Physiologic and metabolic responses of wheat seedlings to elevated and super-elevated carbon dioxide

The metabolic consequence of suboptimal (400 μmol mol⁻¹ or ppm), near-optimal (1500 ppm) and supra-optimal (10,000 ppm) atmospheric carbon dioxide concentrations [CO₂] was investigated in an attempt to reveal plausible underlying mechanisms for the differential physiological and developmental responses to increasing [CO₂]. Both non-targeted and targeted metabolite profiling by GC–MS and LC–MS were employed to examine primary and secondary metabolites in wheat (Triticum aestivum, cv Yocoro rojo) continuously exposed to these [CO₂] levels for 14, 21 and 28 days. Metabolite profile was altered by both [CO₂] and physiological age. In general, plants grown under high [CO₂] exhibited a metabolite profile characteristic of older plants under ambient CO₂. Elevated [CO₂] resulted in higher levels of phosphorylated sugar intermediates, though no clear trend in the content of reducing sugars was observed. Transient starch content was enhanced by increasing [CO₂] to a much greater extent at 10,000 ppm CO₂ than at 1500 ppm CO₂. The percentage increase of starch content resulting from CO₂ enrichment declined as plants develope. In contrast, elevated [CO₂] promoted the accumulation of secondary metabolites (flavonoids) progressively to a greater extent as plants became mature. Elevated [CO₂] to 1500 ppm induced a higher initial growth rate, while super-elevated [CO₂] appeared to negate such initial growth promotion. However, after 4 weeks, there was no difference in vegetative growth between 1500 and 10,000 ppm CO₂-grown plants, both elevated CO₂ levels resulted in an overall 25% increase in biomass over the control plants. More interestingly, elevated atmospheric [CO₂] reduced evapotranspiration rate (ET), but further increase to the supra-optimal level resulted in increased ET (a reversed trend), i.e. ET at 1500 ppm < ET at 10,000 ppm < ET at 400 ppm. The differential effect of elevated and super-elevated CO₂ on plants was further reflected in the nitrogen dynamics. These results provide the potential metabolic basis for the differential productivity and stomatal function of plants grown under elevated and super-elevated CO₂ levels.     

Love Waves in Layered Graded Composite Structures with Imperfectly Bonded Interface

Theoretical analysis and numerical calculations of Love wave propagation in layered graded composites with imperfectly bonded interface are described in this paper. On the basis of WKB method, the approximate analytic solutions for Love waves are obtained. By the interface shear spring model, the dispersion relations for Love waves in layered graded composite structures with rigid, slip, and imperfectly bonded interfaces are given, and the effects of the interface conditions on the phase velocities of Love waves in SiC/Al lay- ered graded composites are discussed. Numerical analysis shows that the phase velocity decreases when the defined flexibility parameter is greater. For the general imperfectly bonded interface, the phase velocity changes in the range of the velocities for the rigid and slip interface conditions.     

基于多步裁定法评估编队超视距空战效能

提出了评估编队歼击机超视距空战效能的多步裁定法。用损失交换比和剩余飞机数量作为效能指标,将最优火力分配与空空反导弹引入到多步裁定模型中。考虑了电子对抗与飞机生存力,计算了歼击机领先发射概率、空空导弹击毁概率和发射次数。算例表明,领先发射一方超视距空战效能通常较高,滞后发射一方若采用最优火力分配、空空反导弹、电子对抗及提高飞机生存力等措施也可提高超视距空战效能。此模型计算简便,合理有效。     

轻型通用飞机起飞总重估算方法研究

飞机的起飞总重是飞机的重要设计参数,概念设计阶段首先要做的重要工作之一就是确定飞机的起飞总重。以四人座低速活塞螺旋桨飞机为例,采用任务剖面法和商载航程法分别对起飞总重进行了估算,并对两种方法进行了修正,在此基础上,取两个计算结果的平均值作为最终的起飞总重估算值。通过与对比机型的比较,验证修正后的计算方法和结果是准确合理的,为通用飞机起飞总重的确定和选择提供了参考。     

