Conical Scanning System for Pioneer Jupiter Spacecraft

The concept, operation, and predicted performance of an RF tracking control system used to point the Pioneer F/G spacecraft at the Earth is described. This system employs a modified conical scanning technique called Conscan. The signal processor, the most interesting unit of the system, is described in detail to show that it approximates a maximum likelihood estimator. The dynamic behavior of the spacecraft and the stability analysis of the system are presented, demonstrating that the system performance is basically determined by the open-loop phase and amplitude errors introduced by the antenna, receiver, and signal processor. A detailed error budget shows that the phase and amplitude errors are small. Finally, closed-loop simulation and test data are presented to verify the error budget.     

A numerical optimization of high altitude testing facility for wind tunnel experiments

High altitude test facilities are required to test the high area ratio nozzles operating at the upper stages of rocket in the nozzle full flow conditions.It is typically achieved by creating the ambient pressure equal or less than the nozzle exit pressure.On average,air/GN2is used as active gas for ejector system that is stored in the high pressure cylinders.The wind tunnel facilities are used for conducting aerodynamic simulation experiments at/under various flow velocities and operating conditions.However,constructing both of these facilities require more laboratory space and expensive instruments.Because of this demerit,a novel scheme is implemented for conducting wind tunnel experiments by using the existing infrastructure available in the high altitude testing(HAT)facility.This article presents the details about the methods implemented for suitably modifying the sub-scale HAT facility to conduct wind tunnel experiments.Hence,the design of nozzle for required area ratio A/A*,realization of test section and the optimized configuration are focused in the present analysis.Specific insights into various rocket models including high thrust cryogenic engines and their holding mechanisms to conduct wind tunnel experiments in the HAT facility are analyzed.A detailed CFD analysis is done to propose this conversion without affecting the existing functional requirements of the HAT facility.     

A fiber-optic current sensor for aerospace applications

A robust, accurate, broadband, AC sensor using fiber optics that is being developed for space applications at power frequencies as high as 20 kHz is described. It can also be used in low- and high-voltage 60-Hz terrestrial power systems and in 400-Hz aircraft systems. It is intrinsically immune to electromagnetic interference (EMI) and has the added benefit of excellent isolation. The sensor uses the Faraday effect in optical fiber and standard polarimetric measurements to sense electrical current. The primary component of the sensor is a specially treated coil of single-mode optical fiber, through which the current-carrying conductor passes. Improved precision is accomplished by temperature compensation by means of signals from a novel fiber-optic temperature sensor embedded in the sensing head. The technology used in the sensor is discussed, and the results of precision tests conducted at various temperatures within the wide operating range as well as the results of early EMI tests are reported     

High energy density capacitors for space power conditioning

Several advanced capacitor designs that might be used in high average power space applications are described. Each type is fundamentally limited by breakdown phenomena. All are intrinsically limited to maximum fields on the order of 1000 MV/m. None of these units has been space rated for energy storage applications. Several problems that must be solved before use in space are presented as well as the current state of the art and estimates of developmental potential     

Comparative analysis of energy storage media and techniques

Techniques for storing and converting energy from one form to another are examined. The parameters of interest are storage density (in terms of both energy and power), conversion efficiency, and number of steps in the conversion process. The techniques compared are electrostatic, magnetic, inertial, chemical, thermal, and nuclear. Each technique for storage is discussed in terms of the ease with which the energy can be converted to electricity for powering lightweight compact power systems for a variety of uses. The storage density associated with the various mechanisms spans an enormous range (~0.5 MJ/kg to ~10⁵ MJ/kg). The impact upon time-to-refuel within the context of mobile tactical army applications is discussed     

The use of ionospheric tomography and elevation masks to reduce the overall error in single-frequency GPS timing applications

Signals from Global Positioning System (GPS) satellites at the horizon or at low elevations are often excluded from a GPS solution because they experience considerable ionospheric delays and multipath effects. Their exclusion can degrade the overall satellite geometry for the calculations, resulting in greater errors; an effect known as the Dilution of Precision (DOP). In contrast, signals from high elevation satellites experience less ionospheric delays and multipath effects. The aim is to find a balance in the choice of elevation mask, to reduce the propagation delays and multipath whilst maintaining good satellite geometry, and to use tomography to correct for the ionosphere and thus improve single-frequency GPS timing accuracy. GPS data, collected from a global network of dual-frequency GPS receivers, have been used to produce four GPS timing solutions, each with a different ionospheric compensation technique. One solution uses a 4D tomographic algorithm, Multi-Instrument Data Analysis System (MIDAS), to compensate for the ionospheric delay. Maps of ionospheric electron density are produced and used to correct the single-frequency pseudorange observations. This method is compared to a dual-frequency solution and two other single-frequency solutions: one does not include any ionospheric compensation and the other uses the broadcast Klobuchar model. Data from the solar maximum year 2002 and October 2003 have been investigated to display results when the ionospheric delays are large and variable. The study focuses on Europe and results are produced for the chosen test site, VILL (Villafranca, Spain). The effects of excluding all of the GPS satellites below various elevation masks, ranging from 5° to 40°, on timing solutions for fixed (static) and mobile (moving) situations are presented. The greatest timing accuracies when using the fixed GPS receiver technique are obtained by using a 40° mask, rather than a 5° mask. The mobile GPS timing solutions are most accurate when satellites at lower elevations continue to be included: using a mask between 10° and 20°. MIDAS offers the most accurate and least variable single-frequency timing solution and accuracies to within 10 ns are achieved for fixed GPS receiver situations. Future improvements are anticipated by combining both GPS and Galileo data towards computing a timing solution.     

Perspectives on the Comet-Asteroid-Meteorite Link

We discuss the possibility that CI and CM carbonaceous chondrites are fragments of extinct cometary nuclei. Theoretical and observational work suggests that comets evolve into asteroids, and several extinct cometary nuclei are now suspected to be among the near Earth object population. This population is the most likely source of meteorites and consequently, we may expect that some meteorites are from extinct comets in this population. The mineralogy and chemistry of CI and CM chondrites is consistent with the view that they originate from asteroidal objects of carbonaceous spectral classes, and these objects in turn may have a cometary origin. We do not suggest that CI or CM chondrites are directly delivered by active comets during perihelion passage or that these chondrites come from cometary debris in meteor streams. Instead, we summarize arguments suggesting that CI and CM chondrites represent fragments of cometary nuclei which evolved into near Earth asteroids after losing their volatiles. This revised version was published online in June 2006 with corrections to the Cover Date.