一种跟随式大磁矩磁力矩器高反电势抑制技术

摘要： 提出一种可以实现大磁矩磁力矩器磁棒电流续流时间自动调节的控制方法,该方法既可以抑制大磁矩磁力矩器高反电势的产生,又无需增加功率器件为磁棒电流提供续流回路,大幅减小控制线路的体积及热设计难度,同时可以满足输出磁矩在小幅值内频繁变换方向的使用要求.     

基于递推更新卡尔曼滤波的磁偶极子目标跟踪

针对磁性目标跟踪问题,以磁偶极子等效场源模型为基础,建立磁性目标跟踪的离散状态空间模型,将磁偶极子目标实时跟踪问题转化为状态空间模型的滤波估值问题。针对磁性目标初始条件难以获得且现有卡尔曼类滤波算法在大初始误差条件下容易出现发散的问题,提出一种递推观测更新的卡尔曼滤波算法,将现有的一步观测更新描述为递推更新过程,等效降低大初始误差带来的大非线性误差。仿真与实测数据测试结果表明,本文算法具有良好的精度和收敛性,能够有效抑制磁偶极子跟踪中由于大初始误差导致的滤波发散,适于实际应用。     

多导线对称分布原子磁分束器和干涉仪设计分析

提出了采用多根对称分布载流导线构成原子分束器的方法,包括三导线和四导线磁导引。阐述了原子分束器的分束机制,用Ansoft Maxwell 2D软件计算给出了部分载流导线移动到不同位置时的磁场分布图。通过分析了导引中心的变化,发现只要通过改变载流导线之间的相对位置就可以来实现从单路到双路导引和三路导引的转换。由此分别设计由3根对称分布载流导线构成的原子双路分束器和4根对称分布载流导线构成三路分束器,然后运用Monte Carlo方法模拟验证其原子分束功能。最后以三线对称分布分束器为基础构成Mach-Zehnder原子磁干涉仪。     

一种磁悬浮陀螺飞轮方案设计与关键技术分析

提出一种磁悬浮陀螺飞轮的设计方案,采用洛伦兹力磁轴承对陀螺飞轮转子进行五自由度支承以提供转动自由度,并利用洛伦兹力磁轴承磁力与电流的线性特性,间接测量陀螺仪的输入角速度.该装置作为姿态控制执行机构兼有敏感器功能,可同时进行三自由度姿态控制与两自由度姿态敏感.针对磁悬浮陀螺飞轮二自由度姿态敏感与三自由度姿态控制这两项关键...     

激光陀螺磁特性研究

本文分析了激光陀螺磁敏感原理,研究了腔内激光束椭偏度的产生机理,设计了高消光比激光束椭偏度测量系统。实验结果表明,激光陀螺磁灵敏度大小与磁场方向有关,输出激光束的椭偏度越大,磁灵敏度越大。研究表明,通过减小输出激光束的椭偏度,可减小激光陀螺磁灵敏度,从而增强激光陀螺环境适应性,提高激光陀螺的成品率。     

Driving major solar flares and eruptions: A review

This review focuses on the processes that energize and trigger M- and X-class solar flares and associated flux-rope destabilizations. Numerical modeling of specific solar regions is hampered by uncertain coronal-field reconstructions and by poorly understood magnetic reconnection; these limitations result in uncertain estimates of field topology, energy, and helicity. The primary advances in understanding field destabilizations therefore come from the combination of generic numerical experiments with interpretation of sets of observations. These suggest a critical role for the emergence of twisted flux ropes into pre-existing strong field for many, if not all, of the active regions that produce M- or X-class flares. The flux and internal twist of the emerging ropes appear to play as important a role in determining whether an eruption will develop predominantly as flare, confined eruption, or CME, as do the properties of the embedding field. Based on reviewed literature, I outline a scenario for major flares and eruptions that combines flux-rope emergence, mass draining, near-surface reconnection, and the interaction with the surrounding field. Whether deterministic forecasting is in principle possible remains to be seen: to date no reliable such forecasts can be made. Large-sample studies based on long-duration, comprehensive observations of active regions from their emergence through their flaring phase are needed to help us better understand these complex phenomena.     

磁响应Fe3O4/HCS复合微球的制备及特性

由壳聚糖与环氧丙烷制备了羟丙基壳聚糖(HCS)。将其配制成水溶液,利用离子凝胶法,与多聚磷酸钠(TPP)反应,制备了粒径在0.6μm羟丙基壳聚糖微球。再用滴定水解法制备了四氧化三铁微粒,激光粒度分析显示滴定水解法制备的Fe3O4粒径分布较窄,粒径小。在此基础上采用交联聚合法制备了Fe3O4/HCS复合微球,微球为实心,四氧化三铁微粒被包裹于微球内部,形状规则,粒径约为0.8μm,经过磁响应分析表明Fe3O4/HCS复合微球具有磁响应性。     

温度对磁屏蔽霍尔推力器磁场构型的影响研究

霍尔推力器磁路设计主要通过常温静态磁场仿真得到，并实测推力器非工作状态常温磁场进行复核。大功率霍尔推力器将面临更为严峻的热问题，推力器工作时磁路系统受高温影响，因此在常温下仿真得到的磁场位形会因温度升高而产生偏移，不能反映推力器真实工作时的磁场情况。为研究霍尔推力器工作时热量对磁路系统的影响，通过热磁耦合仿真对10kW磁屏蔽霍尔推力器的热态磁场分布进行研究，并对热态、常温仿真结果进行了对比，发现在阳极附近的径向磁感应强度Br的差异比放电室出口更大。常温设计的磁屏蔽构型在热态时偏离磁屏蔽，磁场和壁面最大不符合度达到13%，通过陶瓷出口型面修正后重新获得磁屏蔽效果，使最大不符合度降低到4.8%以下。合理热设计有助于降低热载荷，热仿真得到磁路系统最高温度低于500℃，低于0.78倍的居里温度Tc磁性急剧转变点，不会出现磁性能急剧下降，但热量对磁屏蔽霍尔推力器磁场构型的影响是应该考虑的。     

车载中频高速同步发电机设计

对车载中频高速同步发电机设计思路和设计特点进行阐述。根据设计思路和设计特点制造了试验样机,在制造过程中着重对磁极线圈的绑扎与固定、三相旋转整流器的内部结构做了改进。进行了电机性能的试验分析,对采取的技术措施进行验证,验证了设计方法的有效性。这为同类电机设计提供了参考。     

Detailed magnetic structure and stochastic threshold

Non-linear evolution of reconnection is too slow to explain-by itself-fast phenomena such as internal disruptions in tokamaks or flares in the solar atmosphere. It has been proposed that the change in topology could lead to field line stochastization, and hence to highly increased transport. An important objection to this idea is that the increase of transport coefficients should smoothly follow the amplitude of the perturbation, while the observations show a catastrophic transition. We have shown 1) that the shape of the structures (and not only their size or amplitude) evolve during non-linear evolution 2) that the stochastic threshold can be strongly influenced by the detailed shape. Therefore, sharp transitions can appear during the evolution, due to the combination of these two effects. We will first consider an idealized situation, namely the two-waves problem in slab geometry, for which we will study the effect of the separatrix shape on the stochastic threshold. In the second part, we will present an application to the internal disruption in tokamaks, with anm=1 perturbation in a toroidal magnetic configuration. In the last part, we will discuss possible applications of the studies on shape effects to the behaviour of trapped particles in structures of the solar atmosphere.