面向非结构混合网格高精度阻力预测的梯度求解方法

针对非结构混合网格的特点,通过改进传统的Green-Gauss梯度求解方法,提出了一种可提高非结构混合网格黏性计算精度的节点型Green-Gauss梯度求解方法。利用改进后的方法,完成了DLR-F4翼身组合体算例的计算和对比分析。改进后的梯度求解方法残差收敛更好,下降量级更多,阻力系数和试验吻合更好,激波区域压力分布和分离区域流场细节的模拟更精确,说明改进后的梯度求解方法有效提高了程序的鲁棒性和阻力预测精度,验证了方法的有效性。采用改进后的方法对第5届AIAA阻力预测研讨会的通用研究模型（CRM）进行了详细的模拟分析,结果表明：改进的梯度求解方法更加适用于非结构混合网格的黏性计算,计算精准度达到国际同类CFD软件水平,进一步验证了改进方法的可靠性。     

仿生减阻翼型的气动性能

利用一种基于滑移边界理论的仿生肋条结构的模化方法,对仿生减阻翼型的气动性能开展了数值模拟研究。结果显示:肋条结构同时布置在翼型压力面和吸力面湍流区域时,仿生减阻翼型的阻力可降低1.73%~3.07%,升阻比可提高2.10%~4.08%,其中黏性阻力的减小是总阻力下降的主要原因。对流场分析表明,仿生减阻翼型的速度曲线出现一定抬升,使得湍流边界层中的黏性子层增厚,进而导致了仿生减阻翼型气动性能的提升。      

双后掠鸭翼气动特性的数值模拟

首先针对具有中等前缘后掠角梯形鸭翼的缺点提出双后掠鸭翼概念,然后分别对安装梯形鸭翼和双后掠鸭翼的近距耦合鸭式布局的气动性能进行数值模拟研究,分析影响双后掠鸭翼气动性能的流动机理。研究表明：在大迎角时,对于双后掠鸭翼,具有较大前缘后掠角的外翼段可以使鸭翼涡在涡核破裂后仍能形成稳定集中涡并保持较高的强度,增加鸭翼本身的失速迎角,并通过诱导作用改善机翼外翼段流场,进而提高全机大迎角性能,但在小迎角时会破坏鸭翼附着流或前缘气泡涡的发展,造成略微的升力损失。拥有较大失速迎角的双后掠鸭翼在小迎角时具有较大的可用偏度,可以增强布局的抬头控制能力。双后掠鸭翼在满足隐身约束的前提下,超声速阻力较小,具有较好的超声速性能。     

亚声速翼身融合无人机概念外形参数优化

为了兼顾翼身融合（BWB）布局无人机（UAV）的气动、隐身和结构重量要求,应用优化方法研究了某亚声速翼身融合无人机概念方案的外形设计问题。外形优化设计流程包括全机参数化几何外形模型、气动分析、机翼根部弯矩计算、雷达散射截面（RCS）分析、代理模型的建立和外形参数优化计算。选择了三种不同优化目标研究翼身融合无人机外形优化问题：①未配平状态升阻比最大;②配平状态升阻比最大;③配平状态升阻比尽量大和机翼弯矩尽量小。通过优化结果的对比分析,揭示了配平约束和机翼弯矩目标对优化设计结果的影响。研究结果表明：计入配平约束能够有效提高配平升阻比;将配平状态升阻比尽量大和机翼根部弯矩尽量小作为优化目标能够获得合理的优化外形。     

Experiment of drag characteristics of a novel variable geometry flame-holder

A novel variable geometry flame-holder (VGF) based on V-gutter was presented. The structural characteristics of the flame holder were introduced. Experimental study on drag characteristics of the VGF on un-burning and burning states was conducted in a rectangular combustion test rig. The influence of the change of gutter trailing edge width w on pressure recovery in different operating conditions was analyzed emphatically. Furthermore,drag characteristics in different trailing edge width variation modes were discussed. Results show that: (1) Narrowing w can observably raise the total pressure recovery σ but the highest σ is not obtained at minimum w. (2) The relationship of drag coefficient ψ and w in the un-burning conditions can be well expressed in a form of exponential equation (w/d>0.4). (3) Drag characteristics are not sensitive to the variation modes and speeds of w . (4) In the burning condition,σ decreases with the increasing of w basically and the course can be divided into three stages. The results and experimental data presented in this paper would enhance the phenomenological understanding of this type of VGF,and would contribute to the next experimental study and numerical calculus of this novel VGF.      

DLR-F6翼身组合体数值计算

使用自行研制的混合网格亚跨超声速流场解算器程序MFlow计算了AIAA第三届阻力会议提供的DLR-F6及其带整流装置FX2B情况下的阻力。重点分析了两者的网格收敛特性、阻力极曲线以及压力分布等,并与阻力会议的各个软件的计算结果进行比较。详细分析了DLR-F6翼身结合处后缘附近网格精度对分离气泡计算的影响。计算结果表明,MFlow程序的计算精度与国外软件相近,能够为阻力计算提供比较精确的结果。     

基于阻力分解策略的翼型阻力计算方法研究

研究并应用了基于翼型阻力分解策略的中场积分计算阻力的方法。中场积分方法是近年来提出的一种新的计算阻力的方法,方法将流场分为三个不同的区域：波阻区、型阻区、数值耗散区,通过对不同区域进行积分将阻力分解为波阻、型阻、数值耗散阻力。计算结果表明中场积分方法与传统的表面积分方法和远场积分方法相比,不仅可以将阻力分解成不同部分以便于进一步分析阻力产生机理,而且在计算中对网格量的要求较低,即使在网格量较小的情况下也能得到较精确的结果。     

Drag Reduction for an Airship with Proper Arrangement of Propellers

In this article, the flow field around an airship with propellers blowing is calculated on the basis of the Reynolds-averaged Navier-Stokes equations with SST turbulent models. Modeled each as an actuator disk, the propellers are arranged at different positions around the body of airship in the flow direction. The numerical results show that the blowing propellers produce open outer flows. They drive the separated vortexes off the body thus reducing the drag coefficients. The results also show that the position after leading sucking peak is the best place for a propeller to blow. When the propellers are positioned after sucking peak, the longer the area which the propellers work on, the more the profile drag coefficients can be reduced. If the working position of propeller moves from the sucking peak forward to the leading edge, the friction drag coefficient will increase. The bigger the diameter of the propellers and the stronger the pressure jump, the more the drag coefficient will be reduced. The results also reveal that for the design of circularly-positioned propellers with space intervals, the more drag coefficient reduction results, the smaller the space interval is specified.     

近距鸭翼高度对鸭翼－前掠翼布局纵向气动特性影响的实验研究

前掠翼布局由于其潜在的优越性,在未来战斗机的研究设计中将占有日益重要的地位.本文通过风洞测力实验,研究了近距鸭翼相对于前掠主机翼的高度对布局纵向气动性能的影响.实验结果表明:随着主机翼前掠角的增大,近距鸭翼布置高度逐渐增加可获得较好的气动特性.     

基于N-S方程的悬停旋翼桨叶气动干扰数值模拟

采用基于N-S方程的CFD方法,通过计算前后平行放置的双翼和三翼的干扰流场,对悬停状态旋翼桨叶之间的气动干扰机理进行了数值探讨;在此基础上,进行了2种桨叶片数、2种桨距及2种桨尖马赫数情况的旋翼悬停流场对比计算,模拟它们对旋翼气动性能和桨叶间气动干扰作用的影响,得到一些与工程实际吻合的现象和结论。