Impact of rain on wave retrieval from Sentinel-1 synthetic aperture radar images in tropical cyclones

The main objective of our work was to investigate the impact of rain on wave observations from C-band (~5.3 GHz) synthetic aperture radar (SAR) in tropical cyclones. In this study, 10 Sentinel-1 SAR images were available from the Satellite Hurricane Observation Campaign, which were taken under cyclonic conditions during the 2016 hurricane season. The third-generation wave model, known as Simulating WAves Nearshore (SWAN) (version 41.31), was used to simulate the wave fields corresponding to these Sentinel-1 SAR images. In addition, rainfall data from the Tropical Rainfall Measuring Mission satellite passing over the spatial coverage of the Sentinel-1 SAR images were collected. The simulated results were validated against significant wave heights (SWHs) from the Jason-2 altimeter and European Centre for Medium-Range Weather Forecasts data, revealing a root mean square error (RMSE) of ~0.5 m with a 0.25 scatter index. Winds retrieved from the VH-polarized Sentinel-1 SAR images using the Sentinel-1 Extra Wide-swath Mode Wind Speed Retrieval Model after Noise Removal were taken as prior information for wave retrieval. It was discovered that rain did indeed affect the SAR wave retrieval, as evidenced by the 3.21-m RMSE of SWHs between the SAR images and the SWAN model, which was obtained for the ~1000 match-ups with raindrops. The raindrops dampened the wave retrieval when the rain rate was < ~5 mm/hr; however, they enhanced wave retrieval for higher rain rates. It was also found that the portion of the rain-induced ring wave with a wave number > 0.05 rad/m (~125 m wavelength) was clearly observed in the SAR-derived wave spectra.     

Research on navigation of satellite constellation based on an asynchronous observation model using X-ray pulsar

Pulsar navigation is a promising navigation method for high-altitude orbit space tasks or deep space exploration. At present, an important reason for restricting the development of pulsar navigation is that navigation accuracy is not high due to the slow update of the measurements. In order to improve the accuracy of pulsar navigation, an asynchronous observation model which can improve the update rate of the measurements is proposed on the basis of satellite constellation which has a broad space for development because of its visibility and reliability. The simulation results show that the asynchronous observation model improves the positioning accuracy by 31.48% and velocity accuracy by 24.75% than that of the synchronous observation model. With the new Doppler effects compensation method in the asynchronous observation model proposed in this paper, the positioning accuracy is improved by 32.27%, and the velocity accuracy is improved by 34.07% than that of the traditional method. The simulation results show that without considering the clock error will result in a filtering divergence.     

关于疲劳裂纹扩展数学模型的参数寻优

本文通过引入工程设计中的优化方法，分别对室内空气环境下铝合金（ＬＹ１２－ＣＺ）材料疲劳裂纹扩展的数学模型，以及环境条件下（３．５％ＮａＣｌ水溶液浸泡）该材料腐蚀疲劳裂纹扩展的数学模型进行了探讨。在已知标准试样在不同的环境下疲劳裂纹扩展实验ｄａｄＮｉ，ΔＫｉ的条件下，采用优化方法进行参数寻优，可方便地得到与其对应的疲劳裂纹扩展的ｄａｄＮ～ΔＫ最优数学模型     

一种新的六端口测量系统自校准方法

提出了一种新的六端口自校准方法.本方法从六端口相对功率理论出发,导出了六端口系统常数的自校准方程,给出了求解系统常数初值的方法,并利用梯度法对方程组求解,仿真结果表明用一个匹配负载、四个失配负载就可以解出系统常数.     

数字式射击瞄准计算机设计与实现

某型射击军械系统的射瞄计算机原采用模拟机电式技术实现,存在体积大、功耗大、可靠性及可维护性差等缺点,因此,使用数字式计算机技术对其进行升级改造势在必行.本文首先对原系统的火控原理及火控构型的进行了分析;其次,介绍了射击瞄准计算机的对外接口关系.重点介绍了数字式射击瞄准计算机的采样解算时间的确定、计算方法的选取及接口设计等内容.本文所设计的数字式射击瞄准计算机已通过了系统验证并得到了使用,克服了原有系统所存在的固有缺点.文中的设计思想与所用的工程方法对类似武器系统的升级改造有所借鉴.     

CBERS-1卫星红外多光谱扫描仪扫描子系统

文章介绍了CBERS -1卫星红外多光谱扫描仪(IRMSS)关键部件扫描子系统研制与应用情况。     

基于DWDM光接入网的波长分配算法

本文介绍了一种基于DWDM光接入网的波长分配算法，该算法在保证基本服务质量的前提下，通过调度共享波长降低业务请求过程中的阻塞率。文中还对该算法进行了计算机仿真实验，仿真结果表明了该算法的有效性。     

关于平面空穴流动的截断误差减小方法(英文)

提出了一种新的截断误差减小方法。该方法是利用在粗网格 ( 2 h)上估算截断误差进而减小在原始网格( h)上的误差的迭代过程 ,最终目的是利用粗网格得出更精确的结果以及发展一种新的粗网格直接数值模拟方法