静止轨道卫星通信链路的预算与分析

星地链路计算作为卫星通信的重要技术，是卫星通信系统设计的基础和理论依据，直接决定了卫星通信系统的链路通信质量。由于影响卫星链路的因素很多，设计中存在一处不合理即使得整条星地链路不可用，造成巨大的损失。而且在实际设计中无法做到最理想的链路状态，往往需要在某方面有所取舍，这也是链路计算中的一大难点。基于目前国际通用的链路计算方法，将星地链路上下行拆分，独立计算，综合分析，再结合实际工程经验，分析和计算实际工程案例，针对不同的链路配置给出相应合理的设计方法，可作为静止轨道通信卫星星地链路计算分析的参考。     

数字化技术在叶轮研制中的应用

本文通过分析归纳建立了一种叶轮数字化建模方法，并利用该方法成功实现了某型叶轮三维模型创建，同时也根据该数字化模型实现了模具数字化设计及其数控加工。     

Evaluation and improvement of coastal GNSS reflectometry sea level variations from existing GNSS stations in Taiwan

Global sea level rise due to an increasingly warmer climate has begun to induce hazards, adversely affecting the lives and properties of people residing in low-lying coastal regions and islands. Therefore, it is important to monitor and understand variations in coastal sea level covering offshore regions. Signal-to-noise ratio (SNR) data of Global Navigation Satellite System (GNSS) have been successfully used to robustly derive sea level heights (SLHs). In Taiwan, there are a number of continuously operating GNSS stations, not originally installed for sea level monitoring. They were established in harbors or near coastal regions for monitoring land motion. This study utilizes existing SNR data from three GNSS stations (Kaohsiung, Suao, and TaiCOAST) in Taiwan to compute SLHs with two methods, namely, Lomb–Scargle Periodogram (LSP)-only, and LSP aided with tidal harmonic analysis developed in this study. The results of both methods are compared with co-located or nearby tide gauge records. Due to the poor quality of SNR data, the worst accuracy of SLHs derived from traditional LSP-only method exceeds 1?m at the TaiCOAST station. With our procedure, the standard deviations (STDs) of difference between GNSS-derived SLHs and tide gauge records in Kaohsiung and Suao stations decreased to 10?cm and the results show excellent agreement with tide gauge derived relative sea level records, with STD of differences of 7?cm and correlation coefficient of 0.96. In addition, the absolute GNSS-R sea level trend in Kaohsiung during 2006–2011 agrees well with that derived from satellite altimetry. We conclude that the coastal GNSS stations in Taiwan have the potential of monitoring absolute coastal sea level change accurately when our proposed methodology is used.     

Global ionospheric scintillations revealed by GPS radio occultation data with FY3C satellite before midnight during the March 2015 storm

Global observations of S4 amplitude scintillation index by the GPS Occultation Sounder (GNOS) on FengYun-3 C (FY3C) satellite reveal global dynamic patterns of a strong pre-midnight scintillations in F-region of the ionosphere during the St. Patrick’s Day geomagnetic super storm of 17–19 March 2015. The observed strong scintillations mainly occurred in the low latitudes, caused by equatorial plasma bubbles. During the main storm phase (March 17), the scintillations were first triggered in the New Zealand sector near 160°E longitudes, extending beyond 40°S dip latitude. They were also enhanced in the Indian sector, but significantly suppressed in East Asia near 120°E longitude and in Africa around 30°E longitude. During the initial recovery phase (March 18–19), the global scintillations were seldom observed in GNOS data. During the later recovery phase (after March 19), the scintillations recovered to the pre-storm level in Indian, African, and American sectors, but not in East Asian and any of Pacific sectors. These results closely correlate with observations of the density depletion structures by the Communication/Navigation Outage Forecasting System (C/NOFS) satellite, and ground-based instruments. Such consistency indicates reliability of our scintillation sensing approach even in a case-by-case comparison study. The prompt penetration electric field and disturbance dynamo electric field are suggested as the main factors that control the enhancement and inhibition of the scintillations during the storm, respectively.     

An equilibrium multi-objective optimum design for non-circular clearance hole of disk with discrete variables

An Equilibrium Multi-objective Optimization Model(EMOM) with self-regulated weighting factors has been proposed for the optimum design of non-circular clearance hole on the front flange of turbine disk. In the ‘‘equilibrium design", both the stress decrease around the hole and the least hole's profile variation are considered, which balances two ambivalent design goals. Specific discrete variables are applied to realize the standardization design in the optimization process, in which a Surrogate Genetic Coding Algorithm(SGCA) is introduced, and a special check module is used to get rid of repeated fitness evaluation of the samples. The method offers an equilibrium design for the non-circular clearance hole of the turbine disk with great accuracy and efficiency.     

一种卫星信道的反馈优化接入机制

提高卫星信道资源利用率，探索高效可行的端站接入机制是卫星通信发展亟待解决的问题之一。当前卫星通信DVB-RCS标准基于带宽预先规划的接入机制与端站随遇接入的需求矛盾凸显，因此提出一套信道反馈优化接入机制，综合考虑各端站数据业务需求，在不改变原有协议信令特征的基础上，探索性地引入谦虚度激励方法，创造性地构造动态协商反馈模型并加以求解，达到提高端站接入数量、满足随遇接入需求、提升信道利用效率、最大化整体带宽通信业务效益的目的。通过试验验证，带宽分配反馈优化机制比传统模式提高近1倍接入率，最大端站数接入时算法耗时约只有0.67s，可为卫星信道使用提供技术参考。     

任务型教学法的任务设计

任务型教学法是新兴的一种强调“在做中学”(learning by doing)的语言教学方法，是我国外语课程教学改革的一个走向，吸收了以往多种教学法的优点而形成。任务是任务型教学法中一个重要概念。要使任务型教学法更好地发挥作用，任务的设计就显得尤为重要。在任务设计中，要注意任务与人本主义、任务与文化性、任务与教师角色之...     

基于等效板的含离散源损伤机翼结构分析

研究离散源损伤对机翼结构的影响,可以大幅度提高飞机在不良损伤事故下的生存能力.由于机翼内部结构复杂,很难对含离散源损伤机翼结构进行精确分析,而且精确的建模和仿真在建模与计算过程中往往也非常耗时.因此,以含离散源损伤机翼为对象,采用有限元优化设计方法,确立了一种机翼结构等效板模型的建模方法.建立的等效板模型可对含离散源损伤机翼实现快速、准确的静力学和动力学分析.     

HED-21S数控综合实验台画笔自动控制机构设计

以数控系统的PLC控制为基础,设计HED-21S机械笔控制系统结构,它可控制电磁铁的动作,执行画笔的上下运动。这支笔在X、Z型十字窗格可以绘制任意几何形状,该设计符合要求的快速定位数控直线移动,及圆弧插补功能,有助于提高数控编程效率和数控教学质量。     

基于卫星和星敏感器的冗余激光惯组在轨标定

采用高精度卫星导航速度、位置信息以及星敏感器提供的姿态信息设计十表冗余捷联惯组的标定模型,包含陀螺和加速度计的零次项和标度因数,对卫星和星敏感器辅助的冗余激光陀螺捷联惯组进行实时在轨标定.利用标准Kalman滤波和Sage-Husa自适应滤波作为估计算法,对十表冗余捷联惯组参数进行在线估计.数值仿真结果表明:参数标定精度均在7％以内,是一种实时的在轨标定方法,满足误差补偿要求.冗余惯组在轨标定方法为航天器高精度定姿和定轨提供了一种理论参考.