FIGARO: An experiment for pulsar and variable source studies in the MeV range

We present a large area, balloon borne, NaI(Tl) detector for low-energy gamma rays with temporal signature : FIGARO.The main detector is a mosaic of 12 NaI(Tl) tiles 22.5 × 15 × 5 cm, for a total geometric area of 4050 cm².In the energy band 140 keV - 6 MeV, the expected background counting rate at float altitude is in the range of two to three thousands counts per second.For pulsar analysis the expected 3δ sensitivity for 5 hours exposition time is 2.5 10^?4 ph/cm².s.MeV (150–500 keV) 1.5 10^?4 ph/cm².s.MeV (1–6 MeV). This performance, together with the large effective area and the relatively short duration of a balloon flight, make FIGARO particularly suitable for the identification of sources by means of temporal analysis.For objectives in the Northern sky, including the Crab pulsar, a transmediterranean flight is planned for the summer of 1982 ; a Southern mission is scheduled in Brazil for the fall of 1983 (Vela, PSR 1822-09).     

Marangoni heat pipe: An experiment on board MIOsat Italian microsatellite

This article summarizes the activities in preparation of a microgravity experiment to be carried out by using a small technological payload onboard a microsatellite developed by the Italian Space Agency. A dedicated hardware will be developed to investigate innovative heat pipes filled with self-rewetting fluids, i.e. dilute aqueous alcoholic solutions with unique surface tension properties. After a general introduction of the scientific background, the paper is focused on the main activities in preparation of the flight experiment, on the design of the flight hardware and on the experimental planned procedure. The laboratory results achieved on ground in preparation of a flight experiment are also presented, including measurements of fluids physical properties and preliminary heat pipes performances characterization test. From the engineering point of view, the activities dealing with heat pipes filling and sealing are included. The activities for heat pipe characterization conclude the paper.     

The fluid-dynamic disturbances induced on the ISS, based on the first acceleration measurements on board the space station

The different acceleration components on the ISS that are responsible for the generation of convective motions in a fluid cell either in the presence of density gradients or in quasi-isodense processes, are analyzed. The NASA measurements of the quasi-steady and periodic acceleration on the ISS are considered and their effects on fluid-dynamic experiments are computed and discussed under different assumptions. In particular, numerical simulations are carried out to identify the relative importance of linear and pendular accelerations, due to possible rotations of the P/L around its center of mass. The effects caused by variable accelerations created by an isolation mount that exhibits an attenuation factor not constant within the payload volume, caused by the reaction forces of the umbilicals, are computed and analyzed.     

Photochemical synthesis of citric acid cycle intermediates based on titanium dioxide

The emergence of the citric acid cycle is one of the most remarkable occurrences with regard to understanding the origin and evolution of metabolic pathways. Although the chemical steps of the cycle are preserved intact throughout nature, diverse organisms make wide use of its chemistry, and in some cases organisms use only a selected portion of the cycle. However, the origins of this cycle would have arisen in the more primitive anaerobic organism or even back in the proto-metabolism, which likely arose spontaneously under favorable prebiotic chemical conditions. In this context, we report that UV irradiation of formamide in the presence of titanium dioxide afforded 6 of the 11 carboxylic acid intermediates of the reductive version of the citric acid cycle. Since this cycle is the central metabolic pathway of contemporary biology, this report highlights the role of photochemical processes in the origin of the metabolic apparatus.     

Origin of informational polymers and the search for non-terran life: protection of the polymeric state of DNA by phosphate minerals

An in-depth analysis of the effects exerted on the DNA backbone by 25 crystal phosphate minerals is reported. Degradation of DNA oligomers was performed with two different reactions: Hydrolysis following Nucleophilic Degradation (HND), initiated by the nucleophilic addition of formamide on both purine and pyrimidine nucleobases, and Hydrolysis following Nucleophilic Substitution (HNS) carried on by water and starting with the removal of a nondegraded base. A complete panel of effects on the phosphoester bonds, from protection to enhanced instability to absence of interference, is described. These effects differ in the different degradation pathways and in different physical-chemical conditions. The relationship between the hardness of the mineral and its protective ability is discussed. In addition to its interest per se, this study was prompted by the observed catalytic abilities of soluble and mineral phosphates (Saladino et al., 2006c) on the synthetic reactions by formamide. The relevance of these observations in the search for nonterran life is discussed.     

