Millimeter wave radar with clutter measurements

A portable millimeter wave test radar system, also suitable for battery operation, gives interesting possibilities for clutter recordings at hard-to-reach sites. The designed system covers all common radar frequencies from the Ka- to V-bands and enables spatial detection of targets or clutter elements within an adjustable time gate, whereby spatial clutter profiles of rain can be analyzed. The construction allows full operation with non-scanning antennas as well. This is advantageous when measuring temporal RCS variations of selected targets or surface clutter from snow dunes.     

A baseband Doppler simulator for radar system development

Elementary electronics building blocks can be configured as a low-cost baseband Doppler simulator for developing the post-detector processing parts such as MTIs and MTDS of millimeter wave pulsed radars employing amplitude and phase channels. The challenge of narrow pulses in conjunction to low Doppler frequencies is handled here by CMOS switches and normal function generator ICs. Test noise is generated with an off-the-shelf radio RF/IF circuit. Wideband video amplifiers are not required. Typical performance figures include pulse widths from 50 ns, target ranges from 0 to ambiguity maximum, target velocities from 0.5 m/s to 500 m/s and PRFs up to 100 kflz. Virtual target RCS can be adjusted as needed in a straightforward way.     

Sensor systems signal processing platform

A field programmable gate array-based computing platform for high-speed sensors such as short-range radars is presented. The circuit performs necessary A/D conversions, raw data stream compression and target detection, and constructs a message structure suitable for external displays. In the prototype, USB is the connecting path to a laptop computer. An elementary pulse radar is utilized as an application example. An application interest would be in collision avoidance systems. Observed data transfer rates with real radar input signals were 36 Mbytes/s when typical target detection algorithms were applied.     

A hardware signal processing platform for sensor systems

A field programmable gate array-based computing platform for high-speed sensors such as short-range radars is presented. The circuit performs necessary A/D conversions, raw data stream compression and target detection, and constructs a message structure suitable for external displays. In the prototype, USB is the connecting path to a laptop computer. An elementary pulse radar is utilized as an application example. An application interest would be in collision avoidance systems. Observed data transfer rates with real radar input signals were 36 Mbytes/s when typical target detection algorithms were applied.     

Target detection trials with a millimeter wave radar system

Unobstructed, large RCS targets, similar radar targets surrounded by moving foliage, and small targets in severe clutter have been used as test cases for two pre-processing algorithms and several threshold levels in an experimental millimeter wave radar system. The rather conventional "six-out-of-eight" pulse radar selection method with binary output has been compared to an algorithm that accepts a target if the pre-defined trigger level is crossed by the average of the eight consecutive pulses. In this case, however, the output is an analog value corresponding to the relative average video amplitude. In terms of plotted video, this process seems to give a slightly better combination of false alarm rate and detection probability. Large targets are easier to detect from foliage clutter with the conventional method.     

Low-cost ground-to-ground mobile telemetry link

A frequency modulated UHF telemetry link giving 5 MHz of baseband capacity with carrier to noise ratio exceeding 30 dB is described. The system is intended for ground mobile use and provides more than 1 km of coverage also in moderately obstructed terrain indicating allowable maximum path loss up to 110 dB. The mobile transmitter end uses a sturdy flexible antenna. Typical sensor signals include voltage outputs from accelerometers, strain gauges, and thermistors, but live broadcasting-quality television is also easy to implement. Digital interfacing is accomplished through suitable D/A converters, multiplexers, and coders. Both the transmitter and receiver utilize commercial-off-the-shelf building blocks in order to keep the total cost within acceptable limits.