电极面型对横向激励高气压CO2激光器放电的影响

计算并讨论了均匀场电极中电极板安装结构、电极板厚度对实际电场分布影响。计算表明在基本参数类似的条件下,近罗可夫斯基电极表面电场强度具有17%的非均匀性,但在垂直放电方向的对称面上却有更好的均匀性。对放电区辉光的时间积分照片和像增强型CCD相机记录的瞬态照片进行了分析,结果表明:电极表面的电场强度分布,仅对放电的初始发展具有影响,而放电区中央的电场分布以及预电离强度,对最终放电区的均匀性具有决定性的影响。     

某型机VHF电台通讯距离短问题的解决

提出了某型机VHF电台通讯距离短的问题,简述了对某型机VHF电台进行地面试验、空中作用距离试飞情况。并用通讯原理,对VHF电台通讯距离短进行了理论分析,采取了整改措施。最终解决了某型飞机VHF电台通讯距离短的问题,使飞行通讯联络正常。     

Propagation of interplanetary shocks into the Earth’s magnetosphere

This paper is devoted to the study of propagation of disturbances caused by interplanetary shocks (IPS) through the Earth’s magnetosphere. Using simultaneous observations of various fast forward shocks by different satellites in the solar wind, magnetosheath and magnetosphere from 1995 till 2002, we traced the interplanetary shocks into the Earth’s magnetosphere, we calculated the velocity of their propagation into the Earth’s magnetosphere and analyzed fronts of the disturbances. From the onset of disturbances at different satellites in the magnetosphere we obtained speed values ranging from 500 to 1300 km/s in the direction along the IP shock normal, that is in a general agreement with results of previous numerical MHD simulations. The paper discusses in detail a sequence of two events on November 9th, 2002. For the two cases we estimated the propagation speed of the IP shock caused disturbance between the dayside and nightside magnetosphere to be 590 km/s and 714–741 km/s, respectively. We partially attributed this increase to higher Alfven speed in the outer magnetosphere due to the compression of the magnetosphere as a consequence of the first event, and partially to the faster and stronger driving interplanetary shock. High-time resolution GOES magnetic field data revealed a complex structure of the compressional wave fronts at the dayside geosynchronous orbit during these events, with initial very steep parts (10 s). We discuss a few possible mechanisms of such steep front formation in the paper.     

变目标方位角导引法

研究一种用于近程弹道式地－地弹的导引法，它是借用空－空弹常值目标方位角导引法的概念，把它改变成按弹道设计需要而变化的目标方位角导引法，去攻击地面固定目标，它有减小气动阻力，提高命中相对精度的优点，称它为变目标方位角导引法。     

UML在软件可靠性测试数据自动生成中的运用

为了自动生成实时嵌入式软件的可靠性测试数据,利用UML(统一建模语言)提供的建模机 制,从软件可靠性测试的角度建立use-case剖面、接口模型和测试数据实现模型,然后根 据 这些模型的描述进行随机抽样,自动生成可靠性测试数据.利用该方法能够开发出相应的测 试数据自动生成工具,在软件可靠性测试领域有着较大的实用价值.     

微小卫星临近操作仅测距初始相对定轨解析方法

针对仅有相对距离测量信息的近圆轨道航天器近程交会问题,首次提出一种基于传感器偏离航天器质心安装杆臂效应的解析初始相对定轨算法,解决了仅测距定轨存在镜像解的模糊性问题。首先给出了仅测距定轨模糊性的数学解释,然后基于Clohessy-Wiltshire动力学模型和传感器偏心安装的杆臂效应推导了仅测距信息情况下的初始相对轨道解析解,并给出系统能够去模糊的传感器安装条件。最后通过无误差仿真验证了所提算法的有效性,通过误差情况下的Monte Carlo仿真分析了算法的定轨性能。仿真结果表明所提算法有效,在满足传感器偏心安装条件下能够实现较为精确的初始相对定轨。