the entire northern sky every day. These capabilities allow for a systematic all-sky survey to be done for the first time at these energies. MILAGRO will measure the Crab spectrum with high significance over a wide energy range, it will detect and measure the spectra from AGN's such as MRK 421 and it will search for short duration bursts from GRBs and possibly evaporating PBHs.     

炉渣滤床技术处理亚麻生产废水

为了确定处理包头亚麻厂亚麻生产废水的设计方案，设计之前在现场进行了生产试验。在包头亚麻厂污水处理站，模拟炉渣滤床制造了3米高的炉渣滤层，滤渣从工厂锅炉房取用，将实际排放的亚麻煮漂车间、细纱车间、粗纱车间的生产废水混合后，通过炉渣滤层过滤处理，处理后出水由厂化验室和包头环保局化验。试验结果表明，处理后的排水各项指标完全达到国家排放标准。该工艺处理费用低，运行效果稳定，管理简便，具有明显的经济效益、环境效益和社会效益。     

水洞动态测力和流动显示一体化实验技术

研制能够用于低速水流中的三分量内式测力天平,结合氢气泡(或染色液)方法,在水洞(槽)中实现测力和流动显示实验同步进行的动态实验系统,克服了通常测力和流动显示分别在风洞和水洞中进行,实验条件不同给结果分析带来的困难。天平采用高精度位移传感器,避开传统的应变片技术应用于水中所遇到的技术困难。简易飞行器模型的静态和等速俯仰实验结果表明了测量系统的可靠性。     

气相色谱法测定达连河水中的硝基苯

介绍了检测达连河水中硝基苯含量的方法,并就检测结果进行了分析.     

加气喷嘴气体注入形式对雾化性能的影响

本文用马尔文粒度分析仪测量喷雾的平均液滴尺寸及液滴尺寸分布,研究了气体注入形式对喷雾特性的影响.喷嘴压降为34.5～690kPa,喷嘴气液比为0.002～0.023.试验中使用了两种气体注入形式:一种是直径6.3mm的单孔,另一种是20个直径0.5mm的小孔.它们与三种不同孔径的喷孔配合使用.其孔径分别为0.8,1.6和2.4mm.研究结果表明,雾化质量主要取决于喷嘴压降和气液比,而对气体注入形式和喷孔直径不敏感.测量液体流量看出,此类喷嘴的流量系数很小.雾化液体中含有固体颗粒或其它易堵塞小孔或喷嘴通道的有害物时,使用这种喷嘴将会显示出它的优点.     

基于超纯水电解加工的水解离机理研究

介绍了一种以超纯水为电解液的电解加工工艺方法,即超纯水电解加工技术.研究了阳离子交换膜在超纯水中的水解离机理及工作特性,分析其在超纯水电解加工过程中的作用机理,并进行了水解离试验研究.结果表明：电流密度达到了3.7 A/cm^2,电场强度约为2 MV/m,已进入微细电解加工去除材料要求范围,为超纯水微细电解加工的应用奠定了基础.     

金属水反应水冲压发动机系统性能估算

使用金属／水反应燃料是推进水下超高速航行器的最佳途径，分析了单次注水和二次注水的铝／水反应燃料水冲压发动机系统，得出了燃料质量配比、燃烧室温度、燃烧室压强、系统有效推力、效率等关键技术性能指标。指出了二次注水系统的优越性并提出了一种二次注水系统的实施方案。分析结论与实际系统性能指标相吻合，证明了分析的正确性，可以为系统研究提供参考。     

Numerical simulations of water spray on flame deflector during the four-engine rocket launching

This paper aims to study on the cooling effect with two types of water spray nozzle on the flame deflector during the four-engine launch vehicle take-off. To accurately simulate the two-phase flow of the rocket gas with multispecies and the water spray, the three-dimensional compressible Navier-Stokes equations, discrete ordinates methods and realizable k-Ɛ turbulence model are used to establish the rocket supersonic plumes impact model. The Eulerian dispersed phase (EDP) model was used to simulate the water spray into the exhaust gas. The accuracy and effectiveness of the gas-liquid flow model are verified by a good agreement between simulation results and experimental data. On this basis, a series of numerical simulation studies under different water injection position are performed. The results show that the high temperature regions, along the axis of engines on the deflector plate, have no significant temperature decreasing effect by water spray from the nozzles mounted on the apex of the deflector, and the high temperature converts a large quantity of water into vapor near the plume boundary, which would decrease the flow conductivity. With the cooling spray nozzle fixed directly to the deflector plate, the temperature decrease effect is obvious and the effect of thermal shock on deflector plate induced by exhaust plume is reduced, so that it can prevent the flame deflector from thermal ablation. The study results provide indepth information and engineering guidance for designing the water spray systems and increasing the safety of the launch process.     

甲醇超临界水完全气化制氢系统的火用分析

基于热力学火用平衡方程所揭示的实际用能过程和理想用能过程,通过引入"偏离值"、"偏离度"两个指标,对甲醇超临界水制氢系统进行了火用分析。首先确定了加热和反应环节为重点优化环节;然后研究了此二环节的"偏离度"分别随压力、温度的变化规律,并比较了压力和温度对"偏离度"的影响作用大小。在提高甲醇制氢系统的能质利用率方面进行了有益的探讨,其结论对制氢系统的节能工作具有一定的参考价值。     

自制等离子喷枪冷却系统的设计及测试

等离子喷枪是制备热障涂层中的研究重点。目前关于等离子喷枪的研究多集中于喷嘴(阳极)、阴极,鲜有关于喷枪冷却系统方面的研究;喷枪冷却系统的优劣直接影响喷枪的工作寿命和喷涂过程的稳定性,同时制备热障涂层的质量也与冷却效果紧密相关。本文利用三维模型,详细阐述了自制的喷枪冷却系统通道及工作原理,并对设计进行了理论计算,对自制的喷枪进行点火试验和喷涂测试,结果显示自制的喷枪冷却系统功能良好,喷枪工作稳定,涂层质量较好。