Oscillatory Thermocapillary Flows in Simulated Floating-zones with Time-dependent Temperature Boundary Conditions

This study deals with numerical simulations of the Maxus sounding rocket experiment on oscillatory Marangoni convection in liquid bridges. The problem is investigated through direct numerical solution of the non-linear, time-dependent, three-dimensional Navier–Stokes equations. In particular, a liquid bridge of silicon oil 2[cs] with a length L=20 [mm] and a diameter D=20 (mm) is considered. A temperature difference ΔT=30 [K] is imposed between the supporting disks, by heating the top disk and cooling the bottom one with different rates of ramping. The results show that the oscillatory flow starts as an ‘axially running wave', but after a transient time the instability is described by the dynamic model of a ‘standing wave', with an azimuthal spatial distribution corresponding to m=1 (where m is the critical wave number). After the transition, the disturbances become larger and the azimuthal velocity plays a more important role and the oscillatory field is characterized by a travelling wave. The characteristic times for the onset of the different flow regimes are computed for different rates of ramping.     

Surface tension driven-flow in non-coalescing liquid drops

A fluid-dynamic model of two non-coalescing liquid drops of the same liquid, pressed against one another in the presence of thermocapillary convection, is proposed to correlate experimental results on the deformation of the drop surfaces, on the pressure distribution and on the thickness of the air film between the drops. The two-point boundary value problem for the Gauss-Laplace hydrostatic equation, subjected to the constant volume constraint, is solved by a shooting method to evaluate the shapes of the drops for different values of the applied pressure jump across the surface exposed to a constant pressure ambient. The flow fields in the liquid drops and in the air layer are obtained by numerical solutions of the dynamic problem. The numerical results which qualitatively agree with the experimental ones, explain why an air film could be created between the two drops and show that film thicknesses of some microns exist with excess pressures of the same order of magnitude of the pressure needed to deform the drops.     

New methods for microbial contamination monitoring: an experiment on board the MIR orbital station

Experiment T2, carried out during the Euromir'95 mission, was an important step toward innovative methods for spacecraft microbial contamination monitoring. A new standard sampling technique permitted samples to be analysed by different means. On board, two analysis methods were tested in parallel: Bioluminescence and Miniculture. In turn, downloaded samples are being analysed by polymerase chain reaction (PCR), a powerful and promising method for the rapid detection, identification and quantification of pathogens and biofouling agents in closed manned habitats.     

Oscillatory thermocapillary flows in simulated floating-zones with time-dependent temperature boundary conditions

This study deals with numerical simulations of the Maxus sounding rocket experiment on oscillatory Marangoni convection in liquid bridges. The problem is investigated through direct numerical solution of the non-linear, time-dependent, three-dimensional Navier-Stokes equations. In particular, a liquid bridge of silicon oil 2[cs] with a length L = 20 [mm] and a diameter D = 20 (mm) is considered. A temperature difference ΔT = 30 [K] is imposed between the supporting disks, by heating the top disk and cooling the bottom one with different rates of ramping. The results show that the oscillatory flow starts as an ‘axially running wave’, but after a transient time the instability is described by the dynamic model of a ‘standing wave’, with an azimuthal spatial distribution corresponding to m = 1 (where m is the critical wave number). After the transition, the disturbances become larger and the azimuthal velocity plays a more important role and the oscillatory field is characterized by a travelling wave. The characteristic times for the onset of the different flow regimes are computed for different rates of ramping.