A new modeling method of solar energetic proton events for ISO specification

Solar energetic protons degrade performance and reliability of spacecraft systems due to single-event effects, total dose effects and displacement damage in electronics components including solar cells. On designing a solar cell panel, a total fluence of solar energetic protons (SEPs) which cause solar cell damage is needed to estimate power loss of the solar cells over mission life. Nowadays a solar panel area of spacecraft is increasing as spacecraft mission life becomes longer (15–18 years). Thus an accurate SEP model is strongly required for the cost-minimum design from the aerospace industry. The SEP model, JPL-91 proposed by Feynman et al., is currently used widely for solar cell designing. However, it is known that the JPL-91 model predicts higher fluences of protons than values actually experienced in space, especially after 7 years on orbit. In addition, the model is based on several assumptions, and also needs Monte-Carlo simulations for calculating fluences. In this study, we propose a new method for modeling SEPs especially focused on solar cell degradation. The newly-proposed method is empirical, which constructs a model based directly upon proton flux measurement data taken by instruments onboard spacecraft. This method has neither assumptions nor dependence on SEP event selection, both of which are needed in JPL-91. The model fluences derived from this method show lower fluences in longer missions compared to JPL-91. This method has been proposed to ISO (International Organization for Standardization) and has been discussed for a new standard SEP model.     

Research and development of On-Board Processor for advanced mobile satellite communications

This paper describes the research and development of an On-Board Processor (OBP) for a mobile satellite communications system using a geostationaly satellite. The system, which based on Multi-Carrier Time Division Multiple Access, can realize high performance and facilitate the use of miniature hand-held mobile Earth terminals.

Our research and development results indicate as follows.

1. 1) The simultaneous-slot switching method will be the most suitable for an on-board base-band switching with consideration of traffic capacity, time delay, and hardware scale.

2. 2) The OBP performs channel exchange with regeneration that contributes to a reduction in the size of mobile terminals because of the coding gain.

3. 3) Many kinds of Application Specific Integrated Circuits are designed to realize large channel capacity and reduce the size and power consumption of the OBP. These OBP design can increase the channel capacity, which is equivalent to in 5.6kbps voice channel, up to over 500 channels within 5MHz frequency band

Some results are applied to the OBP being developed for the Japanese Engineering Test Satellite VII (ETS-VB).     

A noise attenuation method for medium-energy electron measurements in the radiation belt

From the viewpoint of plasma particle measurements in the radiation belt, background noise is a serious problem. High-energy particles penetrating the sensor shielding generate spurious signals, and their count rate often can be comparable to the true signals. In order to attenuate such background noise during medium-energy (5–83 keV) electron measurements, we propose the double energy analyses (DEA) method. DEA is conducted by a combination of an electrostatic analyser (ESA) and avalanche photo-diodes (APDs); ESA and APD independently determine the energy of each incoming particle. By using the DEA method, therefore, the penetrating particles can be rejected when the two energy determinations are inconsistent; spurious noise are caused only when the deposited energy at an APD is by chance consistent with the measured energy by ESA. We formulate the noise count rate and show the advantage of DEA method quantitatively.